Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: CantRepeat
Forum: General Discussion Today, 07:54 AM
Replies: 6
Views: 154
Posted By CantRepeat
Maybe this will...

Maybe this will help.

http://www.hindecoder.com/index.php?q=MASTERCRAFT-BOAT-COMPANY-HIN-Decoder
Forum: Electrical Today, 07:43 AM
Replies: 3
Views: 85
Posted By CantRepeat
Well, you have an issue with the wiring on the...

Well, you have an issue with the wiring on the ignition you replaced. I would bet it is a ground wire.

I've only seen this happen one time. It was caused by the ground wire/cable on the second,...
Forum: Engine / Drive Train Today, 06:52 AM
Replies: 4
Views: 108
Posted By CantRepeat
Thanks. I'm gonna pull the trigger on the Gen 3 2...

Thanks. I'm gonna pull the trigger on the Gen 3 2 bank. Now I just need to find a place to mount it.
Forum: Electrical Today, 06:49 AM
Replies: 3
Views: 85
Posted By CantRepeat
Dual batteries? Did you leave the main ground...

Dual batteries? Did you leave the main ground wire off the battery that runs up to the buss bar?
Forum: Engine / Drive Train Yesterday, 07:25 PM
Replies: 21
Views: 346
Posted By CantRepeat
The only problem with the sensor wire being...

The only problem with the sensor wire being grounded is that when you remove it from the sensor it goes to zero. If it was broken and grounding some where then it should stay at full tilt when you...
Forum: Ballast Yesterday, 07:22 PM
Replies: 5
Views: 166
Posted By CantRepeat
You can't just "disconnect" the timers. If you...

You can't just "disconnect" the timers. If you did then they wouldn't run at all. Go look at that thread I posted. You have 2 choices and both include removing the timers and replacing them with...
Forum: Team Talk Forum Help- Forum Issues Only Yesterday, 04:42 PM
Replies: 3
Views: 103
Posted By CantRepeat
No problem. If you still have trouble locating it...

No problem. If you still have trouble locating it you can always get under the boat and look the inlets. Just look for the big brass cover with a bunch of round holes in it. Get an idea where it is...
Forum: General Discussion Yesterday, 03:06 PM
Replies: 12
Views: 301
Posted By CantRepeat
Driver side front. We were heading up to the lake...

Driver side front. We were heading up to the lake for a 2 week stay.

http://www.mikesell.net/images/boat/tireblow.jpg

The road we were on wasn't all that bad and had a nice big shoulder to pull off...
Forum: General Discussion Yesterday, 12:29 PM
Replies: 12
Views: 301
Posted By CantRepeat
There's two types of people when it comes to...

There's two types of people when it comes to tires and boat trailers.

Those that have had a blowout and those that will have a blowout.
Forum: Engine / Drive Train Yesterday, 12:23 PM
Replies: 21
Views: 346
Posted By CantRepeat
Rotello Triple -...

Rotello Triple - http://www.walmart.com/ip/Shell-Rotella-T-15W40-Motor-Oil-1-Gal/14958327

Wix makes good filters, likewise, Purolator pureone are very good.
Forum: General Discussion Yesterday, 12:20 PM
Replies: 12
Views: 301
Posted By CantRepeat
Possibly: You were putting on the brakes after...

Possibly: You were putting on the brakes after the tire blew and the cords slapping around pinch the brake line?
Forum: Off Topic Discussion Yesterday, 12:16 PM
Replies: 47
Views: 9,099
Posted By CantRepeat
Now that is nice porn right there.

Now that is nice porn right there.
Forum: Engine / Drive Train Yesterday, 12:13 PM
Replies: 21
Views: 346
Posted By CantRepeat
Well, I would change the oil and the filter and...

Well, I would change the oil and the filter and use a known good filter. This still doesn't mean it's not the gauge going south.

You could pick up a dirt cheap stand alone mechanical gauge and test...
Forum: Ballast Yesterday, 11:43 AM
Replies: 21
Views: 752
Posted By CantRepeat
Are you weighting both port and starboard at the...

Are you weighting both port and starboard at the same time?
Forum: Team Talk Forum Help- Forum Issues Only Yesterday, 11:33 AM
Replies: 3
Views: 103
Posted By CantRepeat
There should be one large inlet with a valve on...

There should be one large inlet with a valve on the port side of the engine on inside of the hull. It will be near the oil pan.

Looks like this.
Forum: Engine / Drive Train Yesterday, 11:31 AM
Replies: 21
Views: 346
Posted By CantRepeat
What makes you think you would have a blockage?...

What makes you think you would have a blockage?

What could and how could something get past the oil pump pick up that would be small enough to get through the screen but large enough to clog a main...
Forum: Engine / Drive Train Yesterday, 10:42 AM
Replies: 21
Views: 346
Posted By CantRepeat
Well, from what I know and have read the only way...

Well, from what I know and have read the only way to test the gauge is by putting a resistor on it. What the resistor does is act like the sensor but you are taking the sensor and wiring out of the...
Forum: Engine / Drive Train Yesterday, 10:40 AM
Replies: 4
Views: 108
Posted By CantRepeat
Prosport onboard battery charges.

Anyone use a Prosport onboard battery charger?

The Promariner 43012 has 12 amp 2 bank and an AGM battery setting. Everything I've read about Optima AGM batteries says they don't like trickle...
Forum: Engine / Drive Train Yesterday, 09:17 AM
Replies: 21
Views: 346
Posted By CantRepeat
With the key on and engine off what happens when...

With the key on and engine off what happens when you pull the sensor wire off at the engine?
Forum: Engine / Drive Train Yesterday, 08:24 AM
Replies: 21
Views: 346
Posted By CantRepeat
Sounds like you have a bad gauge. If it was a...

Sounds like you have a bad gauge. If it was a short in the sense wire the gauge would stay pegged when you removed the wire from the sensor. What happens if you take the sense wire and ground to...
Forum: General Discussion Yesterday, 07:42 AM
Replies: 13
Views: 623
Posted By CantRepeat
I think, for most people, it seems a little less...

I think, for most people, it seems a little less creepy when it some cool quad rotor buzzing around and not some old grey beard standing on the back of the boat with a telephoto lens. lol :D
Forum: Ballast Yesterday, 07:33 AM
Replies: 5
Views: 166
Posted By CantRepeat
Yes, there are 3 things you can do about crappy...

Yes, there are 3 things you can do about crappy timer logic. If you don't mind sending them to the states to get reprogrammed that is probably the best way.

Second post in this...
Forum: General Discussion 07-20-2014, 09:58 PM
Replies: 6
Views: 192
Posted By CantRepeat
Fastenal.com

Fastenal.com
Forum: Find A Pull / Give a Pull 07-20-2014, 05:24 PM
Replies: 1
Views: 69
Posted By CantRepeat
I was stationed there 90-92 and the season is...

I was stationed there 90-92 and the season is really short! I'm from So-Cal so cold water and I don't get along. There is a ramp over on North Fort so if no one shows up here he might just go over...
Forum: Electrical 07-20-2014, 05:10 PM
Replies: 3
Views: 97
Posted By CantRepeat
Yeah, I'm pretty sure the paddle wheel runs the...

Yeah, I'm pretty sure the paddle wheel runs the speedo.

I'm pretty sure you will have a paddle wheel that does speed and temp, but you should have a separate transducer. I know there are a lot of...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 11:03 AM.