Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: blackhawk
Forum: Storage / Winterization Today, 12:00 AM
Replies: 32
Views: 4,915
Posted By blackhawk
Yes, they would be jacked up if they are running...

Yes, they would be jacked up if they are running on the pink RV ethylene glycol based antifreeze. Even though standard green automotive AF may contain ethylene glycol, it also contains many other...
Forum: Storage / Winterization Yesterday, 08:33 PM
Replies: 32
Views: 4,915
Posted By blackhawk
To add to Epnault, propylene glycol also offers...

To add to Epnault, propylene glycol also offers corrosion protection. I did a whole thread about this where I ran tests. It does make a difference. Don't use ethylene glycol, it will actually pit...
Forum: General Discussion 09-23-2018, 09:22 PM
Replies: 0
Views: 105
Posted By blackhawk
South Holston Lake VA

I know there are a few TT members at South Holston Lake. How are the conditions on the water? Any floating debris from Hurricane Florence? I was thinking about making a trip down there on Saturday...
Forum: General Discussion 09-20-2018, 09:06 PM
Replies: 21
Views: 952
Posted By blackhawk
Don't feel bad, the MC dealers in NC and VA...

Don't feel bad, the MC dealers in NC and VA aren't any better. I have never had a single one ever return a phone call or email.
Forum: Ballast 09-09-2018, 08:39 PM
Replies: 26
Views: 764
Posted By blackhawk
I attach a bungee cord to the vent line of my...

I attach a bungee cord to the vent line of my bags. This makes sure that bags don't collapse completely around the vent area. If the vent area collapses, you can't suck in air to replace the water....
Forum: Ballast 09-04-2018, 10:10 PM
Replies: 5
Views: 205
Posted By blackhawk
I would swap pumps and see if the problem...

I would swap pumps and see if the problem follows. To be honest, I would just go ahead and buy a new pump. I always keep a spare on board just in case.
Forum: Ballast 09-04-2018, 10:08 PM
Replies: 26
Views: 764
Posted By blackhawk
Check valves at the vents aren't necessary.

Check valves at the vents aren't necessary.
Forum: Ballast 08-30-2018, 09:26 PM
Replies: 5
Views: 205
Posted By blackhawk
Check the tips of the impeller. If you see...

Check the tips of the impeller. If you see pronounced flat spots, you need a new impeller.

Do you have this problem running the pump with the engine on?
Forum: General Discussion 08-12-2018, 09:44 PM
Replies: 15
Views: 468
Posted By blackhawk
I fill and empty mine at speed all the time.

I fill and empty mine at speed all the time.
Forum: General Discussion 08-12-2018, 09:40 PM
Replies: 14
Views: 1,102
Posted By blackhawk
You will need to pull your shaft and check it for...

You will need to pull your shaft and check it for straightness. You could roll it on a granite countertop for a rough check. Put a light behind the shaft and roll it around and see if you can see a...
Forum: Upholstery 08-04-2018, 10:37 PM
Replies: 11
Views: 2,259
Posted By blackhawk
Was it the Rustoleum Leak...

Was it the Rustoleum Leak...
Forum: Audio/Stereo 08-04-2018, 10:29 PM
Replies: 21
Views: 650
Posted By blackhawk
My 2 7.7s are plenty at surf range for me. I...

My 2 7.7s are plenty at surf range for me. I have them bridged off a M400/4.
Forum: General Discussion 08-04-2018, 10:24 PM
Replies: 7
Views: 509
Posted By blackhawk
Was it the actual lip seal or the hose connection...

Was it the actual lip seal or the hose connection going to the whole assembly?
Forum: Audio/Stereo 08-02-2018, 10:09 PM
Replies: 14
Views: 407
Posted By blackhawk
LDA6339 - Using a multimeter will work fine. You...

LDA6339 - Using a multimeter will work fine. You just need to figure out the voltage that you are looking for on the output of the amp. Look in you amp manual and find your power rating based on...
Forum: Audio/Stereo 08-01-2018, 09:44 PM
Replies: 14
Views: 407
Posted By blackhawk
JimN - My battery was showing 12.6 volts before I...

JimN - My battery was showing 12.6 volts before I started setting the amp gains. That is a good point on the voltage, I didn't notice the 60 watt rating at 12.5V in the JL manual until you pointed...
Forum: Audio/Stereo 07-31-2018, 10:23 PM
Replies: 14
Views: 407
Posted By blackhawk
All my measurements were with no load and I only...

All my measurements were with no load and I only have one pair of RCAs going into the amp.

I had sent a message to JL Audio about the 1.0 volt difference. They said that they have seen a difference...
Forum: Audio/Stereo 07-30-2018, 10:41 PM
Replies: 14
Views: 407
Posted By blackhawk
Should amp output voltage vary between channels?

I just installed a new JL Audio M600/6 amp to power my cabin speakers and sub. When I was measuring the voltage on the amp output channels to set my gains, I noticed that channels 1 and 2 had...
Forum: Audio/Stereo 07-20-2018, 10:22 PM
Replies: 4
Views: 283
Posted By blackhawk
12 years out of an amp is probably not too bad.

12 years out of an amp is probably not too bad.
Forum: Audio/Stereo 07-19-2018, 11:03 PM
Replies: 4
Views: 283
Posted By blackhawk
Time to replace old JL e6450 amp?

I still have the original e6450 amp in my 2006. A couple of weeks ago I noticed the right bow speaker wasn't working. I swapped the speakers and still no sound from the right bow. It actually...
Forum: Wakeboarding & Wakeskating 07-19-2018, 10:57 PM
Replies: 4
Views: 225
Posted By blackhawk
Tommy's advice is dead on. I would start out at...

Tommy's advice is dead on. I would start out at 60', 21 mph, and no ballast. Playing around with your speed first and see what you like. Then as you advance, start adding ballast. I've played...
Forum: Ballast 07-16-2018, 10:17 PM
Replies: 5
Views: 221
Posted By blackhawk
Check to see what voltage you are getting at the...

Check to see what voltage you are getting at the pumps.
Forum: Underwater Running Gear 07-05-2018, 10:27 PM
Replies: 21
Views: 867
Posted By blackhawk
You could take them to a machine shop and have...

You could take them to a machine shop and have them knurl them. They can control the knurl height and build it up to get a tight fit for you.
Forum: General Discussion 07-03-2018, 11:04 PM
Replies: 9
Views: 512
Posted By blackhawk
I was able to carefully tweak my strut back in...

I was able to carefully tweak my strut back in alignment. Just like gwozhog, I used a piece of 1-1/8" round that I found at work. I got the shaft pretty well centered in the thru hull fitting....
Forum: Engine / Drive Train 06-29-2018, 09:02 PM
Replies: 25
Views: 1,066
Posted By blackhawk
Does it have a waterline running to it? If it...

Does it have a waterline running to it? If it does, it is dripless.
Forum: Engine / Drive Train 06-29-2018, 09:01 PM
Replies: 33
Views: 1,295
Posted By blackhawk
Do you have a link to that Youtube video?

Do you have a link to that Youtube video?
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 09:22 AM.


2018