TeamTalk > Search Forums Search Results

User Name Remember Me? Password

Showing results 1 to 23 of 23 Search took 0.00 seconds. Search: Posts Made By: boatweight

Forum: General Discussion 09-29-2009, 05:02 PM

Replies: 4 Engin noise through speakers Views: 447 Posted By boatweight thanks for the help. I have noticed that if the... thanks for the help. I have noticed that if the engin is off but I turn the blower on the noise is even worse then the engine noise. I will start with isolating the amp and see what happens since...

Forum: General Discussion 09-28-2009, 11:47 AM

Replies: 4 Engin noise through speakers Views: 447 Posted By boatweight Engin noise through speakers You have to love it when your wife says "it would be nice if the music was louder", which means, go spend some money on a new amp and speakers for the boat. I installed my new amp and speakers using...

Forum: General Discussion 09-01-2009, 09:56 AM

Replies: 25 Transmission fluid leak Views: 3,483 Posted By boatweight I purchased all the needed parts from Engine Nut... I purchased all the needed parts from Engine Nut (Steve) give him a shout. The special nut was not cheap, around $230+. I heated the nut up just a bit, then used a punch to loosen the nut. Since...

Forum: General Discussion 07-08-2009, 02:25 PM

Replies: 25 Transmission fluid leak Views: 3,483 Posted By boatweight Wanted to thank 'Engine Nut' for the great post... Wanted to thank 'Engine Nut' for the great post above and the help purchasing the parts needed to replace my rear seal on my ZF/Hurth trans. The project from start to finish took about 3...

Forum: Engine / Drive Train 05-26-2009, 03:19 PM

Replies: 0 Hurth 450D socket? Views: 569 Posted By boatweight Hurth 450D socket? Does anyone know where I can purchase the special tool to remove the output flange nut on the ZF\Hurth transmission? I am working on replacing the rear seal as the leak is driving me crazy. Any...

Forum: Engine / Drive Train 05-20-2009, 10:02 AM

Replies: 5 Red stripe under engine cover, hmmm Views: 2,237 Posted By boatweight I will make sure that I have plenty of Red Stripe... I will make sure that I have plenty of Red Stripe on ice when I try and install the new rear seal. I think I will need it!

Forum: Engine / Drive Train 05-19-2009, 09:57 AM

Replies: 5 Red stripe under engine cover, hmmm Views: 2,237 Posted By boatweight Need to deal with the leak Well I finally pulled my boat out of storage and remembred that I still have a leak. I was able to confirm that the leak is happening at the seal, see picture, so from your thread I am assuming this...

Forum: Engine / Drive Train 10-02-2008, 04:38 PM

Replies: 5 Red stripe under engine cover, hmmm Views: 2,237 Posted By boatweight Good to know, I am going to try and tackle this... Good to know, I am going to try and tackle this project next Spring. Thanks for the help

Forum: Engine / Drive Train 10-01-2008, 01:19 PM

Replies: 5 Red stripe under engine cover, hmmm Views: 2,237 Posted By boatweight Red stripe under engine cover, hmmm Last weekend I was doing my year end prep to put my boat (1996 ps190 LT1) in storage, sad day but it's getting cold here in Idaho, and I noticed a red spray stripe on the inside of my engine cover. ...

Forum: Appearance 09-11-2008, 06:10 PM

Replies: 14 Cracked swim step bracket Views: 1,149 Posted By boatweight thanks for the info, sounds like welding is the... thanks for the info, sounds like welding is the way to go. Lee

Forum: Appearance 09-10-2008, 05:27 PM

Replies: 14 Cracked swim step bracket Views: 1,149 Posted By boatweight Cracked swim step bracket I noticed that one of my swim step brackets has a two inch vertical crack running from the inside top of the bracket. Seems to be holding fine but I would like to replace before somthing bad...

Forum: Upholstery 08-11-2008, 01:52 PM

Replies: 3 1996 prostar backseat question Views: 836 Posted By boatweight 1996 prostar backseat question The last owner had the back seat on my 96 prostar re-covered but it looks like they left the hardware off so the seat tends to slide out. There is hardware mounted on each side of the rails that the...

Forum: Appearance 08-07-2008, 01:54 PM

Replies: 8 How to Remove Paint from Gel Coat? Views: 859 Posted By boatweight I had a little scare this weekend. I tried... I had a little scare this weekend. I tried lacquer thinner on small section of the painted on hull numbers and it did a great job taking the paint off (the hull is white and the numbers are red) but...

Forum: Team Talk 08-01-2008, 10:22 AM

Replies: 15 Surfing section Views: 1,759 Posted By boatweight I agree as well I agree as well

Forum: General Discussion 07-29-2008, 11:22 AM

Replies: 44 Ran out of gas yesterday Views: 3,288 Posted By boatweight Not factor installed fuel filter After reading all of the great advice I pulled my gas tank out over the weekend and made a few discoveries. First, I noticed a fuel filter installed that was defiantly not factor and lead me to...

Forum: Electrical 07-29-2008, 10:48 AM

Replies: 8 Gas guage not showing correct level Views: 1,231 Posted By boatweight Pulled the tank and sending unit out this weekend... Pulled the tank and sending unit out this weekend and did a little adjustment, seems to have fixed my guage reading problems. Thanks for the help.

Forum: Appearance 07-18-2008, 11:54 AM

Replies: 8 How to Remove Paint from Gel Coat? Views: 859 Posted By boatweight Painted on hull numbers??? How about if the previous owner painted the registration ID numbers to the hull? I need to change numbers but can't seem to get the paint off the hull, any suggestions?

Forum: Electrical 07-17-2008, 04:25 PM

Replies: 8 Gas guage not showing correct level Views: 1,231 Posted By boatweight thanks GuitsBoy for the help. I am planning on... thanks GuitsBoy for the help. I am planning on making the adjustment this weekend. Lee

Forum: Electrical 07-16-2008, 02:22 PM

Replies: 8 Gas guage not showing correct level Views: 1,231 Posted By boatweight I was looking at the tank last night wondering if... I was looking at the tank last night wondering if I wanted to tackle the project, decided to wait until the weekend, looks like I will have to take off the fuel filler tube and vent line to remove...

Forum: Electrical 07-15-2008, 06:42 PM

Replies: 8 Gas guage not showing correct level Views: 1,231 Posted By boatweight thanks Jim, found the post. Now I need to pull... thanks Jim, found the post. Now I need to pull the fuel tank and see what happens next. Thanks again for the help. Lee

Forum: Electrical 07-15-2008, 12:38 PM

Replies: 8 Gas guage not showing correct level Views: 1,231 Posted By boatweight Gas guage not showing correct level I am trying to trouble shoot an issue with my gas guage or the level of the pump in my tank; ran out of gas this weekend but my tank is still 1/3 full and my guage reads 1/2 full. I recieved some...

Forum: General Discussion 07-15-2008, 10:16 AM

Replies: 44 Ran out of gas yesterday Views: 3,288 Posted By boatweight thanks Steve for the help, I will do a little... thanks Steve for the help, I will do a little research and see what I can find. Lee

Forum: General Discussion 07-14-2008, 06:22 PM

Replies: 44 Ran out of gas yesterday Views: 3,288 Posted By boatweight I too found a dual purpose for my ski rope this... I too found a dual purpose for my ski rope this weekend--pretty colored toe line. I bought a used 1996 prostar 190 LT1 last year and I vaguely remember the last owner saying something about "when...

Showing results 1 to 23 of 23