Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 319
Search took 0.02 seconds.
Search: Posts Made By: 1990lmtd
Forum: Underwater Running Gear 09-01-2015, 04:57 PM
Replies: 27
Views: 692
Posted By 1990lmtd
To get something on the nut on the shaft you have...

To get something on the nut on the shaft you have to tilt the engine forward a bit. No really that hard to do.
Forum: Engine / Drive Train 08-29-2015, 09:46 PM
Replies: 2
Views: 211
Posted By 1990lmtd
Trans takes about 30 to 40 minutes to remove. I'm...

Trans takes about 30 to 40 minutes to remove. I'm not sure what the issue could be. Could you post a video?
Forum: General Discussion 08-27-2015, 09:39 PM
Replies: 68
Views: 41,093
Posted By 1990lmtd
Great video, thanks.

Great video, thanks.
Forum: Engine / Drive Train 08-27-2015, 09:11 PM
Replies: 8
Views: 243
Posted By 1990lmtd
I'm on pascoag reservoir, I sold my last slalom...

I'm on pascoag reservoir, I sold my last slalom ski to a guy that I think was on Johnsons pond named Chris with a mastercraft. Too funny. Good luck with your coil.
Forum: Engine / Drive Train 08-27-2015, 04:13 PM
Replies: 8
Views: 243
Posted By 1990lmtd
That's cool, how's the water level? I think...

That's cool, how's the water level? I think we've met. Did I sell you a slalom ski a few years ago?
Forum: General Discussion 08-27-2015, 02:35 PM
Replies: 5
Views: 332
Posted By 1990lmtd
Stay with the least aggressive method possible. ...

Stay with the least aggressive method possible. You will never get the ghosting out totally from under the decals. Hopefully the new decals will go right over the ghosting and you won't be able to...
Forum: Off Topic Discussion 08-27-2015, 02:24 PM
Replies: 14,719
Views: 4,239,921
Posted By 1990lmtd
Nice job!

Nice job!
Forum: Engine / Drive Train 08-27-2015, 01:38 PM
Replies: 8
Views: 243
Posted By 1990lmtd
I saw that, I meant, what lake?

I saw that, I meant, what lake?
Forum: Engine / Drive Train 08-27-2015, 01:23 PM
Replies: 8
Views: 243
Posted By 1990lmtd
Would you be able to check a ground reference on...

Would you be able to check a ground reference on that wire when it stalls? Say check the resistance to ground while engine off but running properly then do the same test after it stalls and won't...
Forum: Engine / Drive Train 08-26-2015, 05:16 AM
Replies: 3
Views: 332
Posted By 1990lmtd
Pheewww!

Pheewww!
Forum: Engine / Drive Train 08-24-2015, 11:46 PM
Replies: 13
Views: 410
Posted By 1990lmtd
I'm tired. Since the boat wasn't used in the...

I'm tired.
Since the boat wasn't used in the winter it was put up for storage but not filled with anti freeze. So my guess is that the manifolds being damp and full of air also helped accelerate the...
Forum: Engine / Drive Train 08-24-2015, 11:20 PM
Replies: 13
Views: 410
Posted By 1990lmtd
I have a feeling the manifolds were taxed because...

I have a feeling the manifolds were taxed because the boat was never winterized in Texas so therefore sat damp all winter and rotted prematurely. Just a guess though at this point.
Forum: Engine / Drive Train 08-24-2015, 11:17 PM
Replies: 13
Views: 410
Posted By 1990lmtd
Hydro lock upon start up, broken rod, hole in the...

Hydro lock upon start up, broken rod, hole in the side of the block. Done deal. Rear most piston on the starboard side.
Forum: Engine / Drive Train 08-24-2015, 03:33 PM
Replies: 13
Views: 410
Posted By 1990lmtd
My twenty year old fresh water use only manifolds...

My twenty year old fresh water use only manifolds failed and caused catastrophic damage. $600 is cheap insurance.
Forum: General / Other 08-24-2015, 09:06 AM
Replies: 5,906
Views: 602,804
Posted By 1990lmtd
While the tank is out it might be a good idea to...

While the tank is out it might be a good idea to remove, clean and grease the rudder shaft.
Forum: General Discussion 08-24-2015, 07:55 AM
Replies: 68
Views: 41,093
Posted By 1990lmtd
RIP Andy. So sad.

RIP Andy. So sad.
Forum: Off Topic Discussion 08-23-2015, 08:16 PM
Replies: 14,719
Views: 4,239,921
Posted By 1990lmtd
NOOOOOOO!!!

NOOOOOOO!!!
Forum: Audio/Stereo 08-23-2015, 08:35 AM
Replies: 90
Views: 5,965
Posted By 1990lmtd
As long as you have a long enough extension cord...

As long as you have a long enough extension cord to get out to the cove.
Forum: Audio/Stereo 08-23-2015, 08:34 AM
Replies: 90
Views: 5,965
Posted By 1990lmtd
Aric, you could always go Supra style on them.

Aric, you could always go Supra style on them.
Forum: General Discussion 08-23-2015, 07:23 AM
Replies: 7
Views: 496
Posted By 1990lmtd
That's the first time I've seen that. Lmao to...

That's the first time I've seen that. Lmao to bad the kids were in the room, had to lower the volume quick. Good thing wifeyou want standing there.
Forum: Restorations and Refurbishments 08-22-2015, 11:12 PM
Replies: 35
Views: 2,115
Posted By 1990lmtd
Crossing my fingers for you. Take some more...

Crossing my fingers for you. Take some more pictures of the installs along the way.
Forum: Restorations and Refurbishments 08-22-2015, 05:44 PM
Replies: 46
Views: 5,900
Posted By 1990lmtd
http://images.tapatalk-cdn.com/15/08/22/4bdf8556b9...

http://images.tapatalk-cdn.com/15/08/22/4bdf8556b9f2834db77f3435e3d538ca.jpg
Appears to be the same as far as I can tell. Hope this helps.
Forum: Restorations and Refurbishments 08-21-2015, 05:19 AM
Replies: 46
Views: 5,900
Posted By 1990lmtd
I will check it out next time I uncover her and...

I will check it out next time I uncover her and let you know. Thanks for the clarification.
Forum: For Sale: Boats 08-21-2015, 05:15 AM
Replies: 6
Views: 1,019
Posted By 1990lmtd
Love this boat. GLWS

Love this boat. GLWS
Forum: Off Topic Discussion 08-20-2015, 05:41 PM
Replies: 16
Views: 767
Posted By 1990lmtd
I still ski the f1 into 32 off at 34mph. Turns...

I still ski the f1 into 32 off at 34mph. Turns just as sharp at 34 as 36 but any slower is rough. The original vision bindings tend to tear up and need to be replaced if they are still on it. I love...
Showing results 1 to 25 of 319

 

All times are GMT -4. The time now is 09:29 PM.