Go Back   TeamTalk > Search Forums

Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: travis351
Forum: Engine / Drive Train 05-11-2012, 06:23 PM
Replies: 23
Views: 3,326
Posted By travis351
Just to save anybody else the trouble, make sure...

Just to save anybody else the trouble, make sure to loosen up the nut on the smaller threads on the mounts about 1/4" then tap it in so you can separate the mount from the attaching block. Had to...
Forum: Engine / Drive Train 04-10-2012, 12:00 PM
Replies: 23
Views: 3,326
Posted By travis351
Engine mounts

New mounts are in...any sage advice? I'm hoping the mounts aren't seized up with the attaching blocks. Better hit it with PB blaster.
Forum: Engine / Drive Train 04-10-2012, 11:55 AM
Replies: 23
Views: 3,326
Posted By travis351
Update

Finally made some progress on my beloved "Beatercraft." Ended up sawing the old coupler off the broken shaft with a sawzall which was much easier than expected. Next, the strut bearings came out...
Forum: Engine / Drive Train 02-13-2012, 07:09 PM
Replies: 23
Views: 3,326
Posted By travis351
Attention has been diverted else ware for a...

Attention has been diverted else ware for a little bit. I'll post up when I get something done.
Forum: Engine / Drive Train 01-15-2012, 10:05 AM
Replies: 23
Views: 3,326
Posted By travis351
I probably could, I'm just a little concerned...

I probably could, I'm just a little concerned about the force required to pull both bearings out at once. I expected the strut to just fall once the screws were out. The bearings are actually in...
Forum: Engine / Drive Train 01-15-2012, 09:06 AM
Replies: 23
Views: 3,326
Posted By travis351
I'm having issues removing the strut to replace...

I'm having issues removing the strut to replace the bearings. It must be glued to the hull, appears to be silicone. Anybody have any experience removing a stuck strut?

I'm torn between leaving it...
Forum: Engine / Drive Train 12-21-2011, 12:22 PM
Replies: 23
Views: 3,326
Posted By travis351
Thanks for all the help guys. I found a prop on...

Thanks for all the help guys. I found a prop on Ski It Again for $125 and another on eBay for $50! SkiDim is sending shaft, strut bearings and a few other things I needed. 12% off using PEACE as...
Forum: Engine / Drive Train 11-29-2011, 12:23 AM
Replies: 23
Views: 3,326
Posted By travis351
Driveshafts

New member first post. Seems like a great forum here FAQ and history were very enlightening.

Anyway, my 83 MC Skier (Powerslot 1-1/8 shaft) has been parked for a while and I'm slowly bringing her...
Showing results 1 to 8 of 8

 

All times are GMT -4. The time now is 05:00 PM.