Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 374
Search took 0.03 seconds.
Search: Posts Made By: jake
Forum: General Discussion 01-11-2010, 01:03 PM
Replies: 17
Views: 2,846
Posted By jake
Seems to be a mix of both rebate to dealer and...

Seems to be a mix of both rebate to dealer and MSRP discount. Talking to the dealer about a 2008, and the boat show discount does sweeten the deal somewhat but not the advertised face value.
Forum: Engine / Drive Train 08-01-2009, 11:58 AM
Replies: 15
Views: 1,610
Posted By jake
This topic has been discussed a number of times...

This topic has been discussed a number of times in the past, you may want to search old threads. My two cents, I was considering the same move a couple years ago, but after doing some research on...
Forum: Off Topic Discussion 07-31-2009, 09:24 PM
Replies: 88
Views: 4,470
Posted By jake
You must be 'up-north'. No AC in two years?

You must be 'up-north'. No AC in two years?
Forum: Off Topic Discussion 07-31-2009, 09:09 AM
Replies: 88
Views: 4,470
Posted By jake
Columbus is ~1.5m, Minneapolis is ~3m people. ...

Columbus is ~1.5m, Minneapolis is ~3m people. Have spent some time in Columbus, would say it feels more 'small town' than Minni. Upside of Minni is you get most of the features of a large citi...
Forum: Engine / Drive Train 07-28-2009, 03:57 PM
Replies: 20
Views: 2,101
Posted By jake
Something like this. These are made for a Bu,...

Something like this. These are made for a Bu, but thinking same thing for my 190.

Malibu turn down exhaust tips (http://www.bakesonline.com/detail.aspx?ID=756)

Here is another alternative, could...
Forum: Engine / Drive Train 07-28-2009, 01:36 PM
Replies: 35
Views: 2,171
Posted By jake
Should work. I had it on there with a 4160. ...

Should work. I had it on there with a 4160. Call them up and ask Vince to be sure.
Forum: Engine / Drive Train 07-28-2009, 12:00 PM
Replies: 20
Views: 2,101
Posted By jake
My boat is fairly quiet at idle. Noise I'm...

My boat is fairly quiet at idle. Noise I'm trying to address is at the exhaust tips, at speed. Live on a small-ish lake, would like to decrease noise if possible as a courtesy to my neighbors. I...
Forum: Engine / Drive Train 07-28-2009, 11:28 AM
Replies: 35
Views: 2,171
Posted By jake
There are USCG approved lines that are not steel....

There are USCG approved lines that are not steel. Not saying this one is approved, but I replaced my steel line with this product from DIM.

http://www.skidim.com/prodinfo.asp?number=JMS32-383831
Forum: Engine / Drive Train 07-28-2009, 09:54 AM
Replies: 20
Views: 2,101
Posted By jake
Why did you switch from the stock silent master's...

Why did you switch from the stock silent master's in your 94? Are these quieter? I've been looking around for ways to make my 93 quieter. A neighbor of mine on our lake has a CC with a down turned...
Forum: General Discussion 07-27-2009, 09:06 AM
Replies: 18
Views: 1,159
Posted By jake
Maybe some gloves?

Maybe some gloves?
Forum: Electrical 07-22-2009, 02:10 PM
Replies: 10
Views: 2,397
Posted By jake
The symptom has been solved, which was my PP...

The symptom has been solved, which was my PP rebooting often because voltage was too low. Cleaned up all the behind the dash connections, now have 11+ Volts at the tach/PP and it seems to be...
Forum: General / Other 07-21-2009, 06:38 PM
Replies: 11
Views: 2,381
Posted By jake
So after a few gyrations, got it working. Turns...

So after a few gyrations, got it working. Turns out I had a bad unit. The new one was also wired backwards so had to switch the wiring on a second sender but now all is well. Working fuel...
Forum: Electrical 07-21-2009, 03:03 PM
Replies: 10
Views: 2,397
Posted By jake
12.5 V, at the ignition switch (orange wire) 11.2...

12.5 V, at the ignition switch (orange wire)
11.2 V at the ignition switch (purple wire, ignition switch in the on position but boat not running)

13.5 V at both spots when boat is running
Forum: Electrical 07-21-2009, 02:29 PM
Replies: 10
Views: 2,397
Posted By jake
JimN: Think I already covered that. Voltage at...

JimN: Think I already covered that. Voltage at my dash (primary harness, leading to the circuit board, back to the orange cable on my ignition switch) is exactly the same as my battery posts 12,5V....
Forum: Electrical 07-21-2009, 12:10 PM
Replies: 10
Views: 2,397
Posted By jake
Jim: what should the voltage be at the boat...

Jim: what should the voltage be at the boat harness? Measured it last night, have 12.5V when the boat is off. If the voltage is correct, what does a continuity test tell me?
Forum: Electrical 07-20-2009, 10:57 PM
Replies: 10
Views: 2,397
Posted By jake
The meter was grounded on the main ground coming...

The meter was grounded on the main ground coming to the back of the tach.
Forum: Electrical 07-20-2009, 08:32 PM
Replies: 10
Views: 2,397
Posted By jake
Bad ignition switch?

So, finally got around to troubleshooting my low voltage issue at the dash. Here's what I found out:

1. 12.5V at the main harness coming in to the dash
2. 12.5V at the breaker panel
3. 12.5V...
Forum: Waterskiing & Barefooting 07-20-2009, 12:13 PM
Replies: 522
Views: 70,272
Posted By jake
http://lh3.ggpht.com/_RigWUQpMS-M/SmSXCrOI84I/AAAA...

http://lh3.ggpht.com/_RigWUQpMS-M/SmSXCrOI84I/AAAAAAAAB7w/Htpo3cWTi5M/s800/DSC_1246.JPG
Forum: Trailers 07-16-2009, 01:48 PM
Replies: 19
Views: 1,995
Posted By jake
Call the Illinois retail location, 309-862-1000. ...

Call the Illinois retail location, 309-862-1000. They are the only branch with the item in stock at this moment. I called and told them I need an Atwood trailer jack, model #84025...they were able...
Forum: Trailers 07-16-2009, 12:18 PM
Replies: 19
Views: 1,995
Posted By jake
FYI...Redneck Trailer Supply has the Atwood...

FYI...Redneck Trailer Supply has the Atwood 84025. Called Atwood, they will also sell direct but happened to be out of stock, referred me to Redneck, said they are the biggest distributor of Atwood...
Forum: Engine / Drive Train 07-15-2009, 12:04 PM
Replies: 7
Views: 1,773
Posted By jake
I had great results with a rebuild on my 4110...

I had great results with a rebuild on my 4110 last summer. Runs great. I know the majority opinion leans towards the 4160 on this board, but my dealer said the 4110 is a great carb, no need to...
Forum: General Discussion 07-10-2009, 09:53 AM
Replies: 37
Views: 2,378
Posted By jake
That guy is Nicolas Sarkozy, the president of...

That guy is Nicolas Sarkozy, the president of France, not a SS agent...
Forum: Trailers 07-08-2009, 03:22 PM
Replies: 19
Views: 1,995
Posted By jake
Has anyone found a replacement trailer jack that...

Has anyone found a replacement trailer jack that fits cleanly with the factory mounting configuration on this era trailer?
Forum: Appearance 07-08-2009, 03:06 PM
Replies: 27
Views: 3,005
Posted By jake
These work really well, Walmart, less than $5....

These work really well, Walmart, less than $5. They hold about one full bottle of Starbrite, and they spray a nice large pattern. You can just label it and leave the hull cleaner in there. A garden...
Forum: Appearance 07-08-2009, 02:06 PM
Replies: 27
Views: 3,005
Posted By jake
I tried Zing and it turned black plastic parts...

I tried Zing and it turned black plastic parts cloudy white (speedo pitots, bilge outlet). Starbrite doesn't do this. FYI
Showing results 1 to 25 of 374

 

All times are GMT -4. The time now is 11:58 PM.