Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 355
Search took 0.02 seconds.
Search: Posts Made By: ProStar Slalom
Forum: General Discussion 02-25-2015, 08:46 PM
Replies: 32
Views: 1,383
Posted By ProStar Slalom
Bastogne!

Bastogne!
Forum: General / Other 02-15-2015, 07:18 PM
Replies: 12
Views: 495
Posted By ProStar Slalom
Here's a picture of a new cable. I guess it does...

Here's a picture of a new cable. I guess it does slide through the tube; I can't remember. What I do remember is that when I bought the boat from PO the steering was terrible. I put in a new cable...
Forum: Electrical 02-13-2015, 07:41 PM
Replies: 22
Views: 2,489
Posted By ProStar Slalom
Follow-up. I thought I was good to go with OE...

Follow-up. I thought I was good to go with OE 3-wire, but not so much. I was getting a signal to the gauge but only a small needle movement. Not sure why it wouldn't work since it's supposed to...
Forum: Engine / Drive Train 02-10-2015, 09:56 PM
Replies: 5
Views: 383
Posted By ProStar Slalom
I'm not the original owner, but I don't think it...

I'm not the original owner, but I don't think it was ever messed with. You have to remove the rear seat back to even get to it. Not sure why there's a second filter, but I don't think the original...
Forum: General / Other 02-08-2015, 08:36 AM
Replies: 12
Views: 495
Posted By ProStar Slalom
If I recall correctly, that "support tube" will...

If I recall correctly, that "support tube" will come with the new cable...it's all one piece. You'll be good to go with a new cable. Attach some rope or string to the old cable as you pull it up to...
Forum: Electrical 02-02-2015, 09:17 PM
Replies: 22
Views: 2,489
Posted By ProStar Slalom
I found an OE 3-wire on Ebay. Didn't want to...

I found an OE 3-wire on Ebay. Didn't want to mess with changing the wiring back there. Not many of these left; next one will be mechanical I'm sure.
Forum: Engine / Drive Train 02-01-2015, 10:34 PM
Replies: 5
Views: 383
Posted By ProStar Slalom
Thanks, Jim; I'll give that a try. Yes, far more...

Thanks, Jim; I'll give that a try. Yes, far more complicated than the one between the fuel pump and the throttle body.
Forum: Electrical 02-01-2015, 09:01 PM
Replies: 22
Views: 2,489
Posted By ProStar Slalom
Jeff, my sender was bad as well. I assume the...

Jeff, my sender was bad as well. I assume the bad sender made for a bad signal to the fuel gauge...and for whatever reason was causing the voltage gauge to read bad as well. You can see on the...
Forum: Engine / Drive Train 02-01-2015, 08:49 PM
Replies: 5
Views: 383
Posted By ProStar Slalom
Remove in-line filter near tank?

2001 19Skier with 310 Predator. Boat has two fuel filters...one near fuel pump and another just outside the fuel tank. Probably a dumb question, but how do I remove the filter in the pictures...
Forum: Electrical 02-01-2015, 08:38 PM
Replies: 22
Views: 2,489
Posted By ProStar Slalom
We bought our '01 in 2007. In 2008 I had to...

We bought our '01 in 2007. In 2008 I had to replace the MDC box because I didn't know anything about "winterizing" it, and it was damaged by water from the speedo tubes. A couple of years later I...
Forum: General / Other 02-01-2015, 07:43 AM
Replies: 11
Views: 548
Posted By ProStar Slalom
Not sure about the best place to buy, but there...

Not sure about the best place to buy, but there are plenty out there and plenty of threads on here about biminis. I would recommend mounting it so that it will lie flat at the front edge of the...
Forum: Electrical 01-24-2015, 08:17 AM
Replies: 3
Views: 258
Posted By ProStar Slalom
Worth a look/try. I have not had a speedometer...

Worth a look/try. I have not had a speedometer out, but the smaller gauges were completely sealed if I recall correctly...might have to "break into" the back of the instrument to get to the guts.
Forum: Electrical 01-23-2015, 08:51 PM
Replies: 3
Views: 258
Posted By ProStar Slalom
Doesn't the '03 have Medallion gauges? If so,...

Doesn't the '03 have Medallion gauges? If so, the signal goes through the MDC (black box). I've never heard of being able to replace a stepper motor...more likely a MDC issue.
Forum: Electrical 01-13-2015, 08:27 PM
Replies: 6
Views: 2,119
Posted By ProStar Slalom
Ok, I'll install the transducer per the...

Ok, I'll install the transducer per the instructions and go with the accessory switch for power. Thanks to all for the help.
Forum: Electrical 01-12-2015, 09:02 PM
Replies: 6
Views: 2,119
Posted By ProStar Slalom
Threadjack here. I just purchased a Faria depth...

Threadjack here. I just purchased a Faria depth gauge which came with the same transducer described in the original post. I had not previously read this write-up, so was surprised by the complexity...
Forum: Engine / Drive Train 12-07-2014, 08:13 AM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
New plugs, wires, cap, and rotor...all is well. ...

New plugs, wires, cap, and rotor...all is well. I had one wet plug which had to be the source of the engine running rough. The rest of the plugs were fine, but after looking at the corrosion inside...
Forum: Engine / Drive Train 11-30-2014, 06:46 AM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Thanks again to all; I'll update after digging...

Thanks again to all; I'll update after digging into it a bit; probably next weekend.
Forum: Engine / Drive Train 11-29-2014, 09:54 AM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Thanks, Jim. Cap/rotor/wires from auto parts...

Thanks, Jim. Cap/rotor/wires from auto parts store as well? Faster than Ski DIM if I can get them locally.
Forum: Engine / Drive Train 11-28-2014, 07:17 PM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Thanks, Jim; great to see you chime in. What...

Thanks, Jim; great to see you chime in. What fuel pressure am I looking for? Check at idle and at RPM? Probably a dumb question, but can I use a tire pressure gauge? I assume I can get...
Forum: Engine / Drive Train 11-28-2014, 08:19 AM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Thanks, guys. I'll try going that route. I was...

Thanks, guys. I'll try going that route. I was thinking something fuel related, but you've both steered me toward spark; will give it a try.

Scott
Forum: Engine / Drive Train 11-27-2014, 08:27 PM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Thanks, Mike. I've changed the plugs, but it's...

Thanks, Mike. I've changed the plugs, but it's been a few years. Cap, rotor, and wires are probably original. I'll pull the plugs and take a look.
Forum: Engine / Drive Train 11-27-2014, 04:46 PM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
I haven't, but not sure what to check with them...

I haven't, but not sure what to check with them other than making sure all connections are good. I guess I could pull the plugs and see if one hasn't been firing?
Forum: Engine / Drive Train 11-27-2014, 03:21 PM
Replies: 17
Views: 1,041
Posted By ProStar Slalom
Help--TBI started running rough

2001 Predator 310hp TBI. It had been running fine all year. The last couple of times out it started running rough. After warming up, still slightly rough at idle, but when throttling up either...
Forum: General Discussion 10-07-2014, 10:26 PM
Replies: 9
Views: 749
Posted By ProStar Slalom
Wow...well over $100 for a Medallion fuel gauge. ...

Wow...well over $100 for a Medallion fuel gauge. Just reinforces the idea to tear out all of the Medallion junk and put in reliable gauges....winter project for me.
Forum: General Discussion 09-21-2014, 06:31 PM
Replies: 12
Views: 799
Posted By ProStar Slalom
Yes, you will want it as level as possible to...

Yes, you will want it as level as possible to drain out any water each time you raise the boat.
Showing results 1 to 25 of 355

 

All times are GMT -4. The time now is 01:06 PM.