Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Jeff d
Forum: General / Other 09-12-2015, 09:02 PM
Replies: 40
Views: 10,393
Posted By Jeff d
Never mind. Found it. 530920 "LATCH SUNDECK...

Never mind. Found it.

530920 "LATCH SUNDECK KEEPER PS 205V 99"

$3.29 here:
http://charlotteskiboats.com/shop/latch-sundeck-keeper-ps-205v-99/
Forum: General / Other 09-12-2015, 08:57 PM
Replies: 40
Views: 10,393
Posted By Jeff d
No, it doesn't come with the latch. I had to...

No, it doesn't come with the latch. I had to order the strap retainer/keeper from the master craft dealer. I think I posted the part number earlier in the thread but I'm on my phone right now and...
Forum: Electrical 07-21-2015, 09:06 PM
Replies: 46
Views: 8,740
Posted By Jeff d
I'm not sure on the paddle wheel. Does it...

I'm not sure on the paddle wheel. Does it currently go through the MDC? You'll have to get a paddle wheel compatible speedometer for sure since the ones included in most gauge sets are pitot pickup...
Forum: Electrical 07-20-2015, 10:33 PM
Replies: 46
Views: 8,740
Posted By Jeff d
It converts the standard variable resistance...

It converts the standard variable resistance signals from the senders to a proprietary electronic bus signal to be processed by proprietary gauges. You don't lose any functionality if you replace...
Forum: Electrical 07-16-2015, 09:07 AM
Replies: 46
Views: 8,740
Posted By Jeff d
Perfect pass has an hour meter and it can be...

Perfect pass has an hour meter and it can be synced up with actual hours. None of the tachs I've seen have provisions to roll them forward to match actual hours. Faria makes an identical tach to...
Forum: Electrical 06-19-2015, 09:00 AM
Replies: 46
Views: 8,740
Posted By Jeff d
The jury is still out on the fuel level sender. ...

The jury is still out on the fuel level sender. The oem centroid senders that MC have a terrible reputation to begin with. I'm pretty certain that a couple of years before I did the MDC-extomy I...
Forum: Engine / Drive Train 06-03-2015, 04:31 PM
Replies: 53
Views: 7,601
Posted By Jeff d
A. Very likely B. Yes C. Yes, like Rossterman...

A. Very likely
B. Yes
C. Yes, like Rossterman said the water from the pitot tube actually enters the MDC. If it freezes in there it cracks the chamber then water flows over the electronics inside. ...
Forum: Engine / Drive Train 05-27-2015, 11:26 AM
Replies: 53
Views: 7,601
Posted By Jeff d
It's all...

It's all here:
http://www.mastercraft.com/teamtalk/showthread.php?p=1052383#post1052383

It would likely be the same on an '03 but I can't say for sure. It might be a little rough if you've never...
Forum: Engine / Drive Train 05-27-2015, 10:28 AM
Replies: 53
Views: 7,601
Posted By Jeff d
Not possible. I think he just glossed over the...

Not possible. I think he just glossed over the fact that he swapped in analog gauges based on the level of quoting of my write-up.

Normal analog gauges, with the exception of the tach and volt...
Forum: Engine / Drive Train 05-26-2015, 11:05 PM
Replies: 53
Views: 7,601
Posted By Jeff d
Mine are all still working well after...

Mine are all still working well after de-winterization. With the analog fuel level gauge and sender the needle moves back and forth a bit when the boat rocks. I like that as it gives me more...
Forum: Electrical 05-18-2015, 02:46 PM
Replies: 46
Views: 8,740
Posted By Jeff d
Not really. It's a pain. You have to be good at...

Not really. It's a pain. You have to be good at working by feel only.
Forum: Electrical 02-02-2015, 10:05 PM
Replies: 46
Views: 8,740
Posted By Jeff d
Ok, I guess mine was bad then. Good to know it...

Ok, I guess mine was bad then. Good to know it will work with a standard gauge.
Forum: Electrical 02-02-2015, 10:00 AM
Replies: 46
Views: 8,740
Posted By Jeff d
I have it but I wouldn't bother with it as it was...

I have it but I wouldn't bother with it as it was one of the gauges that I had erratic behavior with.
Forum: Electrical 02-01-2015, 10:10 PM
Replies: 46
Views: 8,740
Posted By Jeff d
Did you use an OE 3 wire solid state sender or a...

Did you use an OE 3 wire solid state sender or a 2 wire mechanical sender?
Forum: Electrical 02-01-2015, 08:53 PM
Replies: 46
Views: 8,740
Posted By Jeff d
Noice! Did you have to replace the fuel level...

Noice! Did you have to replace the fuel level sender or did the original one work? I never definitely determined if my oe sender was bad or just non-standard/not compatible.
Forum: General Discussion 09-22-2014, 08:41 AM
Replies: 27
Views: 1,737
Posted By Jeff d
0% in Louisiana if the sale is between private...

0% in Louisiana if the sale is between private parties. You only pay tax on the trailer at the rate for your parish (what we call counties. Usually 8-9%). It's up to the buyer and seller to decide...
Forum: General Discussion 09-10-2014, 09:07 AM
Replies: 19
Views: 2,220
Posted By Jeff d
Often the throttle body and/or the spark arrestor...

Often the throttle body and/or the spark arrestor can make a high pitched noise at certain RPM. Mine does. Are you sure it's the transmission? On the LTR the air intake is like 16" from the...
Forum: General Discussion 09-09-2014, 09:40 AM
Replies: 5
Views: 1,247
Posted By Jeff d
I don't have a part number for the alternator...

I don't have a part number for the alternator bracket but I did have to replace mine due to a similar failure to yours. The local dealer was able to find one and it was $111 but that was over 3...
Forum: General Discussion 09-08-2014, 06:26 PM
Replies: 5
Views: 1,247
Posted By Jeff d
Make sure you have the supplemental bracket...

Make sure you have the supplemental bracket covered by Indmar Advisory #SA2001-1 which calls for the installation of the "495109 LTR Alternator Bracket Kit". I got this from the MC dealer and I...
Forum: General Discussion 09-06-2014, 12:50 PM
Replies: 11
Views: 2,391
Posted By Jeff d
If concerned about the durability of the plastic...

If concerned about the durability of the plastic Perko kit you can do what this guy did:
http://www.mastercraft.com/teamtalk/showthread.php?t=51590
Forum: General Discussion 09-01-2014, 03:08 PM
Replies: 24
Views: 3,532
Posted By Jeff d
I don't know. There are posts on wakeworld and...

I don't know. There are posts on wakeworld and planet nautique. The pictures I've seen the break occurred right between the prop and the strut.
Forum: General Discussion 09-01-2014, 02:50 PM
Replies: 24
Views: 3,532
Posted By Jeff d
I've seen a lot of reports of shafts snapping on...

I've seen a lot of reports of shafts snapping on the Nautique G series boats, allegedly with no impact.
Forum: General Discussion 08-31-2014, 06:06 PM
Replies: 12
Views: 872
Posted By Jeff d
I don't know much about this but don't some of...

I don't know much about this but don't some of the earlier throttle by wire boats need a MEFI flash update to work with perfect pass?
Forum: Trailers 08-31-2014, 06:03 PM
Replies: 9
Views: 1,549
Posted By Jeff d
I have these from MadDog and don't like them. ...

I have these from MadDog and don't like them. I'm pretty sure they were originally advertised as sunbrella but they definitely are not. They faded from black to a bit of a purple in one season...
Forum: General Discussion 08-29-2014, 08:34 PM
Replies: 5
Views: 384
Posted By Jeff d
Get the StarGazer (GPS) if nothing else for the...

Get the StarGazer (GPS) if nothing else for the easier install. If you get the non-stargazer then you have to cut a big honkin' hole in the bottom of the boat for the paddle wheel.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 07:13 PM.