Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Jeff d
Forum: Electrical 07-21-2015, 08:06 PM
Replies: 35
Views: 5,047
Posted By Jeff d
I'm not sure on the paddle wheel. Does it...

I'm not sure on the paddle wheel. Does it currently go through the MDC? You'll have to get a paddle wheel compatible speedometer for sure since the ones included in most gauge sets are pitot pickup...
Forum: Electrical 07-20-2015, 09:33 PM
Replies: 35
Views: 5,047
Posted By Jeff d
It converts the standard variable resistance...

It converts the standard variable resistance signals from the senders to a proprietary electronic bus signal to be processed by proprietary gauges. You don't lose any functionality if you replace...
Forum: Electrical 07-16-2015, 08:07 AM
Replies: 35
Views: 5,047
Posted By Jeff d
Perfect pass has an hour meter and it can be...

Perfect pass has an hour meter and it can be synced up with actual hours. None of the tachs I've seen have provisions to roll them forward to match actual hours. Faria makes an identical tach to...
Forum: Electrical 06-19-2015, 08:00 AM
Replies: 35
Views: 5,047
Posted By Jeff d
The jury is still out on the fuel level sender. ...

The jury is still out on the fuel level sender. The oem centroid senders that MC have a terrible reputation to begin with. I'm pretty certain that a couple of years before I did the MDC-extomy I...
Forum: Engine / Drive Train 06-03-2015, 03:31 PM
Replies: 53
Views: 5,609
Posted By Jeff d
A. Very likely B. Yes C. Yes, like Rossterman...

A. Very likely
B. Yes
C. Yes, like Rossterman said the water from the pitot tube actually enters the MDC. If it freezes in there it cracks the chamber then water flows over the electronics inside. ...
Forum: Engine / Drive Train 05-27-2015, 10:26 AM
Replies: 53
Views: 5,609
Posted By Jeff d
It's all...

It's all here:
http://www.mastercraft.com/teamtalk/showthread.php?p=1052383#post1052383

It would likely be the same on an '03 but I can't say for sure. It might be a little rough if you've never...
Forum: Engine / Drive Train 05-27-2015, 09:28 AM
Replies: 53
Views: 5,609
Posted By Jeff d
Not possible. I think he just glossed over the...

Not possible. I think he just glossed over the fact that he swapped in analog gauges based on the level of quoting of my write-up.

Normal analog gauges, with the exception of the tach and volt...
Forum: Engine / Drive Train 05-26-2015, 10:05 PM
Replies: 53
Views: 5,609
Posted By Jeff d
Mine are all still working well after...

Mine are all still working well after de-winterization. With the analog fuel level gauge and sender the needle moves back and forth a bit when the boat rocks. I like that as it gives me more...
Forum: Electrical 05-18-2015, 01:46 PM
Replies: 35
Views: 5,047
Posted By Jeff d
Not really. It's a pain. You have to be good at...

Not really. It's a pain. You have to be good at working by feel only.
Forum: Electrical 02-02-2015, 09:05 PM
Replies: 35
Views: 5,047
Posted By Jeff d
Ok, I guess mine was bad then. Good to know it...

Ok, I guess mine was bad then. Good to know it will work with a standard gauge.
Forum: Electrical 02-02-2015, 09:00 AM
Replies: 35
Views: 5,047
Posted By Jeff d
I have it but I wouldn't bother with it as it was...

I have it but I wouldn't bother with it as it was one of the gauges that I had erratic behavior with.
Forum: Electrical 02-01-2015, 09:10 PM
Replies: 35
Views: 5,047
Posted By Jeff d
Did you use an OE 3 wire solid state sender or a...

Did you use an OE 3 wire solid state sender or a 2 wire mechanical sender?
Forum: Electrical 02-01-2015, 07:53 PM
Replies: 35
Views: 5,047
Posted By Jeff d
Noice! Did you have to replace the fuel level...

Noice! Did you have to replace the fuel level sender or did the original one work? I never definitely determined if my oe sender was bad or just non-standard/not compatible.
Forum: General Discussion 09-22-2014, 07:41 AM
Replies: 27
Views: 1,280
Posted By Jeff d
0% in Louisiana if the sale is between private...

0% in Louisiana if the sale is between private parties. You only pay tax on the trailer at the rate for your parish (what we call counties. Usually 8-9%). It's up to the buyer and seller to decide...
Forum: General Discussion 09-10-2014, 08:07 AM
Replies: 19
Views: 1,788
Posted By Jeff d
Often the throttle body and/or the spark arrestor...

Often the throttle body and/or the spark arrestor can make a high pitched noise at certain RPM. Mine does. Are you sure it's the transmission? On the LTR the air intake is like 16" from the...
Forum: General Discussion 09-09-2014, 08:40 AM
Replies: 5
Views: 989
Posted By Jeff d
I don't have a part number for the alternator...

I don't have a part number for the alternator bracket but I did have to replace mine due to a similar failure to yours. The local dealer was able to find one and it was $111 but that was over 3...
Forum: General Discussion 09-08-2014, 05:26 PM
Replies: 5
Views: 989
Posted By Jeff d
Make sure you have the supplemental bracket...

Make sure you have the supplemental bracket covered by Indmar Advisory #SA2001-1 which calls for the installation of the "495109 LTR Alternator Bracket Kit". I got this from the MC dealer and I...
Forum: General Discussion 09-06-2014, 11:50 AM
Replies: 11
Views: 1,933
Posted By Jeff d
If concerned about the durability of the plastic...

If concerned about the durability of the plastic Perko kit you can do what this guy did:
http://www.mastercraft.com/teamtalk/showthread.php?t=51590
Forum: General Discussion 09-01-2014, 02:08 PM
Replies: 24
Views: 3,098
Posted By Jeff d
I don't know. There are posts on wakeworld and...

I don't know. There are posts on wakeworld and planet nautique. The pictures I've seen the break occurred right between the prop and the strut.
Forum: General Discussion 09-01-2014, 01:50 PM
Replies: 24
Views: 3,098
Posted By Jeff d
I've seen a lot of reports of shafts snapping on...

I've seen a lot of reports of shafts snapping on the Nautique G series boats, allegedly with no impact.
Forum: General Discussion 08-31-2014, 05:06 PM
Replies: 12
Views: 635
Posted By Jeff d
I don't know much about this but don't some of...

I don't know much about this but don't some of the earlier throttle by wire boats need a MEFI flash update to work with perfect pass?
Forum: Trailers 08-31-2014, 05:03 PM
Replies: 9
Views: 1,199
Posted By Jeff d
I have these from MadDog and don't like them. ...

I have these from MadDog and don't like them. I'm pretty sure they were originally advertised as sunbrella but they definitely are not. They faded from black to a bit of a purple in one season...
Forum: General Discussion 08-29-2014, 07:34 PM
Replies: 5
Views: 336
Posted By Jeff d
Get the StarGazer (GPS) if nothing else for the...

Get the StarGazer (GPS) if nothing else for the easier install. If you get the non-stargazer then you have to cut a big honkin' hole in the bottom of the boat for the paddle wheel.
Forum: Appearance 08-29-2014, 12:48 PM
Replies: 8
Views: 732
Posted By Jeff d
I wouldn't. Too many horror stories of vinyl...

I wouldn't. Too many horror stories of vinyl falling apart shortly thereafter. Even if it's a small spot it will remove the shine from the vinyl so you'll have a dull spot. If there's a stain that...
Forum: Appearance 08-29-2014, 12:19 PM
Replies: 8
Views: 732
Posted By Jeff d
LA's Totally Awesome degreaser from the dollar...

LA's Totally Awesome degreaser from the dollar store (Most Dollar Trees, Dollar General, Family Dollar etc carry it). The yellow liquid in the tranclucent bottle with only red writing on it (There...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 08:33 AM.