Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 77
Search took 0.01 seconds.
Search: Posts Made By: D. Newland
Forum: General Discussion 01-13-2017, 03:57 PM
Replies: 13
Views: 655
Posted By D. Newland
Full blast is OK because any excess pressure just...

Full blast is OK because any excess pressure just shoots out the water intake on the bottom of the hull. The motor will take whatever it needs when running.
Forum: General Discussion 01-12-2017, 04:43 PM
Replies: 13
Views: 655
Posted By D. Newland
Yes. I found the brass cap at Ace. HD didn't...

Yes. I found the brass cap at Ace. HD didn't have it for some reason. Just plastic ones.

It's not necessary, but if you get a male/female hose quick disconnect, it makes it a bit easier. ...
Forum: General Discussion 01-12-2017, 01:51 PM
Replies: 13
Views: 655
Posted By D. Newland
Oh boy, I need to work on the carpet.

Oh boy, I need to work on the carpet.
Forum: General Discussion 01-11-2017, 12:36 PM
Replies: 13
Views: 655
Posted By D. Newland
I'll post a pic tomorrow of my setup as I did...

I'll post a pic tomorrow of my setup as I did what Deb and her husband did to all of their boats as they helped me trouble-shoot a clogged trans cooler a while back.

Basically, I used Sch 40 PVC in...
Forum: Audio/Stereo 10-14-2016, 03:26 PM
Replies: 3
Views: 590
Posted By D. Newland
Thanks, guys. This is a pre-wired and built box...

Thanks, guys. This is a pre-wired and built box by Kicker and all the documentation shows it's 2 ohms. It may be worth putting an ohm meter on it just to make sure.

Yes-using a speaker to RCA...
Forum: Audio/Stereo 10-14-2016, 01:23 PM
Replies: 3
Views: 590
Posted By D. Newland
2 subwoofers smoked

Disclaimer-It's in my kids '06 Accord, but they do have a Liquid Force sticker on the back window.

Can you guys check my math/install here? 1st sub lasted about a month, 2nd about 2 weeks. ...
Forum: Ballast 07-27-2016, 12:57 PM
Replies: 18
Views: 1,286
Posted By D. Newland
Did Wakemakers recommend making 3 intakes for the...

Did Wakemakers recommend making 3 intakes for the 3 ballast pumps and ditching the intake manifold block?

They did to me, and I said "no way" at first, but I did it and it ended up being a simple...
Forum: Find A Pull / Give a Pull 07-21-2016, 01:55 PM
Replies: 20
Views: 2,496
Posted By D. Newland
If work is in Mesa, then IMO it's better to focus...

If work is in Mesa, then IMO it's better to focus on your drive-time to Saguaro and Canyon from any possible neighborhood you're researching. Pleasant and Bartlett Lakes could then be more of a...
Forum: Find A Pull / Give a Pull 07-20-2016, 02:05 PM
Replies: 20
Views: 2,496
Posted By D. Newland
Oh, and bring the boat. Plenty of lakes around...

Oh, and bring the boat. Plenty of lakes around here and Lake Powell is only 4 1/2 hour drive north.
Forum: Find A Pull / Give a Pull 07-20-2016, 02:04 PM
Replies: 20
Views: 2,496
Posted By D. Newland
What's your employers address/location? Lake...

What's your employers address/location?

Lake Pleasant has the most neighborhoods within (relatively) close proximity, but it's in the North/Northwest Valley. North Peoria, Anthem, Tramonto, Desert...
Forum: General Discussion 05-04-2016, 02:19 PM
Replies: 4
Views: 390
Posted By D. Newland
Medallion buzzer...

Medallion buzzer (http://www.mastercraft.com/teamtalk/showthread.php?t=69653)

Check this thread out. There are many other threads with great info on the Medallion issues.
Forum: General / Other 10-13-2015, 12:14 PM
Replies: 60
Views: 18,898
Posted By D. Newland
Not sure yet. I ski'd the boat @ 32 earlier in...

Not sure yet. I ski'd the boat @ 32 earlier in the season, but haven't done it since then. I'll see if I can get a couple shots next time out of the wake at that speed.
Forum: General / Other 10-12-2015, 01:45 PM
Replies: 60
Views: 18,898
Posted By D. Newland
2 outings now w/this and it's been doing...

2 outings now w/this and it's been doing everything it should. Hole shot now has zero bow rise, and takes much less throttle to get it up to speed. More ride attitude control while cruising. I'm...
Forum: Engine / Drive Train 10-01-2015, 05:42 PM
Replies: 20
Views: 2,335
Posted By D. Newland
Glad you got back to the dock! How many out...

Glad you got back to the dock!

How many out there have high water alarms? Very cheap and effective. I put one in because of the ballast bags and just 5200'd mine right under the engine and...
Forum: General / Other 09-28-2015, 03:33 PM
Replies: 60
Views: 18,898
Posted By D. Newland
That's correct. Lenco XDS 101 Short (shorty)...

That's correct.

Lenco XDS 101 Short (shorty) actuator. You also need to buy the top mount separately. Any local boat shop should have the mount.
Take-off wakeplate from a late model X-Star I found...
Forum: General / Other 09-28-2015, 02:17 PM
Replies: 60
Views: 18,898
Posted By D. Newland
I doubt there is a logic board in the switch, but...

I doubt there is a logic board in the switch, but it does require (and has) it's own +/- wiring, as well as a Deutsch connector for the actuator. I used a Lenco 14' Duetsch harness extension as...
Forum: General / Other 09-28-2015, 12:19 PM
Replies: 60
Views: 18,898
Posted By D. Newland
Installed. Turns out the Lenco Airboat single...

Installed. Turns out the Lenco Airboat single switch does not need any control box. Downside-no gauge and no auto retract. Upside-I got this done for approx. $700.

It takes 3 seconds for full...
Forum: General / Other 09-25-2015, 04:07 PM
Replies: 60
Views: 18,898
Posted By D. Newland
Thanks for posting that item. I did research it...

Thanks for posting that item. I did research it and the D does apparently mean Digital, so you need that dual keypad to work with the control box. I just couldn't find a good mounting location for...
Forum: General / Other 09-25-2015, 01:26 PM
Replies: 60
Views: 18,898
Posted By D. Newland
Well, the Lenco control box Prostar used is no...

Well, the Lenco control box Prostar used is no longer available new, and Lenco no longer has a unit that controls an analog gauge. I may have to go without a gauge. I think I'm OK with that.

I did...
Forum: Engine / Drive Train 09-25-2015, 12:30 PM
Replies: 4
Views: 757
Posted By D. Newland
That's an X30. By the large zinc on the rudder...

That's an X30. By the large zinc on the rudder and galvanized trailer, it's probably a salt-water boat. That may explain the possible engine replacement.

Have you seen it? That vintage of boat...
Forum: General / Other 09-21-2015, 12:29 PM
Replies: 60
Views: 18,898
Posted By D. Newland
I found a late model take-off wake plate from an...

I found a late model take-off wake plate from an X-Star on EBay. I clearance-cut the trailing edge as it needed a 9-degree bend on each side to flow with the transom. I fab'd a bending brake out of...
Forum: General / Other 09-21-2015, 12:25 PM
Replies: 60
Views: 18,898
Posted By D. Newland
I did more research this weekend about the trim...

I did more research this weekend about the trim gauge wiring and have most of it sorted. I think I just need to find out where the Lenco signal wire is located and tap into it.

Anyway, 1st item I...
Forum: General / Other 09-18-2015, 05:57 PM
Replies: 60
Views: 18,898
Posted By D. Newland
I'm currently tackling this project. Thanks for...

I'm currently tackling this project. Thanks for the thread! If you don't mind, I have a few pics of minor differences/changes that I'd like to post on this thread to keep info in 1 spot.

1...
Forum: Engine / Drive Train 09-11-2015, 12:51 PM
Replies: 40
Views: 5,500
Posted By D. Newland
I had a coil go bad. The only symptom was an...

I had a coil go bad. The only symptom was an engine backfire when I hit the throttle, then it had a hard time starting. Got to dock. Next time out, would not fire.

You Tube has a vid (actually...
Forum: General Discussion 09-04-2015, 04:52 PM
Replies: 278
Views: 46,044
Posted By D. Newland
Another old-school X30 with updated logo.

Another old-school X30 with updated logo.
Showing results 1 to 25 of 77

 

All times are GMT -4. The time now is 06:29 AM.