Go Back   TeamTalk > Search Forums

Showing results 1 to 11 of 11
Search took 0.02 seconds.
Search: Posts Made By: Dakotax
Forum: General / Other 04-09-2012, 04:40 PM
Replies: 3
Views: 461
Posted By Dakotax
Do they make the wake glow or is it like two...

Do they make the wake glow or is it like two beams of light shining into the water? I have 2 college age boys at home and they are often out after dark unless the Game and Fish is patrolling our...
Forum: General / Other 04-09-2012, 11:45 AM
Replies: 3
Views: 461
Posted By Dakotax
Underwater light position

I am adding underwater lights to my X-2. Do the leds light up the wake better if they are mounted in the center between the exhaust ports or outside of the swim platform brackets. We would like to...
Forum: Engine / Drive Train 10-28-2011, 09:36 PM
Replies: 5
Views: 681
Posted By Dakotax
When I was winterizing I noticed the nut on the...

When I was winterizing I noticed the nut on the end of prop shaft was loose. Also noticed oil lines to trans cooler were being pinched when add on ballast bag rolled against engine compartment...
Forum: Engine / Drive Train 10-14-2011, 07:29 PM
Replies: 5
Views: 681
Posted By Dakotax
If I put my hand over the flange I can turn it...

If I put my hand over the flange I can turn it but it is difficult. I have the 15w40 oil in it and the air temp was in the 50's.
Forum: Engine / Drive Train 10-14-2011, 07:01 PM
Replies: 5
Views: 681
Posted By Dakotax
how hard should output flange turn

Any one know how hard it should be to turn output flange on transmission. I have 09 X2.
Forum: General Discussion 08-09-2011, 09:59 AM
Replies: 2
Views: 378
Posted By Dakotax
switch is fine. Called Lenco, said they would...

switch is fine. Called Lenco, said they would replace it under warranty.
Forum: General Discussion 08-07-2011, 08:28 PM
Replies: 2
Views: 378
Posted By Dakotax
trim tab problem

Noticed the trim tab on my 09 X2 did not retract when I put it on the lift. It would not go up or down when I ran the switch. When I pulled up on it while operating the switch it engaged and...
Forum: General Discussion 08-16-2010, 05:02 PM
Replies: 4
Views: 523
Posted By Dakotax
Usually don't have a problem with the bow when we...

Usually don't have a problem with the bow when we surf, the rear of the boat is another story. I have to admit the ballast pumps are frustrating. This spring I replaced the Jabsco controls with...
Forum: General Discussion 08-16-2010, 03:40 PM
Replies: 4
Views: 523
Posted By Dakotax
I was thinking it was from the wake washing on...

I was thinking it was from the wake washing on the motor hatches, but maybe I have a leak somewhere.
Forum: General Discussion 08-16-2010, 12:49 PM
Replies: 4
Views: 523
Posted By Dakotax
Does MC warranty drowned x2 ballast pump?

Any one else submerge the port ballast pump when surfing? The bilge pump in the back is on the high side (starboard) and the water gets deep on the port side in the back. Was wondering if any were...
Forum: General Discussion 07-28-2010, 07:31 PM
Replies: 0
Views: 306
Posted By Dakotax
Timer for ballast relay

I have the add on ballast bags and have replaced my ballast timers with relays. I am thinking of adding a timer to the toggle switch power supply so they do not get left on. I am looking at a solid...
Showing results 1 to 11 of 11

 

All times are GMT -4. The time now is 01:08 AM.