Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 480
Search took 0.02 seconds.
Search: Posts Made By: bcd
Forum: General Discussion 10-20-2014, 05:05 PM
Replies: 20
Views: 722
Posted By bcd
I couldn't get mine off. Sent from my DROID RAZR...

I couldn't get mine off.

Sent from my DROID RAZR HD using Tapatalk
Forum: General Discussion 10-10-2014, 02:22 PM
Replies: 40
Views: 1,952
Posted By bcd
My 12 x2 didn't have tracking fins. My 14 x2...

My 12 x2 didn't have tracking fins. My 14 x2 does. They really make a difference turning when weighted down.

Sent from my DROID RAZR HD using Tapatalk
Forum: General Discussion 09-28-2014, 10:20 PM
Replies: 2
Views: 175
Posted By bcd
Do you hit the start button right after you turn...

Do you hit the start button right after you turn the key on? I've lost gps a couple of times when the start button gets hit right after turning the key. It must drop out during crank and miss the...
Forum: Trailers 09-19-2014, 10:40 AM
Replies: 590
Views: 56,732
Posted By bcd
Mine is leaving marks. They come off easily with...

Mine is leaving marks. They come off easily with goof off. The 2014 trailers need to be pretty deep to load and I think I went a little too deep one time and roughed up the ramp-n-clamp and now it...
Forum: General Discussion 09-12-2014, 09:26 AM
Replies: 60
Views: 4,226
Posted By bcd
For that price, I'd do it, but just buy 2 in case...

For that price, I'd do it, but just buy 2 in case it bends. If you know not to push down on it when it's up, it will be fine. The issue is when it's locked up and someone thinks it's a gas strut...
Forum: General Discussion 09-12-2014, 08:05 AM
Replies: 60
Views: 4,226
Posted By bcd
If you do get the hold open, I'd recommend...

If you do get the hold open, I'd recommend tracing a template of it. That way, if/when it gets bent, you can either bend it back or make a stronger/thicker replacement. I think the part cost me $50...
Forum: General Discussion 09-12-2014, 07:58 AM
Replies: 60
Views: 4,226
Posted By bcd
I think got rid of the metal hold open because it...

I think got rid of the metal hold open because it was flimsy. It took hardly any weight on them in the locked position to bend them. Once bent, they were very hard to bend back into position. My...
Forum: Off Topic Discussion 08-12-2014, 02:30 PM
Replies: 7
Views: 838
Posted By bcd
Okoboji is a big one towards the western part of...

Okoboji is a big one towards the western part of the state. I've never been there so can't comment much on it. I've heard of a lot of people vacationing there, so it must be decent.

Coralville...
Forum: Ballast 08-11-2014, 09:14 PM
Replies: 10
Views: 492
Posted By bcd
You can try taking it...

You can try taking it apart:
http://www.mastercraft.com/teamtalk/showthread.php?p=777034#post777034
Forum: General Discussion 08-05-2014, 03:44 PM
Replies: 3,452
Views: 428,484
Posted By bcd
It's a backwater slough off the mighty...

It's a backwater slough off the mighty Mississippi. She finally settled down for the summer and let us out the course in and dry out/clean up the club.

Sent from my DROID RAZR HD using Tapatalk
Forum: General Discussion 08-05-2014, 11:28 AM
Replies: 3,452
Views: 428,484
Posted By bcd
Sunday morning was a good ski...

Sunday morning was a good ski dayhttp://img.tapatalk.com/d/14/08/05/8ajyjase.jpg

Sent from my DROID RAZR HD using Tapatalk
Forum: Off Topic Discussion 08-03-2014, 07:33 AM
Replies: 20
Views: 915
Posted By bcd
With no kids? Sent from my DROID RAZR HD using...

With no kids?

Sent from my DROID RAZR HD using Tapatalk
Forum: General Discussion 07-27-2014, 08:38 PM
Replies: 4
Views: 544
Posted By bcd
You cannot clear the engine code without the...

You cannot clear the engine code without the diacom interface tool.

If the checklist on the overheat issue doesn't solve the problem, I wonder if installing an orificed vent line installed in the...
Forum: General Discussion 07-16-2014, 08:16 AM
Replies: 14
Views: 525
Posted By bcd
I lost my speedo once at start up. I went into...

I lost my speedo once at start up. I went into the diagnostic screen and it showed that it wasn't on the CAB bus. I cycled the key a couple of times and that didn't fix it. It took turning the...
Forum: Engine / Drive Train 07-15-2014, 07:57 AM
Replies: 4
Views: 286
Posted By bcd
boat requires more RPM's to go the same speed

My primary slalom tug is my friend's 94 Ski Nautique. We noticed last week that it started running warmer. It usually runs under 160, but it was going over 180 last week. Sunday we had it out, and...
Forum: General Discussion 07-14-2014, 06:37 PM
Replies: 15
Views: 522
Posted By bcd
I had issues with the crankshaft sensor. It's at...

I had issues with the crankshaft sensor. It's at the back of the engine (as it sits in the boat), so by the pulleys. It's down low, and if you get water on the boat, it can cause issues (at least...
Forum: General Discussion 07-12-2014, 07:54 AM
Replies: 71
Views: 5,797
Posted By bcd
Not sure what Swat did, but be careful about...

Not sure what Swat did, but be careful about bypassing the ballast system. The boat software system detects the current going to the ballast pump motors. If it doesn't see the motor load for the...
Forum: Ballast 07-11-2014, 07:21 AM
Replies: 17
Views: 955
Posted By bcd
Just make sure you never have full added bags...

Just make sure you never have full added bags sitting on an empty hard tank.

Sent from my DROID RAZR HD using Tapatalk
Forum: Trailers 07-10-2014, 10:50 AM
Replies: 27
Views: 975
Posted By bcd
I don't tow the trailer very far - 50 yards, so...

I don't tow the trailer very far - 50 yards, so it's normally not an issue. I have noticed on vacation at a different lake where I tow it a 1/2 mile that I have the same issue you're discussing. I...
Forum: General Discussion 07-09-2014, 07:47 PM
Replies: 71
Views: 5,797
Posted By bcd
Does it only overheat while the boat is idling,...

Does it only overheat while the boat is idling, or is it a different issue? I have heard some dealers have moved the location if the temp sensor. They claim an air pocket gets stuck at the seen...
Forum: Trailers 07-09-2014, 04:45 PM
Replies: 27
Views: 975
Posted By bcd
Trailer without the boat so I don't worry about...

Trailer without the boat so I don't worry about it

Sent from my DROID RAZR HD using Tapatalk
Forum: Trailers 07-09-2014, 04:44 PM
Replies: 27
Views: 975
Posted By bcd
They are hydraulic. Mine does the same thing. I...

They are hydraulic. Mine does the same thing. I don't tow the

Sent from my DROID RAZR HD using Tapatalk
Forum: General Discussion 07-06-2014, 04:51 PM
Replies: 1
Views: 235
Posted By bcd
Water coming out is normal. That's the dripless...

Water coming out is normal. That's the dripless shaft seal, which uses engine coolant water flow. With the engine off and boat out of the water, some of the engine coolant water continues to drain...
Forum: MasterCraft In Your Area 07-05-2014, 10:49 PM
Replies: 5
Views: 388
Posted By bcd
I saw this on...

I saw this on Wakeworld:
http://www.wakeworld.com/forum/showthread.php?t=802601
Forum: General Discussion 07-05-2014, 08:02 PM
Replies: 648
Views: 87,593
Posted By bcd
I'd say it's almost 10k high. There will be a...

I'd say it's almost 10k high. There will be a bump compared to a DD, but it's not a bad slalom boat. A little weight in the front helps. One of the best hulls ever. Epic wakeboard wake with extra...
Showing results 1 to 25 of 480

 

All times are GMT -4. The time now is 08:01 AM.