Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 37
Search took 0.77 seconds.
Search: Posts Made By: jchance
Forum: Storage / Winterization 10-08-2014, 06:23 PM
Replies: 8
Views: 603
Posted By jchance
Where did you find the rest of the instructions?

Where did you find the rest of the instructions?
Forum: Engine / Drive Train 09-10-2014, 12:27 PM
Replies: 5
Views: 259
Posted By jchance
Manual states do not screw in.

Manual states do not screw in.
Forum: Ballast 07-03-2014, 03:14 PM
Replies: 1
Views: 302
Posted By jchance
Length of 1/2" PVC pipe to hold it open...

Length of 1/2" PVC pipe to hold it open longwise
Forum: Audio/Stereo 06-11-2014, 10:42 AM
Replies: 1
Views: 225
Posted By jchance
Need cooler running amp suggestions

2001 Maristar with 4 JL speakers and sub in the boat and 4 Kicker cans on the tower. They are currently powered by 2 of the original Clarion amps. Sounds good but 1 amp clips frequently; not to...
Forum: General Discussion 06-10-2014, 11:45 AM
Replies: 2
Views: 200
Posted By jchance
Help with getting floor up to remove gas tank to replace steering cable

I need to replace my cable in my 2001 Maristar v210. It is a V-drive. We can get the cable loose at both ends but it appears to be stuck under the gas tank. We can get all of the floor access panels...
Forum: General / Other 06-10-2014, 11:43 AM
Replies: 0
Views: 141
Posted By jchance
Help with steering cable/floor removal issue

I need to replace my cable in my 2001 Maristar v210. It is a V-drive. We can get the cable loose at both ends but it appears to be stuck under the gas tank. We can get all of the floor access...
Forum: Upholstery 12-02-2013, 12:01 PM
Replies: 7
Views: 1,498
Posted By jchance
Just for those who still are having the problem,...

Just for those who still are having the problem, stainless steel through bolting works better than trying to replace the inserts.
Forum: Trailers 05-02-2013, 11:35 AM
Replies: 47
Views: 3,283
Posted By jchance
OK, I spoke with several dealers in the area and...

OK, I spoke with several dealers in the area and got quotes from $85 to $130 per tire plus mount/balance.

I then spoke with a good friend who owns a large tire dealership and also is a...
Forum: Engine / Drive Train 04-23-2013, 11:28 AM
Replies: 7
Views: 1,052
Posted By jchance
I'vebeen under there and have had everything...

I'vebeen under there and have had everything loose. We tried to tighten the nut to see if we could get the steady stream back to a few drops but it is just too old and needs to be replaced at this...
Forum: Engine / Drive Train 04-22-2013, 11:44 PM
Replies: 7
Views: 1,052
Posted By jchance
V-drive help! Which is the better way to do it?

It's time to replace my shaft seal as it is dripping entirely too much. I have a 2001 Maristar 210 with a V-drive. We have ordered the Gortex seal from SkiDim and are looking at the ways to proceed...
Forum: Trailers 04-21-2013, 11:43 PM
Replies: 47
Views: 3,283
Posted By jchance
Exactly my question

My boat stays on a trolley indoors most of the time and the trailer sits in a shady spot in the woods next to my lakehouse. I am looking for something that will last over time with minimal dryrot,...
Forum: Trailers 04-21-2013, 11:10 PM
Replies: 47
Views: 3,283
Posted By jchance
Tires

Time for a new set. Opinions on who makes the best trailer tire for the price?
Forum: Storage / Winterization 05-19-2012, 11:04 PM
Replies: 4
Views: 568
Posted By jchance
New cover

Have a 2001 Maristar V-210 with a Zero-flex tower. The cover which came with the boat finally bit the dust. Any suggestions for a good replacement?
Forum: Towers 05-10-2012, 10:42 AM
Replies: 19
Views: 3,545
Posted By jchance
Your pads should be the same as the zero flex on...

Your pads should be the same as the zero flex on my Maristar 210. Try them!
Forum: Ballast 04-10-2012, 12:02 PM
Replies: 17
Views: 1,625
Posted By jchance
Planning on keeping the tanks and just converting...

Planning on keeping the tanks and just converting over to something that fills.empties more reliably.
Forum: Ballast 04-07-2012, 03:02 PM
Replies: 17
Views: 1,625
Posted By jchance
Wakemakers.com

Anyone know what is going on with them or how reliable they are. The reason I ask is I have contacted them twice about upgrading the ballast system on my 2001 Maristar V210. It has the factory...
Forum: General Discussion 08-11-2011, 02:33 PM
Replies: 12
Views: 1,275
Posted By jchance
Same here. Use SS washers, spacers,etc and it...

Same here. Use SS washers, spacers,etc and it looks good and is MUCH sturdier!!
Forum: Storage / Winterization 10-12-2010, 10:10 AM
Replies: 9
Views: 1,696
Posted By jchance
I turn on both the heater and shower while...

I turn on both the heater and shower while running antifreeze through the engine. That allows the antifreeze to circulate through the heater core (just like a car) and spray out of the shower head. ...
Forum: Appearance 07-20-2010, 12:58 PM
Replies: 4
Views: 516
Posted By jchance
Do you have any photos? Did it pull through the...

Do you have any photos? Did it pull through the side of the boat or out of the trim panel? On mine, the bolts or studs turned loose from the panel and were just left through the hole in the side of...
Forum: General Discussion 07-01-2010, 04:06 PM
Replies: 3
Views: 457
Posted By jchance
Refurbing the ballast system

I have a 2001 Maristar V210 with tower and factory installed ballasts. The cables to control the inlet valves are located in the rear hatch and are somewhat of a PITA to access. I was wondering if...
Forum: Appearance 06-22-2010, 10:43 AM
Replies: 4
Views: 516
Posted By jchance
The boat is on lift 120 miles from here so no...

The boat is on lift 120 miles from here so no pictures currently. The side panel ih held on by 5 to 6 screws/bolts along the top of the panel, thru bolted into the fiberglass side of the boat. At...
Forum: Appearance 06-21-2010, 02:58 PM
Replies: 4
Views: 516
Posted By jchance
Driver starboard panel

I found my driver side panel (the one with the throttle and ballast switches) had broken loose this weekend. I have not pulled the panel, but it looks like one of the rear screws/bolts broke out of...
Forum: Upholstery 06-21-2010, 02:56 PM
Replies: 2
Views: 595
Posted By jchance
Driver seat repair

I have a 2001 Maristar with a captain's chair mounted on a Garelok Millenuim plate (the OEM original). The seat is made of HDPE and 3 of the inserts for the mounting screws have snapped in half. It...
Forum: General Discussion 06-21-2010, 02:56 PM
Replies: 2
Views: 451
Posted By jchance
Driver seat loose

I have a 2001 Maristar with a captain's chair mounted on a Garelok Millenuim plate (the OEM original). The seat is made of HDPE and 3 of the inserts for the mounting screws have snapped in half. It...
Forum: General Discussion 06-07-2010, 11:42 AM
Replies: 2
Views: 761
Posted By jchance
Ballast systems issues in 2001 V-drive

I have a 2001 Maristar V-drive with the front and rear ballast system. The water valves are located under the engine are controlled by hand knobs inside the starboard side rear hatch. They are...
Showing results 1 to 25 of 37

 

All times are GMT -4. The time now is 04:42 AM.