Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: bturner2
Forum: Electrical Today, 07:24 AM
Replies: 2
Views: 62
Posted By bturner2
The best place to start with electrical problems...

The best place to start with electrical problems is with a good cleaning and a "nut and bolt" on every connector in the system. It doesn't matter which direction go or where you start as long as...
Forum: General Discussion Today, 06:52 AM
Replies: 4
Views: 243
Posted By bturner2
Yeah I lived with mine for about 6 years like...

Yeah I lived with mine for about 6 years like that. Used lots of grease which only would work for a week or two. I put the new seal in but it really didn't do anything. Waiting to see the full...
Forum: General Discussion 05-20-2018, 07:16 PM
Replies: 4
Views: 243
Posted By bturner2
Depending on the rudder box you have the fix may...

Depending on the rudder box you have the fix may differ. I have an 07 which doesn't use o rings but instead uses a seal at the top of the rudder box. Mine unfortunately was never greased from the...
Forum: For Sale: Parts & Accessories 05-20-2018, 01:13 PM
Replies: 9
Views: 198
Posted By bturner2
Agreed. The first time I saw this type BS was...

Agreed. The first time I saw this type BS was when I worked at a car dealership many years ago. Guy came in with a year old car that honestly looked 10. Dents on every panel, road rash on every wheel...
Forum: Team Talk Forum Help- Forum Issues Only 05-20-2018, 08:38 AM
Replies: 5
Views: 150
Posted By bturner2
The deep state is blocking you. Too many non...

The deep state is blocking you. Too many non liberal non green inspired ideas to let into to your country...... :D
Forum: General Discussion 05-20-2018, 08:36 AM
Replies: 52
Views: 5,060
Posted By bturner2
If you go have a designated driver, take a boat...

If you go have a designated driver, take a boat you can bang around and be prepared for all that hanging with a bunch of drunk people can bring to the table. Can be a ton of fun but it does draw...
Forum: For Sale: Parts & Accessories 05-20-2018, 08:29 AM
Replies: 9
Views: 198
Posted By bturner2
Yeah that's a project. Too bad, poor boat....

Yeah that's a project. Too bad, poor boat.

Unless you're in an area with good, cheap interior shops bringing it back to life while not losing money on the deal is difficult. 3 - 5 on the interior...
Forum: Trailers 05-19-2018, 01:37 PM
Replies: 7
Views: 175
Posted By bturner2
Yeah that's what I was eluding to in my post. I...

Yeah that's what I was eluding to in my post. I worked on a 97 trailer last year the was real bad. After 2 days of soaking with penetrating oil and pounding with a drift I was able get the pin to...
Forum: Trailers 05-18-2018, 06:05 PM
Replies: 7
Views: 175
Posted By bturner2
Yeah that'll do it. So these actually come apart...

Yeah that'll do it. So these actually come apart pretty easy however the wild card on yours is going to be disconnecting and connecting the hydraulic line to the system.

Assuming you're going to...
Forum: General Discussion 05-18-2018, 07:34 AM
Replies: 10
Views: 334
Posted By bturner2
I'd agree with the above. That boat should do 45...

I'd agree with the above. That boat should do 45 without undue effort or complaint. This is a 2015 so I'm thinking this is/was a used boat correct? If so I'm thinking prop or alignment. It doesn't...
Forum: Trailers 05-17-2018, 12:36 PM
Replies: 7
Views: 175
Posted By bturner2
Hard to tell based on the information you've...

Hard to tell based on the information you've provided.

Is this a MasterCraft trailer?
Does it have a swinging tongue?
Single or Dual axle?
Are you sure it's a UFP actuator?
If so are there any...
Forum: General Discussion 05-16-2018, 07:47 AM
Replies: 52
Views: 5,060
Posted By bturner2
Depends on where, when and the conditions at the...

Depends on where, when and the conditions at the time on how boat-able it will be for your (our) type boat.

Lake St. Claire on a good weekday when no one is on it is outstanding. Very scenic,...
Forum: General / Other 05-16-2018, 07:15 AM
Replies: 14
Views: 540
Posted By bturner2
Yeah, you've got more problems than the bearings....

Yeah, you've got more problems than the bearings. If the water is that high (based on the picture) then the actuator is probably underwater as well and if it's for a month you can count on all kinds...
Forum: Electrical 05-15-2018, 11:53 AM
Replies: 6
Views: 144
Posted By bturner2
If all the others are then I'd suspect the gauge....

If all the others are then I'd suspect the gauge. You used to be able check a gauge with with meter or by shorting the sender leads.....

https://www.youtube.com/watch?v=Zm8E-_yNSK8

Before going to...
Forum: Electrical 05-15-2018, 08:55 AM
Replies: 6
Views: 144
Posted By bturner2
If the water is above 50 degrees the engine...

If the water is above 50 degrees the engine should have no problems getting up to operating temp unless the thermostat is stuck open. Battery nor impeller will effect the boat not coming up to temp....
Forum: General Discussion 05-14-2018, 01:40 PM
Replies: 60
Views: 5,614
Posted By bturner2
The more material you have the tougher it gets. A...

The more material you have the tougher it gets. A buddy of mine bought an over the tower cover and it's a monster to handle alone. That being said the first fitting is always the hardest. Once you...
Forum: Engine / Drive Train 05-14-2018, 01:33 PM
Replies: 11
Views: 551
Posted By bturner2
Yikes. I've heard this same story many times...

Yikes. I've heard this same story many times before and sorry to hear it again. Well at least you'll have a winterization story to tell others who say they don't need to winterize their boat. Best of...
Forum: Electrical 05-14-2018, 01:27 PM
Replies: 6
Views: 144
Posted By bturner2
Are all the other gauges working correctly? Any...

Are all the other gauges working correctly? Any other symptoms? Do all the gauge needles shake on the pin when the system boots up?

Can't tell where you're located since you're a guest but up here...
Forum: Trailers 05-12-2018, 07:52 AM
Replies: 6
Views: 393
Posted By bturner2
You'd have to check with your state DMV but I...

You'd have to check with your state DMV but I know there was a time when trailers rated under a certain weight were not required to have brakes. No idea when or what the weight was but I do recall a...
Forum: General / Other 05-11-2018, 12:15 PM
Replies: 10
Views: 289
Posted By bturner2
Did this this occur after winter start up or did...

Did this this occur after winter start up or did it happen after working correctly with no changes to power/battery connections? Your PD will be different with each.

If after winter start up, get...
Forum: For Sale: Boats 05-11-2018, 08:08 AM
Replies: 41
Views: 2,662
Posted By bturner2
Has this boat ever been a salt water boat? Based...

Has this boat ever been a salt water boat? Based on the area I could see how your prices are depressed from up here. That boat in Michigan in very good condition is $35K, sell it this weekend kind of...
Forum: General / Other 05-11-2018, 08:01 AM
Replies: 10
Views: 289
Posted By bturner2
My guess would be that someone put Perfect Pass...

My guess would be that someone put Perfect Pass on the boat which would take the place of one (the primary) of the speedos. That would leave you with the secondary one. My suggestion would be to...
Forum: For Sale: Boats 05-10-2018, 01:11 PM
Replies: 41
Views: 2,662
Posted By bturner2
Opps, sorry I saw some pictures from VP46. His...

Opps, sorry I saw some pictures from VP46. His location says CA.
Forum: For Sale: Boats 05-10-2018, 08:30 AM
Replies: 41
Views: 2,662
Posted By bturner2
I agree with the comment about $30K scarring...

I agree with the comment about $30K scarring people away if it's as nice as it looks in the pictures. 1000 hours is the magic number but I'd put a number on the boat that matches condition and...
Forum: For Sale: Boats 05-09-2018, 07:41 AM
Replies: 15,091
Views: 3,426,782
Posted By bturner2
Here's one for $8500 with a lift and a ton of...

Here's one for $8500 with a lift and a ton of work already done to it.....

https://flint.craigslist.org/boa/d/1988-mastercraft/6564434858.html
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 11:29 PM.


2018