Go Back   TeamTalk > Search Forums

Showing results 1 to 18 of 18
Search took 0.00 seconds.
Search: Posts Made By: 47Driver
Forum: General Discussion 04-25-2013, 08:55 AM
Replies: 21
Views: 3,244
Posted By 47Driver
They are still there.

They are still there.
Forum: Engine / Drive Train 04-10-2012, 09:36 PM
Replies: 4
Views: 533
Posted By 47Driver
Thank you for the responses!

Thank you for the responses!
Forum: Engine / Drive Train 04-07-2012, 08:24 AM
Replies: 4
Views: 533
Posted By 47Driver
Transmission Service Manual

Does anyone have any knowledge of a Velvet Drive (1:1 model 10-17.004) Service and/or Installation Manual that I can get off this site or the internet. I have searched the forums and can't seem to...
Forum: Upholstery 01-03-2011, 09:30 PM
Replies: 5
Views: 642
Posted By 47Driver
Thank You for the replies.

Thank You for the replies.
Forum: Upholstery 12-28-2010, 09:08 PM
Replies: 5
Views: 642
Posted By 47Driver
Upholsterer

Does anyone know of a good upholsterer in the lower Alabama, NW Florida area? Looking to get my bench seat redone. Thank You.
Forum: Engine / Drive Train 05-12-2010, 08:27 PM
Replies: 8
Views: 1,389
Posted By 47Driver
I use type F on my Velvet 1:1 Don't recall what...

I use type F on my Velvet 1:1 Don't recall what research I did to determine that. The Dexron type II that the manuals call for isn't made anymore, I believe.
Forum: Engine / Drive Train 05-03-2009, 07:08 PM
Replies: 6
Views: 478
Posted By 47Driver
Engine Issues

Two issues with the engine. Both started the same day. One: The motor just shuts down when under power. It has not happened at idle but shuts down when underway (2k and 4k rpm). No indication that...
Forum: Engine / Drive Train 02-16-2009, 03:35 PM
Replies: 3
Views: 1,041
Posted By 47Driver
XSMN Fluid

I have a 1:1 Velvet xmsn and the manual calls for Dexron2 or type F fluid. From going to the parts store this morning I am guessing that Dexron2 was phased out years ago but it looks like there are...
Forum: General / Other 08-05-2008, 09:01 PM
Replies: 3
Views: 440
Posted By 47Driver
Bimini

Could some one please post a detailed picture showing how the base of the poles are mounted to your boat. I want to see what my options are. My boat came with a top but it was mounted at the back of...
Forum: Trailers 07-23-2008, 09:16 AM
Replies: 30
Views: 2,906
Posted By 47Driver
Jeff, How well do those plastic wheels hold up...

Jeff,
How well do those plastic wheels hold up when all of that weight is applied? Where did you purchase them?
Forum: Trailers 07-23-2008, 09:12 AM
Replies: 30
Views: 2,906
Posted By 47Driver
For the guys that replaced the springs where did...

For the guys that replaced the springs where did you purchase them from and did you go with the original setup or did you increase the number of leaf springs??
Forum: Trailers 06-21-2008, 11:55 AM
Replies: 30
Views: 2,906
Posted By 47Driver
Prop Guard Riding to Low

Greetings. I have the usual problem of the prop guard riding to low (single axle). My drive way has an incline and putting the boat in the garage is a chore. Right now I am laying down shoring to get...
Forum: Engine / Drive Train 06-21-2008, 11:43 AM
Replies: 6
Views: 913
Posted By 47Driver
Drive Shaft Leaking

My drive shaft (on the boat) is leaking (steady stream). I am going to try and just tighten the packing nut to maybe slow it down a little but if I have to replace the packing what's best to go with?...
Forum: Trailers 05-26-2008, 06:11 PM
Replies: 9
Views: 756
Posted By 47Driver
Great...Walmart. That's were I spend most of my...

Great...Walmart. That's were I spend most of my money and time. I think I have the grease gun that will fit this one too.
Forum: Trailers 05-26-2008, 02:16 PM
Replies: 9
Views: 756
Posted By 47Driver
Wheel Bearing Grease

What type of grease do I use? Is there a marine type grease. Thanks for the reply's.
Forum: Trailers 04-30-2008, 11:25 PM
Replies: 13
Views: 995
Posted By 47Driver
Thanks for all of the replys fellas. Will this...

Thanks for all of the replys fellas. Will this work with the trailer brake system??
Forum: Trailers 04-30-2008, 07:45 AM
Replies: 137
Views: 16,386
Posted By 47Driver
Any peculiarities to recarpeting the V-block? ...

Any peculiarities to recarpeting the V-block? Mine needs to be done asap.
Forum: Trailers 04-30-2008, 07:31 AM
Replies: 13
Views: 995
Posted By 47Driver
Trailer is too long

Hey fellas , new MC owner here. This teamtalk has been great for me and has already answered a bunch of my questions. Here's one I need help with. I am in the process of looking for a new home and I...
Showing results 1 to 18 of 18

 

All times are GMT -4. The time now is 01:23 PM.