Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 396
Search took 0.02 seconds.
Search: Posts Made By: MLA
Forum: Storage / Winterization Yesterday, 07:37 PM
Replies: 5
Views: 159
Posted By MLA
Used oil is corrosive. no advantage to leaving it...

Used oil is corrosive. no advantage to leaving it sit while the boat is laid up for winter.
Forum: General Discussion Yesterday, 06:30 PM
Replies: 6
Views: 219
Posted By MLA
Pull straight out gently.

Pull straight out gently.
Forum: Audio/Stereo 10-17-2014, 04:33 PM
Replies: 8
Views: 366
Posted By MLA
They could. If those are used for the sub chnls,...

They could. If those are used for the sub chnls, the sub level would be tied to the head-unit volume and not be effected by front or rear fade. Personal preference, as some like the sub level to be...
Forum: MasterCraft In Your Area 10-13-2014, 01:33 PM
Replies: 7
Views: 544
Posted By MLA
its Lake Wylie SE of Charlotte. Wylie is the 2nd...

its Lake Wylie SE of Charlotte. Wylie is the 2nd lake down the river from Norman.
Forum: Audio/Stereo 10-10-2014, 06:34 AM
Replies: 8
Views: 394
Posted By MLA
Are you replacing the existing e6450M? You will...

Are you replacing the existing e6450M? You will need some means of turning down the volume of the in-boat amp. Your tower amp volume will be tied to the head-unit level, so the JL volume control can...
Forum: Audio/Stereo 10-09-2014, 08:55 PM
Replies: 5
Views: 484
Posted By MLA
I am trying to get a hold of one similar to demo,...

I am trying to get a hold of one similar to demo, so no feedback right now. I would suggest an external amp for an application like a boat. Not so much for heat, but because the internal amp is not...
Forum: Engine / Drive Train 10-08-2014, 07:11 PM
Replies: 42
Views: 1,711
Posted By MLA
If you pulled coil packs/module off as an...

If you pulled coil packs/module off as an assembly and reinstalled an assembly, then nothing changed. Are you sure you know which cylinder is which?

That does look like a chevy 5.7 and not a Cadi...
Forum: Engine / Drive Train 10-08-2014, 04:24 PM
Replies: 42
Views: 1,711
Posted By MLA
What engine is it specifically? Compression...

What engine is it specifically?

Compression test tells you that the cam timing is likely correct, but what about the distributor timing, as well as the actual firing order.
Forum: General Discussion 10-06-2014, 09:05 PM
Replies: 16
Views: 645
Posted By MLA
Certainly a potential source for a leak, but that...

Certainly a potential source for a leak, but that hose usually T's off after the impeller, but pre-engine,s o that water leak would be lake temp.
Forum: General Discussion 10-06-2014, 05:32 PM
Replies: 16
Views: 645
Posted By MLA
Warm water usually means its passed through the...

Warm water usually means its passed through the engine first.
Forum: Audio/Stereo 10-01-2014, 01:51 PM
Replies: 9
Views: 490
Posted By MLA
Id bet that that 500-1 is a low-pass sub mono...

Id bet that that 500-1 is a low-pass sub mono only, not like the full-range 750/1.
Forum: Off Topic Discussion 09-30-2014, 12:25 AM
Replies: 235
Views: 15,252
Posted By MLA
Sun rise over Lake Mead from Temple Bar marina,...

Sun rise over Lake Mead from Temple Bar marina, Sat a week ago. 20 minutes later, we were surfing.

http://i45.photobucket.com/albums/f97/Lake_Mead_Tiges/IMG_5926_zps5f034c1b.jpg...
Forum: Storage / Winterization 09-29-2014, 10:14 PM
Replies: 26
Views: 1,161
Posted By MLA
If you drain the block of water prior to the...

If you drain the block of water prior to the introduction of the marine/rv antifreeze, is will fill, once you fire the engine back up. This insures you have nearly zero dilution of the antifreeze....
Forum: General / Other 09-28-2014, 05:36 PM
Replies: 7
Views: 407
Posted By MLA
Drill, tap and install one

Drill, tap and install one
Forum: Audio/Stereo 09-21-2014, 08:11 PM
Replies: 9
Views: 490
Posted By MLA
Wet Sounds SD-6 if you are certain that those...

Wet Sounds SD-6 if you are certain that those will be in the near future. For a single amp for a pro-485, the HT-2 is perfect.
Forum: Electrical 09-16-2014, 03:41 PM
Replies: 5
Views: 261
Posted By MLA
Ideally, you would be looking at 2 amps to drive...

Ideally, you would be looking at 2 amps to drive a pair of Rev-10 and 2 subs, then I guess theres an amp for the in-boats. I would do a large gauge trunk like off the battery/battery switch to amp...
Forum: Electrical 09-14-2014, 09:07 PM
Replies: 5
Views: 261
Posted By MLA
1) 12V batteries could not be wired in series on...

1) 12V batteries could not be wired in series on a 12V engine system. But to answer your basic question, no, the alternator would not do well at recharging them if they are run down.

2) Really...
Forum: Audio/Stereo 09-14-2014, 10:38 AM
Replies: 13
Views: 615
Posted By MLA
Head-unit red (at the head unit, but could be any...

Head-unit red (at the head unit, but could be any color at the helm) turn-on to the ACC1 switched output. Bypass the key switch all together for the radio.
Forum: Audio/Stereo 09-13-2014, 05:45 PM
Replies: 13
Views: 615
Posted By MLA
I would worry less with how its currently wired,...

I would worry less with how its currently wired, and concentrate on how it needs to be wired to achieve your goal

You ACC rocker needs to have a constant B+ when the battery switch is on, or all the...
Forum: Audio/Stereo 09-08-2014, 10:30 AM
Replies: 13
Views: 615
Posted By MLA
Yes. Seems as if someone attempted to do what you...

Yes. Seems as if someone attempted to do what you are wanting to, but didnt quite get it. If it was wired correctly to the ACC1, it would not be effected by the key switch. its 12v input would be...
Forum: Audio/Stereo 09-08-2014, 06:42 AM
Replies: 13
Views: 615
Posted By MLA
You will need to isolate the head-units turn-on...

You will need to isolate the head-units turn-on wire and move it from the IGN terminal to the ACC terminal. Or, relocated it to a rocker switch.
Forum: Audio/Stereo 09-07-2014, 09:25 PM
Replies: 13
Views: 615
Posted By MLA
Are you talking about the key switch and a rocker...

Are you talking about the key switch and a rocker switch? I would prefer the head-unit turn-on to no be tied to the key switch.
Forum: Towers 09-07-2014, 06:01 PM
Replies: 1
Views: 183
Posted By MLA
looks like you need thicker inserts.

looks like you need thicker inserts.
Forum: Electrical 09-05-2014, 10:49 PM
Replies: 12
Views: 416
Posted By MLA
The typical 4 wire GM style IAC is a PWM...

The typical 4 wire GM style IAC is a PWM controlled motor, so there is not a constant voltage reading.
Forum: Electrical 09-05-2014, 09:45 PM
Replies: 12
Views: 416
Posted By MLA
An IAC motor issue will not alter the fuel/air...

An IAC motor issue will not alter the fuel/air ratio. It will not create a rough running engine, only too slow, too fast or correct idle speed.
Showing results 1 to 25 of 396

 

All times are GMT -4. The time now is 05:39 PM.