Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 1.84 seconds.
Search: Posts Made By: Spork
Forum: Electrical 09-10-2016, 09:48 AM
Replies: 6
Views: 221
Posted By Spork
Very close to...

Very close to OE
http://m.ebay.com/itm/85mm-auto-gauge-0-6000-rpm-Tachometer-for-marine-yacht-Black-Face-/231989593688?nav=SEARCH
Forum: Electrical 09-09-2016, 11:15 PM
Replies: 6
Views: 221
Posted By Spork
Then yes the tachometer is likely the cause. I...

Then yes the tachometer is likely the cause. I doubt it's a ground issue as all the gauges share the same Daisy chain ground.
Forum: Electrical 09-09-2016, 11:04 PM
Replies: 6
Views: 221
Posted By Spork
Distributor advance springs are likely letting...

Distributor advance springs are likely letting the distributor advance the ignition timing causing the idle to go up. Replacement springs are available. Start with checking the ignition timing.
Forum: Electrical 09-09-2016, 09:47 AM
Replies: 10
Views: 440
Posted By Spork
Yes there is a separate small circuit board for...

Yes there is a separate small circuit board for the audible alarms that is not part of the gauges.
Forum: Electrical 09-06-2016, 07:16 PM
Replies: 10
Views: 440
Posted By Spork
If you need a gauge let me know I have one. Found...

If you need a gauge let me know I have one.
Found this line. So the Temp sender can not be 33-240 ohm type.

The temperature sender is faulty if the resistance measures 0 ohms when the engine is...
Forum: Electrical 09-05-2016, 09:59 PM
Replies: 10
Views: 440
Posted By Spork
No adjustment on the gauge. IIRC sender should be...

No adjustment on the gauge. IIRC sender should be a 33-240 ohm type. But also the specific temperature reading the original vdo gauge was 100-220. I suspect you may have a 250 sender. Did you use...
Forum: General Discussion 08-24-2016, 07:18 PM
Replies: 22
Views: 1,392
Posted By Spork
Guy on facebook just recently shows pictures of...

Guy on facebook just recently shows pictures of one of these jump boats restored.
Forum: General / Other 08-22-2016, 04:34 PM
Replies: 5
Views: 232
Posted By Spork
just remove and replace that piece of floorboard....

just remove and replace that piece of floorboard. remove seats etc. to access, likely have to use a bottle jack to slide piece out from under the dash supports.
Forum: Underwater Running Gear 08-20-2016, 01:07 PM
Replies: 20
Views: 1,262
Posted By Spork
I had a propeller cause a pull to the right on my...

I had a propeller cause a pull to the right on my direct drive boat. Visibly the propeller looked fine, no marks or dings and had proper rpm's and mph at WOT. I swapped the oem 3 blade for a new CNC...
Forum: For Sale: Boats 07-01-2016, 12:53 PM
Replies: 18
Views: 3,464
Posted By Spork
351W Indmar V8 670 Hours

351W Indmar V8
670 Hours
Forum: General Discussion 06-25-2016, 06:46 PM
Replies: 10
Views: 454
Posted By Spork
your 2001 prostar needs rpm input to run the hour...

your 2001 prostar needs rpm input to run the hour meter that's nestled in the tachometer.

These older boats do not use rpm input to start the hour meter.

Like Miss Rita said this era boat has a...
Forum: Underwater Running Gear 06-25-2016, 09:25 AM
Replies: 10
Views: 631
Posted By Spork
TS190 with about 350hp and the added weight of a...

TS190 with about 350hp and the added weight of a tower and audio.
Forum: Find A Pull / Give a Pull 06-22-2016, 02:27 PM
Replies: 6
Views: 365
Posted By Spork
Depending on what size boat you get Lake Conroe...

Depending on what size boat you get Lake Conroe could be a good or bad lake. 22fter + your mostly good anything smaller and you'll wish you had a larger boat, Lake Conroe is a bathtub especially in...
Forum: General Discussion 06-22-2016, 10:34 AM
Replies: 36
Views: 3,390
Posted By Spork
yep, I put mine away and is kept in the MC...

yep, I put mine away and is kept in the MC binder.

this is my daily use key float
Forum: Underwater Running Gear 06-22-2016, 10:10 AM
Replies: 10
Views: 631
Posted By Spork
Definitely keep as a spare, my experience; I used...

Definitely keep as a spare, my experience; I used an OJ 13x14 on my 1:1 when I was demoing a few props and the engine was lugged and felt like a dog on hole-shot. I would not recommend to keep it on...
Forum: Electrical 06-21-2016, 08:17 PM
Replies: 3
Views: 212
Posted By Spork
You can buy resistors from radio shack to splice...

You can buy resistors from radio shack to splice connector to engine ground. Put a mechanical oil psi gauge to verify actual oil psi reading.
Forum: Electrical 06-21-2016, 07:53 PM
Replies: 3
Views: 212
Posted By Spork
If you have an 80 psi gauge then you need an...

If you have an 80 psi gauge then you need an 80psi sender.



Technical Reference Manual



Oil Pressure System- Inboard & Stern Drive
To test the gauge, voltage from "I" to "G" terminal must be...
Forum: Electrical 06-17-2016, 06:54 PM
Replies: 8
Views: 525
Posted By Spork
A few years ago I had a pretty good voltage drop...

A few years ago I had a pretty good voltage drop of ~1.5 v. The culprit a small amount of corrosion in the engine harness cannon plug that feeds up to the helm near starboard side of engine aft of...
Forum: Engine / Drive Train 06-16-2016, 09:50 AM
Replies: 3
Views: 214
Posted By Spork
Will be relatively easy to achieve 310+hp. ...

Will be relatively easy to achieve 310+hp.

There are much better cylinder heads than ford oem gt-40 heads.

if your on a budget I would use GT-40P cylinder heads off a 5.0 explorer, use a weiand...
Forum: General Discussion 06-15-2016, 10:32 PM
Replies: 36
Views: 3,390
Posted By Spork
My contribution...

My contribution...
Forum: Engine / Drive Train 06-15-2016, 04:47 PM
Replies: 31
Views: 6,133
Posted By Spork
might have corrosion or paint covering the...

might have corrosion or paint covering the marks...
Forum: Electrical 06-13-2016, 04:41 PM
Replies: 10
Views: 762
Posted By Spork
behind the ignition coil mounted to the engine...

behind the ignition coil mounted to the engine itself
145130
it'll look similar to this
145128
145129
Forum: General Discussion 06-06-2016, 06:38 PM
Replies: 28
Views: 1,869
Posted By Spork
DD is correct trailer is for a 1999 maristar 210

DD is correct trailer is for a 1999 maristar 210
Forum: Audio/Stereo 05-23-2016, 10:50 AM
Replies: 11
Views: 999
Posted By Spork
Thanks for the update.

Thanks for the update.
Forum: Electrical 05-03-2016, 09:58 PM
Replies: 7
Views: 964
Posted By Spork
This should get you in the ballpark...

This should get you in the ballpark...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 01:21 AM.