Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 478
Search took 0.03 seconds.
Search: Posts Made By: blackhawk
Forum: Ballast 03-27-2015, 10:08 PM
Replies: 21
Views: 560
Posted By blackhawk
I have never had a Johnson pump apart, so I don't...

I have never had a Johnson pump apart, so I don't know if it uses the same bearings as the Jabsco. The newer Jabsco pumps don't even use bearings. They just have bronze sleeves.
Forum: Ballast 03-26-2015, 10:55 PM
Replies: 21
Views: 560
Posted By blackhawk
I can still get you some bearings if you need...

I can still get you some bearings if you need them.

If you replace the lip seal in the pump head every couple of years, that will keep water out of the motor. In my boat, I can't turn the rear...
Forum: Ballast 03-25-2015, 11:56 PM
Replies: 21
Views: 560
Posted By blackhawk
You can rebuild the Jabsco pumps and replace the...

You can rebuild the Jabsco pumps and replace the bearings, seals, and brushes. The bearings or brushes would be the only place noise would come from, most likely it is the bearings.

The Jabsco and...
Forum: Appearance 03-25-2015, 11:47 PM
Replies: 14
Views: 553
Posted By blackhawk
I wouldn't do it.

I wouldn't do it.
Forum: General Discussion 03-25-2015, 11:38 PM
Replies: 30
Views: 804
Posted By blackhawk
I bought my 2006 X15 in September 2013 for $42K...

I bought my 2006 X15 in September 2013 for $42K with 190 hours. I would think that $40K and under would be a good deal for your. I am on the East Coast, so California prices could be higher.
Forum: Engine / Drive Train 03-24-2015, 10:49 PM
Replies: 32
Views: 1,159
Posted By blackhawk
Get a punch and sharpen it on a grinder to a fine...

Get a punch and sharpen it on a grinder to a fine point. Then use that with a hammer and tap the outside of the broken bolt to try and unscrew it. This is my goto method on broken bolts. It...
Forum: General Discussion 03-19-2015, 09:11 PM
Replies: 63
Views: 2,640
Posted By blackhawk
Explain how non-synthetic oil would cause a...

Explain how non-synthetic oil would cause a bearing to spin?
Forum: Off Topic Discussion 03-13-2015, 10:43 PM
Replies: 18
Views: 765
Posted By blackhawk
I would go with the darker accents and also...

I would go with the darker accents and also darken the brick a little.
Forum: Electrical 03-04-2015, 09:32 PM
Replies: 28
Views: 1,064
Posted By blackhawk
Mike - That is a good link for cables, thanks.

Mike - That is a good link for cables, thanks.
Forum: General Discussion 03-01-2015, 08:11 PM
Replies: 8
Views: 424
Posted By blackhawk
I agree with the others. Go with the XL.

I agree with the others. Go with the XL.
Forum: Tow Vehicles 02-26-2015, 09:34 PM
Replies: 36
Views: 1,449
Posted By blackhawk
I have a CNC router with my side business. I cut...

I have a CNC router with my side business. I cut out these hitch covers for the local high school. The material is called Colorcore but is the same as Starboard, both are made by King Plastics. ...
Forum: Off Topic Discussion 02-26-2015, 01:24 PM
Replies: 39
Views: 1,575
Posted By blackhawk
If you are running a new electrical service to...

If you are running a new electrical service to the building from the pole, go ahead and put in a 200 amp service. I did that on my detached garage. It only costs $200 or $300 extra and you will...
Forum: What is this boat worth? 02-25-2015, 09:56 PM
Replies: 24
Views: 1,006
Posted By blackhawk
I have a 2006 X15. For surfing, I run all stock...

I have a 2006 X15. For surfing, I run all stock ballast full, IBS up front until the cup holders pop-up. I then have 900s in the rear lockers. I only fill the 900 just on the side that I am...
Forum: General Discussion 02-25-2015, 09:41 PM
Replies: 5
Views: 406
Posted By blackhawk
Where are the Hokies?

Where are the Hokies?
Forum: General Discussion 02-20-2015, 08:31 PM
Replies: 42
Views: 2,021
Posted By blackhawk
Roman - There is no need to pull the thermostat. ...

Roman - There is no need to pull the thermostat. You can back fill the engine block via the large hose that runs between the thermostat housing and engine water pump. Pull the hose off at the...
Forum: Wakesurfing 02-18-2015, 09:04 PM
Replies: 22
Views: 802
Posted By blackhawk
Inland Surfer Tako has been a great beginner...

Inland Surfer Tako has been a great beginner board for us. I am 6'2" 190 lbs for reference. No problem riding ropeless.
Forum: Off Topic Discussion 02-15-2015, 11:14 PM
Replies: 15
Views: 676
Posted By blackhawk
Just to report back. I bought the Leatherique...

Just to report back. I bought the Leatherique kit that VP46 posted a picture of. I tried it out this weekend and it got maybe 10% of the denim stain out. The directions say that it works best to...
Forum: Appearance 02-09-2015, 10:34 PM
Replies: 23
Views: 1,557
Posted By blackhawk
I use the DEWALT DWP849X. It is a horse, works...

I use the DEWALT DWP849X. It is a horse, works great.
Forum: Off Topic Discussion 02-05-2015, 01:46 PM
Replies: 15
Views: 676
Posted By blackhawk
VP46 - Thanks for the product suggestions. I...

VP46 - Thanks for the product suggestions. I think that I will try the Adam's first and see how that goes.

Aric - I did try the magic eraser lightly in one small spot before I posted. ...
Forum: Off Topic Discussion 02-04-2015, 10:26 PM
Replies: 15
Views: 676
Posted By blackhawk
denim dye stains in leather upholstery

I have a 2014 Durango that is my wife's daily driver. We just bought it in July. It has gotten a denim dye transfer stain on the back of the seat. The seats are a light tan. Does anyone know of...
Forum: Engine / Drive Train 02-03-2015, 11:06 PM
Replies: 5
Views: 338
Posted By blackhawk
It doesn't matter which way you flow the...

It doesn't matter which way you flow the antifreeze through the heater. The heater performs the same and winterizes the same regardless of the flow direction. I just take off both hoses at the...
Forum: General Discussion 02-03-2015, 10:57 PM
Replies: 17
Views: 1,188
Posted By blackhawk
When they are open tomorrow, just do an online...

When they are open tomorrow, just do an online chat and ask them for the TeamTalk discount code.
Forum: Engine / Drive Train 02-01-2015, 11:19 PM
Replies: 9
Views: 569
Posted By blackhawk
I vote #3 also. If you don't do it right, you...

I vote #3 also. If you don't do it right, you will always have that in the back of your mind.
Forum: Electrical 01-26-2015, 10:02 AM
Replies: 7
Views: 538
Posted By blackhawk
Not sure if your bilge is similar to mine (2006...

Not sure if your bilge is similar to mine (2006 X15), but check under the gas tank. I have had stuff roll up under there out of sight. A long pick-up magnet is your friend.
Forum: Ballast 01-19-2015, 11:31 PM
Replies: 6
Views: 680
Posted By blackhawk
It is supposed to shut off the pump if it is run...

It is supposed to shut off the pump if it is run dry. I am guessing that it is sensing the current draw to know once the pump is no longer moving any water.
Showing results 1 to 25 of 478

 

All times are GMT -4. The time now is 05:56 AM.