Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 42
Search took 0.01 seconds.
Search: Posts Made By: johny_Utah
Forum: General Discussion 06-08-2016, 09:19 AM
Replies: 6
Views: 305
Posted By johny_Utah
So mine toggles between time, engine hours, air...

So mine toggles between time, engine hours, air temp and depth but I don't see lake temp. Is there a setting to add lake temp?
Forum: General Discussion 06-07-2016, 07:42 PM
Replies: 6
Views: 305
Posted By johny_Utah
Another Newbie Question 07' X15

How do I toggle from Air Temp to Water Temp? Or does my boat only have Air Temp?

Thanks is advance!
Forum: General Discussion 06-05-2016, 07:53 PM
Replies: 5
Views: 214
Posted By johny_Utah
Thank you.... Didn't notice the calibration...

Thank you.... Didn't notice the calibration switch but all good now!
Forum: General Discussion 06-03-2016, 01:04 PM
Replies: 5
Views: 214
Posted By johny_Utah
07' X15 Speedo error

I don't think my boat goes 55 but the speedo says I do!!! Any ideas why the faulty reading?
Forum: General Discussion 04-30-2016, 01:17 PM
Replies: 7
Views: 938
Posted By johny_Utah
Ronix Wake Shaper on a X-15

Anyone have experience with this setup? Big improvement, worth the cost?
Forum: General Discussion 04-25-2016, 09:48 AM
Replies: 8
Views: 566
Posted By johny_Utah
Rear seat cushion blew out

Yesterday coming home from the lake my center rear seat cushion blew out of my X-15 anyone know where to buy a new one?
Forum: Engine / Drive Train 06-24-2008, 11:38 PM
Replies: 1
Views: 540
Posted By johny_Utah
Oil Leak from drain plug

I have a 351 with the drain conector with a hose to get the oil to drain out of the hole in the bildge. I am getting an oil drip from where the fitting goes into the pan. I am affraid to tighten it...
Forum: Electrical 06-17-2008, 11:53 PM
Replies: 9
Views: 907
Posted By johny_Utah
this says 86 but it should be the same

this says 86 but it should be the same
Forum: Electrical 05-26-2008, 06:30 PM
Replies: 11
Views: 1,359
Posted By johny_Utah
Not sure if this helps but had it so thought I...

Not sure if this helps but had it so thought I would share
Forum: Appearance 05-26-2008, 06:06 PM
Replies: 572
Views: 69,676
Posted By johny_Utah
I am ready as well

jeff@watchdogproperty.com

Thanks a ton!
Forum: Appearance 05-26-2008, 06:02 PM
Replies: 16
Views: 2,101
Posted By johny_Utah
That is why I had to wet sand my whole boat. It...

That is why I had to wet sand my whole boat. It was a pain in the A but like I said well worth it. If there is other minor scatches in your hull you can sand those out as well. I wish they sold the...
Forum: Trailers 05-21-2008, 10:49 PM
Replies: 31
Views: 5,135
Posted By johny_Utah
Home Depot

I just did mine and got the black carpet from Home Depot. I think it was around 4 dollars per foot.
Forum: General / Other 05-18-2008, 03:27 PM
Replies: 2
Views: 555
Posted By johny_Utah
Thank you!

Thank you!
Forum: Appearance 05-16-2008, 03:40 PM
Replies: 16
Views: 2,101
Posted By johny_Utah
Call Spectrum Color

It is a walk in the park. Your hull is probably Glacier White. They sell a paste that goes on like vasoline. I had a huge scratch and some dings and took on the project. Can't tell where the scatch...
Forum: General / Other 05-16-2008, 12:08 PM
Replies: 2
Views: 555
Posted By johny_Utah
New Tach 89 PS 190

I bought a new VDO tach for my 89 PS 190 351 and it does not register RPM. I made sure the settings on the back are set correctly but still no reading. The reason for the change is I did not trust my...
Forum: Trailers 04-22-2008, 10:38 PM
Replies: 5
Views: 742
Posted By johny_Utah
Here you go if you can get to Michigan

http://cgi.ebay.com/ebaymotors/Mastercraft-Boat-Trailer-parts_W0QQitemZ330230172822QQcmdZViewItem
Forum: General / Other 03-18-2008, 09:32 PM
Replies: 5
Views: 651
Posted By johny_Utah
Speedos found on ebay

Does anyone know what it takes to switch over from the original speedo in an 89' prostar 190 to this five point connector on ebay?

My speedos are faded and this would be a great upgrade if the cost...
Forum: Engine / Drive Train 03-04-2008, 07:58 PM
Replies: 5
Views: 522
Posted By johny_Utah
Replace Oil Pan

I have an oil leak that I thought was coming from the drain screw but it seems it is a bigger issue. Is there a manual to pull the motor? Disconecting the tranny and such. 89' prostar 351 indmar BW...
Forum: Engine / Drive Train 05-10-2007, 09:49 PM
Replies: 4
Views: 538
Posted By johny_Utah
Oil Leak

Any ideas where to start looking for an oil leak on a 89' prostar 190 351 indmar?

I seem to have some oil build up at the drain hole when the boat sits.

Thank you,

J
Forum: Engine / Drive Train 03-29-2007, 05:30 PM
Replies: 7
Views: 1,033
Posted By johny_Utah
Thermostat

What is the best degree thermostat to run? Also is this the same one that is in a car?
Forum: Engine / Drive Train 10-09-2006, 11:21 PM
Replies: 9
Views: 881
Posted By johny_Utah
I just replaced the heads in my 89 190. I got...

I just replaced the heads in my 89 190. I got them from First Mate Marine AKA Marshal Engines. They where 220 apiece. Here is the link

http://www.firstmatemarine.net/

J.
Forum: Engine / Drive Train 08-24-2006, 12:23 AM
Replies: 30
Views: 3,163
Posted By johny_Utah
Indmar VS. PCM

What is the difference between Indmar and PCM. I can't find a manual for an 89 indmar engine but I did for a PCM. Also when I order parts from Discount they have a PCM lable on them.

Here is the PCM...
Forum: Engine / Drive Train 08-18-2006, 11:32 AM
Replies: 4
Views: 1,161
Posted By johny_Utah
GT 40 Heads

I looked into it and Discount Inboard said they would not work with my older engine. Also they are 695 pr. At that price why not spend another 2k for a whole new motor. I actually thought about that...
Forum: Engine / Drive Train 08-18-2006, 12:54 AM
Replies: 4
Views: 1,161
Posted By johny_Utah
FYI Rebuilt Heads

Rebuilt heads on the way. I bought from First Mate. 220 pr. Not a bad price for fully rebuilt heads. I was quoted 85 for ones out of a junkyard and they would still need to be magna flowed and bench...
Forum: Engine / Drive Train 08-10-2006, 12:40 AM
Replies: 4
Views: 1,161
Posted By johny_Utah
Head Talk 89' prostar 190 Ford 351w

I now have water spraying from the head gasket! Could I need new heads too?

If I replace the gasket how will I know if I need new heads?

J
Showing results 1 to 25 of 42

 

All times are GMT -4. The time now is 07:29 PM.