Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 27
Search took 0.01 seconds.
Search: Posts Made By: david_ski
Forum: Off Topic Discussion 08-24-2015, 01:27 AM
Replies: 6,547
Views: 988,866
Posted By david_ski
I have seen a family of 4 multiple times on...

I have seen a family of 4 multiple times on scooters in China and Taiwan. Dad driving with child in the middle with the mom in the back on the seat. Second small child is on floor board between dads...
Forum: Off Topic Discussion 07-15-2015, 07:01 PM
Replies: 6,547
Views: 988,866
Posted By david_ski
I have seen the same thing in Singapore. A...

I have seen the same thing in Singapore. A couple of excavators with hammer bits can take down a building like that in less than a week. It was amazing to watch from above and see the daily...
Forum: Off Topic Discussion 07-14-2015, 11:06 PM
Replies: 6,547
Views: 988,866
Posted By david_ski
years ago when I would put in at the river,...

years ago when I would put in at the river, sometimes there was silt on the ramp that caused slippage. Same end effect, objects in motion tend to stay in motion. What had saved me was that once the...
Forum: Off Topic Discussion 06-20-2015, 04:42 PM
Replies: 233
Views: 14,470
Posted By david_ski
Best picture of your beer is the last beer that...

Best picture of your beer is the last beer that you had.
Last Thursday in Dublin Ireland at the Guinness Storehouse.
Forum: General / Other 04-13-2015, 12:18 AM
Replies: 5,892
Views: 598,547
Posted By david_ski
A round of buffing compound followed with a coat...

A round of buffing compound followed with a coat of wax. Now it ready for a season at the pond.
Forum: Trailers 03-20-2015, 02:08 AM
Replies: 9
Views: 741
Posted By david_ski
I use a piece of plywood (dimensions 2' x 4') ...

I use a piece of plywood (dimensions 2' x 4') that I lean up against the trailer on the south side to combat sun exposure. Quick to set up and take down.
Forum: Engine / Drive Train 03-19-2015, 01:47 AM
Replies: 17
Views: 1,254
Posted By david_ski
Get a 4160, dump the 4010. The 4010 can be tuned...

Get a 4160, dump the 4010. The 4010 can be tuned for hot or cold, idle or run. Best fix I made right after I purchased my 1993 ProStar 10 years ago.

Anyone want a used 4010. Haha!
Forum: Off Topic Discussion 11-01-2014, 12:16 AM
Replies: 21
Views: 1,385
Posted By david_ski
I am a west coast Giants fan, but hats off to KC...

I am a west coast Giants fan, but hats off to KC for a great series. Such class from both teams and fans. Again a great series, and game 7 could of gone either way.
Forum: Engine / Drive Train 10-25-2012, 12:25 AM
Replies: 36
Views: 3,840
Posted By david_ski
I put in 2 1/4 turn ball valves into the heater...

I put in 2 1/4 turn ball valves into the heater lines. In addition I added brass T's in line on the heater side. To winterize or during summer, valves closed and take the plugs out of the T's and...
Forum: General / Other 06-02-2012, 03:24 PM
Replies: 14
Views: 1,615
Posted By david_ski
I too had a leak in my muffler. I pinpointed the...

I too had a leak in my muffler. I pinpointed the leak, sanded the area well, the added some fiberglass/resin to the area. Two layers and it is as good as new. I used a mirror to inspect the inside...
Forum: Engine / Drive Train 02-18-2012, 03:02 AM
Replies: 14
Views: 4,131
Posted By david_ski
I had a similar leak in my muffler. I used...

I had a similar leak in my muffler. I used fiberglass and resin on exterior. I will post a picture tomorrow. I actually used a mirror and inspected the inside and found a fairly large crack at the...
Forum: General / Other 01-10-2012, 10:32 AM
Replies: 19
Views: 1,689
Posted By david_ski
not for gas tank. It is below floor line and the...

not for gas tank. It is below floor line and the rudder control cable is above it. Nothing is resting on it.

I am in China right now. I will post some new pics this weekend after I get home. I...
Forum: General / Other 12-20-2011, 01:42 AM
Replies: 19
Views: 1,689
Posted By david_ski
standard 1:1 BW trans; 1 in shaft and 13x13prop....

standard 1:1 BW trans; 1 in shaft and 13x13prop.

Even if it was a powerslot with a larger prop, the prop fins would be closer to rudder. This box is right behind the prop strut. This box is at the...
Forum: General / Other 12-19-2011, 04:00 PM
Replies: 19
Views: 1,689
Posted By david_ski
Purpose of this fiberglass extrusion in bilge

This is a 93 ProStar. The picture is in the rear of the bilge towards the rudder.

What is the purpose of the fiberglass hump that is part of the interior fiberglass pan (circled in RED)?

As you...
Forum: General / Other 11-29-2011, 01:31 AM
Replies: 1
Views: 534
Posted By david_ski
Muffler pin hole leak

I found a pin hole leak in one of my mufflers.

I was noticing more water in bilge than usual (typically none).
After taking off prop shaft access panel I noticed a small spray emiting from muffler...
Forum: General / Other 11-29-2011, 12:54 AM
Replies: 5,892
Views: 598,547
Posted By david_ski
I drained fuel from gas tank and cleaned the...

I drained fuel from gas tank and cleaned the chunks floating on the bottom.

I will replace the fuel pickup hose with new feed tube (strainer broke off and was rattling in tank).

New fuel hose from...
Forum: Off Topic Discussion 09-15-2011, 12:09 AM
Replies: 20
Views: 3,508
Posted By david_ski
You mean that this can happen more than...

You mean that this can happen more than once??
Drowning and submersion due to falling or jumping from burning water-skis, subsequent encounter.

I know that water skiing is an addictive sport, but...
Forum: General / Other 08-30-2011, 12:39 AM
Replies: 5,892
Views: 598,547
Posted By david_ski
Skied 2 sets. Then I changed the oil & filter....

Skied 2 sets. Then I changed the oil & filter. Good for another 50 hours. A great day.

Here is the strange thing. Last week I had tried to change the oil after our ski sets. I did it the same...
Forum: General Discussion 01-29-2008, 05:59 PM
Replies: 34
Views: 2,704
Posted By david_ski
Hurleman's Boat repair in Penryn on English...

Hurleman's Boat repair in Penryn on English Colony. Is is a master craftsman with fiberglass and wood.
Forum: General Discussion 09-07-2007, 01:06 AM
Replies: 219
Views: 13,092
Posted By david_ski
It cleans up real well what is your recipe for...

It cleans up real well
what is your recipe for your variation on "Britt's Boat scrub"?

I purchased a 1993 PS190 2 yeas ago and the previous owner had it shining just like yours.

The new owner...
Forum: Engine / Drive Train 07-26-2007, 01:15 PM
Replies: 3
Views: 782
Posted By david_ski
I have a 93 ProStar 190. I had a similar problem...

I have a 93 ProStar 190. I had a similar problem a couple of years ago. When I had less than 8-10 gallons in the tank. My boat would start to act like it was empty. My boat is carburated.

My...
Forum: General Discussion 07-05-2007, 05:53 PM
Replies: 23
Views: 3,169
Posted By david_ski
Great info. Another question from the timeline. ...

Great info.

Another question from the timeline. What years of ProStar lineage in the late 90's/early 2000's required the hull modification for tracking/turning?
Forum: Find A Pull / Give a Pull 08-02-2005, 01:14 AM
Replies: 18
Views: 1,882
Posted By david_ski
Yes, I think we were out there about a month ago...

Yes, I think we were out there about a month ago in the afternoon. You have a 93 stars and stripes? I thought is was a new model 04 MC197 (blue/white)?
Forum: Find A Pull / Give a Pull 08-02-2005, 12:06 AM
Replies: 18
Views: 1,882
Posted By david_ski
you got it. not my boat, but since I am boat...

you got it. not my boat, but since I am boat free this summer, that is what I have been sking behind.
Forum: Upholstery 08-02-2005, 12:02 AM
Replies: 53
Views: 6,309
Posted By david_ski
Did you order the skins from your local dealer or...

Did you order the skins from your local dealer or contact MC directly?
Showing results 1 to 25 of 27

 

All times are GMT -4. The time now is 05:20 PM.