Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: blackhawk
Forum: Wakesurfing 05-28-2015, 10:36 PM
Replies: 6
Views: 203
Posted By blackhawk
How many hard tanks does that model have and...

How many hard tanks does that model have and where are they located? As Scott said, you will need more ballast.
Forum: Upholstery 05-27-2015, 11:16 PM
Replies: 17
Views: 725
Posted By blackhawk
I wouldn't hesitate to try the magic erasers. ...

I wouldn't hesitate to try the magic erasers. They worked miracles for me on my old boat. Never saw any damage whatsoever to the vinyl after using them.
Forum: For Sale: Parts & Accessories 05-26-2015, 10:51 PM
Replies: 6
Views: 298
Posted By blackhawk
inboardonline.com is another place that I use...

inboardonline.com is another place that I use often
Forum: General Discussion 05-26-2015, 10:39 PM
Replies: 23
Views: 1,430
Posted By blackhawk
I would not trust that thing. I could see...

I would not trust that thing. I could see running the trolling motor, then the remote freaks out. Your boat ends up crashing or out by itself in the middle of the lake.
Forum: General Discussion 05-26-2015, 10:33 PM
Replies: 19
Views: 432
Posted By blackhawk
I buy quite a few things from inboardonline. ...

I buy quite a few things from inboardonline. They have been good to deal with. Call them up and ask if they have any discounts going. They will usually give you 10% off.
Forum: General Discussion 05-26-2015, 10:30 PM
Replies: 33
Views: 2,047
Posted By blackhawk
How about just take the prop off? Bring along a...

How about just take the prop off? Bring along a long snorkel for putting it back on underwater.
Forum: Ballast 05-22-2015, 09:45 PM
Replies: 3
Views: 247
Posted By blackhawk
Try a heat gun instead of the hair dryer.

Try a heat gun instead of the hair dryer.
Forum: Trailers 05-21-2015, 09:55 PM
Replies: 14
Views: 681
Posted By blackhawk
I bought new boards just for the sake of not...

I bought new boards just for the sake of not spending the time to take off the old carpet and pulling out all those staples. I measured my bolt pattern and had the boards wrapped and ready to put...
Forum: Restorations and Refurbishments 05-19-2015, 03:49 PM
Replies: 10
Views: 654
Posted By blackhawk
What is this stuff made out of? The website...

What is this stuff made out of? The website gives pretty limited info.
Forum: Engine / Drive Train 05-18-2015, 11:10 PM
Replies: 6
Views: 166
Posted By blackhawk
Does it have the Delco EST ignition?

Does it have the Delco EST ignition?
Forum: Upholstery 05-17-2015, 11:17 PM
Replies: 7
Views: 672
Posted By blackhawk
Good info here!

Good info here!
Forum: General Discussion 05-17-2015, 10:43 PM
Replies: 11
Views: 356
Posted By blackhawk
I would bet there is a hose clamp loose somewhere...

I would bet there is a hose clamp loose somewhere on the engine. I had this exact thing happen to me. I pulled the hose to the transmission cooler to do my routine check for any debris. I stuck...
Forum: For Sale: Parts & Accessories 05-15-2015, 11:25 PM
Replies: 6
Views: 238
Posted By blackhawk
How old are they?

How old are they?
Forum: Wanted to Buy 05-14-2015, 11:35 PM
Replies: 5
Views: 243
Posted By blackhawk
An Inland Surfer Tako would serve both you and...

An Inland Surfer Tako would serve both you and your wife fine. You can find a new on sale for around $350.
Forum: Towers 05-14-2015, 11:31 PM
Replies: 7
Views: 418
Posted By blackhawk
I third the Pledge.

I third the Pledge.
Forum: General Discussion 05-12-2015, 10:45 PM
Replies: 6
Views: 309
Posted By blackhawk
I always inspect mine every Winter. If I start...

I always inspect mine every Winter. If I start seeing a well defined flat spot on the end of the vanes, I replace.
Forum: General Discussion 05-12-2015, 10:37 PM
Replies: 16
Views: 460
Posted By blackhawk
Without a pic, it is hard to know exactly what...

Without a pic, it is hard to know exactly what you need done. But, I doubt a water jet is necessary. Any machine shop could do it on a standard milling machine. Most likely, you could do this with...
Forum: General Discussion 05-11-2015, 12:08 AM
Replies: 12
Views: 458
Posted By blackhawk
I think that yellow stuff is just where the water...

I think that yellow stuff is just where the water has passed through the foam of the cushion. The water just soaks up any dirt and foam dyes and comes out yellow/orange looking with a sticky...
Forum: Audio/Stereo 05-07-2015, 11:34 PM
Replies: 4
Views: 388
Posted By blackhawk
Have you researched from Ebay? Sometimes these...

Have you researched from Ebay? Sometimes these pop up on there.
Forum: General Discussion 05-05-2015, 03:44 PM
Replies: 19
Views: 1,222
Posted By blackhawk
After seeing this thread resurrected, I started...

After seeing this thread resurrected, I started 2nd guessing that .040" gap on the AC 41-101 plugs that I mentioned before. I had sent an email to Indmar about spark plugs last year and that is what...
Forum: Trailers 05-03-2015, 11:31 PM
Replies: 31
Views: 1,802
Posted By blackhawk
Would you be willing to part with the reservoir...

Would you be willing to part with the reservoir cap from the old Reliable unit? Mine is kind of chewed up on the hex and the diaphragm is caved in.
Forum: General Discussion 05-03-2015, 11:19 PM
Replies: 85
Views: 3,352
Posted By blackhawk
Disconnect your lanyard and just give the starter...

Disconnect your lanyard and just give the starter a very slight bump to turn the crank. Or you could turn the engine over by hand. I wouldn't think that it would get stuck on the crankshaft, but it...
Forum: General Discussion 05-03-2015, 11:14 PM
Replies: 65
Views: 3,018
Posted By blackhawk
After checking all the hoses for blockage, you...

After checking all the hoses for blockage, you could run it out of the water using the bucket method. That would make it easy to see if you are pulling water through the engine and out the exhaust.
Forum: Appearance 05-02-2015, 11:08 PM
Replies: 18
Views: 1,119
Posted By blackhawk
I agree with MikeG, that it is repairable. It...

I agree with MikeG, that it is repairable. It will definitely take some patience to get it right though.
Forum: Appearance 05-01-2015, 11:28 PM
Replies: 10
Views: 862
Posted By blackhawk
3M Finesse-it II

3M Finesse-it II
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 06:55 AM.