Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 345
Search took 0.02 seconds.
Search: Posts Made By: ProStar Slalom
Forum: General / Other Today, 07:43 AM
Replies: 3
Views: 64
Posted By ProStar Slalom
Not sure about the best place to buy, but there...

Not sure about the best place to buy, but there are plenty out there and plenty of threads on here about biminis. I would recommend mounting it so that it will lie flat at the front edge of the...
Forum: Electrical 01-24-2015, 08:17 AM
Replies: 3
Views: 183
Posted By ProStar Slalom
Worth a look/try. I have not had a speedometer...

Worth a look/try. I have not had a speedometer out, but the smaller gauges were completely sealed if I recall correctly...might have to "break into" the back of the instrument to get to the guts.
Forum: Electrical 01-23-2015, 08:51 PM
Replies: 3
Views: 183
Posted By ProStar Slalom
Doesn't the '03 have Medallion gauges? If so,...

Doesn't the '03 have Medallion gauges? If so, the signal goes through the MDC (black box). I've never heard of being able to replace a stepper motor...more likely a MDC issue.
Forum: Electrical 01-13-2015, 08:27 PM
Replies: 6
Views: 1,998
Posted By ProStar Slalom
Ok, I'll install the transducer per the...

Ok, I'll install the transducer per the instructions and go with the accessory switch for power. Thanks to all for the help.
Forum: Electrical 01-12-2015, 09:02 PM
Replies: 6
Views: 1,998
Posted By ProStar Slalom
Threadjack here. I just purchased a Faria depth...

Threadjack here. I just purchased a Faria depth gauge which came with the same transducer described in the original post. I had not previously read this write-up, so was surprised by the complexity...
Forum: Engine / Drive Train 12-07-2014, 08:13 AM
Replies: 17
Views: 994
Posted By ProStar Slalom
New plugs, wires, cap, and rotor...all is well. ...

New plugs, wires, cap, and rotor...all is well. I had one wet plug which had to be the source of the engine running rough. The rest of the plugs were fine, but after looking at the corrosion inside...
Forum: Engine / Drive Train 11-30-2014, 06:46 AM
Replies: 17
Views: 994
Posted By ProStar Slalom
Thanks again to all; I'll update after digging...

Thanks again to all; I'll update after digging into it a bit; probably next weekend.
Forum: Engine / Drive Train 11-29-2014, 09:54 AM
Replies: 17
Views: 994
Posted By ProStar Slalom
Thanks, Jim. Cap/rotor/wires from auto parts...

Thanks, Jim. Cap/rotor/wires from auto parts store as well? Faster than Ski DIM if I can get them locally.
Forum: Engine / Drive Train 11-28-2014, 07:17 PM
Replies: 17
Views: 994
Posted By ProStar Slalom
Thanks, Jim; great to see you chime in. What...

Thanks, Jim; great to see you chime in. What fuel pressure am I looking for? Check at idle and at RPM? Probably a dumb question, but can I use a tire pressure gauge? I assume I can get...
Forum: Engine / Drive Train 11-28-2014, 08:19 AM
Replies: 17
Views: 994
Posted By ProStar Slalom
Thanks, guys. I'll try going that route. I was...

Thanks, guys. I'll try going that route. I was thinking something fuel related, but you've both steered me toward spark; will give it a try.

Scott
Forum: Engine / Drive Train 11-27-2014, 08:27 PM
Replies: 17
Views: 994
Posted By ProStar Slalom
Thanks, Mike. I've changed the plugs, but it's...

Thanks, Mike. I've changed the plugs, but it's been a few years. Cap, rotor, and wires are probably original. I'll pull the plugs and take a look.
Forum: Engine / Drive Train 11-27-2014, 04:46 PM
Replies: 17
Views: 994
Posted By ProStar Slalom
I haven't, but not sure what to check with them...

I haven't, but not sure what to check with them other than making sure all connections are good. I guess I could pull the plugs and see if one hasn't been firing?
Forum: Engine / Drive Train 11-27-2014, 03:21 PM
Replies: 17
Views: 994
Posted By ProStar Slalom
Help--TBI started running rough

2001 Predator 310hp TBI. It had been running fine all year. The last couple of times out it started running rough. After warming up, still slightly rough at idle, but when throttling up either...
Forum: General Discussion 10-07-2014, 10:26 PM
Replies: 9
Views: 735
Posted By ProStar Slalom
Wow...well over $100 for a Medallion fuel gauge. ...

Wow...well over $100 for a Medallion fuel gauge. Just reinforces the idea to tear out all of the Medallion junk and put in reliable gauges....winter project for me.
Forum: General Discussion 09-21-2014, 06:31 PM
Replies: 12
Views: 760
Posted By ProStar Slalom
Yes, you will want it as level as possible to...

Yes, you will want it as level as possible to drain out any water each time you raise the boat.
Forum: General Discussion 09-05-2014, 10:13 PM
Replies: 2
Views: 279
Posted By ProStar Slalom
Call the guys at perfect pass; they have a good...

Call the guys at perfect pass; they have a good reputation for customer service.
Forum: General Discussion 07-17-2014, 02:37 PM
Replies: 11
Views: 688
Posted By ProStar Slalom
All, Thanks for the feedback so far. I had not...

All,

Thanks for the feedback so far. I had not considered the bunks causing the lift to float. I think it's a steel cradle and seems really heavy, but I'll have to consider that. I think I'll...
Forum: General Discussion 07-16-2014, 07:02 PM
Replies: 11
Views: 688
Posted By ProStar Slalom
Boat Lift Bunks

Fellas,

As you can see in the pic, the boat lift at our new house needs some work. Before I get started, need your thoughts on whether 2x8s on edge are wide enough to support the boat? Our...
Forum: General Discussion 06-28-2014, 09:17 AM
Replies: 4
Views: 267
Posted By ProStar Slalom
Great memories. Reinforces my decision to cancel...

Great memories. Reinforces my decision to cancel my subscription years ago...today's magazine is a disgrace compared to what they used to publish.
Forum: General Discussion 06-04-2014, 09:51 AM
Replies: 18
Views: 1,145
Posted By ProStar Slalom
I would watch ski-it-again and/or ebay and find a...

I would watch ski-it-again and/or ebay and find a used complete system, or put one together. You'll need the timer to pick-up magnets. Paddlewheel versions will require drilling a hole in the hull....
Forum: General Discussion 06-03-2014, 08:21 AM
Replies: 1
Views: 244
Posted By ProStar Slalom
Depends on transmission. Powerslot will be 1...

Depends on transmission. Powerslot will be 1 1/8"; 1:1 trans will be 1"
Forum: Waterskiing & Barefooting 06-02-2014, 11:07 PM
Replies: 17
Views: 2,323
Posted By ProStar Slalom
We did some cleaning and reorganizing recently...

We did some cleaning and reorganizing recently and decided to see what we've acquired over the years. Surprised to see what looks like "OJ" on one of the wood skis. "OJ" or maybe "CJ" for...
Forum: General Discussion 05-16-2014, 08:29 AM
Replies: 5
Views: 292
Posted By ProStar Slalom
Owned one for seven years; great boat. Glare...

Owned one for seven years; great boat. Glare never bothered me, but windshield height sucked...for me the top frame was right at eye level.
Forum: MasterCraft In Your Area 05-02-2014, 08:19 AM
Replies: 43
Views: 2,739
Posted By ProStar Slalom
[QUOTE=bgeorge01;1039909]Where is there a slalom...

[QUOTE=bgeorge01;1039909]Where is there a slalom course? I ride OHL all the time but have only been doing it for 2 years, pretty excited to get to know where I can and cannot go. I can't believe that...
Forum: Engine / Drive Train 05-02-2014, 08:14 AM
Replies: 37
Views: 2,885
Posted By ProStar Slalom
Good for you, Jeff. Plenty of us have had to...

Good for you, Jeff. Plenty of us have had to replace the black box and/or a gauge or two. Please keep us posted on how this turns out.
Showing results 1 to 25 of 345

 

All times are GMT -4. The time now is 02:26 PM.