Go Back   TeamTalk > Search Forums

Showing results 1 to 16 of 16
Search took 0.00 seconds.
Search: Posts Made By: phil_edgecumbe
Forum: General Discussion 07-24-2014, 06:03 AM
Replies: 14
Views: 1,213
Posted By phil_edgecumbe
I'm no expert however the "slalom" ropes I've...

I'm no expert however the "slalom" ropes I've bought are a lot thicker than a kneeboard rope or "easy-up with a big V for the front of the ski" rope. The slalom ropes have very little stretch.

This...
Forum: Tow Vehicles 07-14-2014, 11:20 PM
Replies: 27
Views: 1,237
Posted By phil_edgecumbe
I have the 2013 Land Rover Discovery 4 (LR4 in...

I have the 2013 Land Rover Discovery 4 (LR4 in the USA) (3 litre V6, sequential twin turbo diesel, 8 speed transmission, self leveling air suspension) which is the same platform as the RR.

I tow a...
Forum: Engine / Drive Train 06-15-2014, 05:09 AM
Replies: 11
Views: 485
Posted By phil_edgecumbe
If it's the same setup as the 1997 LT-1 then it's...

If it's the same setup as the 1997 LT-1 then it's a 6PK990 or K060400 or Indmar part# 72-5010

http://www.mastercraft.com/teamtalk/showthread.php?t=50176
Forum: General Discussion 05-22-2014, 08:33 AM
Replies: 13
Views: 535
Posted By phil_edgecumbe
Mines a 1997...

Mines a 1997...
Forum: General Discussion 05-22-2014, 12:53 AM
Replies: 13
Views: 535
Posted By phil_edgecumbe
I have a 1997 ProStar 205 so can give you some...

I have a 1997 ProStar 205 so can give you some feedback. Whilst it can carry 10 people and is very versatile for all forms of watersports, wakes are not it's strong point. The hull is designed for...
Forum: Upholstery 05-21-2014, 07:07 AM
Replies: 23
Views: 2,104
Posted By phil_edgecumbe
I had the same issue on my boat so I over...

I had the same issue on my boat so I over stitched it just to finish the season. The stitching just made the old and brittle vinyl crack and fall apart quicker. I ended up taking the boat to an...
Forum: Engine / Drive Train 04-23-2014, 06:52 PM
Replies: 24
Views: 798
Posted By phil_edgecumbe
I have a 97 Prostar with the same LT-1 engine. My...

I have a 97 Prostar with the same LT-1 engine. My raw water pump wobbles a bit at idle as well. I checked the alignment and the pump has a machined ridge that fits concentrically into the harmonic...
Forum: Engine / Drive Train 03-25-2014, 01:43 AM
Replies: 5
Views: 525
Posted By phil_edgecumbe
That's a great result. Well done...

That's a great result. Well done...
Forum: Engine / Drive Train 03-24-2014, 10:28 PM
Replies: 5
Views: 525
Posted By phil_edgecumbe
Check you wired the battery the correct way....

Check you wired the battery the correct way.
Just saying...The grey alternator wire melts on a 97 Prostar if you reverse the battery accidently.
Forum: Trailers 02-16-2014, 05:47 AM
Replies: 61
Views: 5,968
Posted By phil_edgecumbe
My pulsating brake problem solved!

Initial Problem:
Problem was the brakes would oscillate at about 1Hz. The harder the car braked the more violent the "machine gunning" was. If the brakes were applied gently then progressively harder...
Forum: General / Other 12-11-2013, 11:20 PM
Replies: 37
Views: 1,722
Posted By phil_edgecumbe
Just in case you are still unconvinced...Get the...

Just in case you are still unconvinced...Get the Heater!

I have both however have used the shower once. It gets you warm then 30 seconds later you are wet and cold!

The Heater gets used on most...
Forum: Engine / Drive Train 10-12-2013, 04:54 AM
Replies: 19
Views: 1,487
Posted By phil_edgecumbe
Update: Took the boat out for it's first run for...

Update:

Took the boat out for it's first run for the season.
I had the strut bushes replaced as they were a bit sloppy, prop checked/balanced and drive shaft alignment checked. The prop is the...
Forum: Engine / Drive Train 09-08-2013, 11:01 PM
Replies: 19
Views: 1,487
Posted By phil_edgecumbe
Thanks for the responses guys. I've decided to...

Thanks for the responses guys. I've decided to "just go ski" rather than obsess about how to make the boat go faster.

Winter lay-up causes us boat owners to ponder these sorts of things.

In...
Forum: Engine / Drive Train 09-08-2013, 05:09 AM
Replies: 19
Views: 1,487
Posted By phil_edgecumbe
I have a 1:1 transmission and the standard 4...

I have a 1:1 transmission and the standard 4 blade prop. I can't get the prop nut off to check it's dimensions.
Forum: Engine / Drive Train 09-06-2013, 08:46 PM
Replies: 19
Views: 1,487
Posted By phil_edgecumbe
LT-1 Power Upgrade Question

I have a 1997 PS205 with LT-1 EFI engine. Current top speed at WOT is 45mph at 4600rpm. The engine (650 hrs) and propeller are standard.

I'd like to get a little more top end power/speed for...
Forum: Engine / Drive Train 12-11-2012, 08:41 PM
Replies: 3
Views: 685
Posted By phil_edgecumbe
I have found an equivalent to the standard...

I have found an equivalent to the standard 72-5010 belt as no-one stocks them in Australia and USA online stores won't ship here. It's a Gates Micro-V belt with part number 6PK990 (6 rib, 990mm in...
Showing results 1 to 16 of 16

 

All times are GMT -4. The time now is 12:15 PM.