Go Back   TeamTalk > Search Forums

Showing results 1 to 23 of 23
Search took 0.00 seconds.
Search: Posts Made By: boatweight
Forum: General Discussion 09-29-2009, 05:02 PM
Replies: 4
Views: 499
Posted By boatweight
thanks for the help. I have noticed that if the...

thanks for the help. I have noticed that if the engin is off but I turn the blower on the noise is even worse then the engine noise. I will start with isolating the amp and see what happens since...
Forum: General Discussion 09-28-2009, 11:47 AM
Replies: 4
Views: 499
Posted By boatweight
Question Engin noise through speakers

You have to love it when your wife says "it would be nice if the music was louder", which means, go spend some money on a new amp and speakers for the boat. I installed my new amp and speakers using...
Forum: General Discussion 09-01-2009, 09:56 AM
Replies: 25
Views: 3,994
Posted By boatweight
I purchased all the needed parts from Engine Nut...

I purchased all the needed parts from Engine Nut (Steve) give him a shout. The special nut was not cheap, around $230+. I heated the nut up just a bit, then used a punch to loosen the nut. Since...
Forum: General Discussion 07-08-2009, 02:25 PM
Replies: 25
Views: 3,994
Posted By boatweight
Wanted to thank 'Engine Nut' for the great post...

Wanted to thank 'Engine Nut' for the great post above and the help purchasing the parts needed to replace my rear seal on my ZF/Hurth trans. The project from start to finish took about 3...
Forum: Engine / Drive Train 05-26-2009, 03:19 PM
Replies: 0
Views: 683
Posted By boatweight
Unhappy Hurth 450D socket?

Does anyone know where I can purchase the special tool to remove the output flange nut on the ZF\Hurth transmission? I am working on replacing the rear seal as the leak is driving me crazy. Any...
Forum: Engine / Drive Train 05-20-2009, 10:02 AM
Replies: 5
Views: 2,583
Posted By boatweight
I will make sure that I have plenty of Red Stripe...

I will make sure that I have plenty of Red Stripe on ice when I try and install the new rear seal. I think I will need it!
Forum: Engine / Drive Train 05-19-2009, 09:57 AM
Replies: 5
Views: 2,583
Posted By boatweight
Need to deal with the leak

Well I finally pulled my boat out of storage and remembred that I still have a leak. I was able to confirm that the leak is happening at the seal, see picture, so from your thread I am assuming this...
Forum: Engine / Drive Train 10-02-2008, 04:38 PM
Replies: 5
Views: 2,583
Posted By boatweight
Good to know, I am going to try and tackle this...

Good to know, I am going to try and tackle this project next Spring. Thanks for the help
Forum: Engine / Drive Train 10-01-2008, 01:19 PM
Replies: 5
Views: 2,583
Posted By boatweight
Question Red stripe under engine cover, hmmm

Last weekend I was doing my year end prep to put my boat (1996 ps190 LT1) in storage, sad day but it's getting cold here in Idaho, and I noticed a red spray stripe on the inside of my engine cover. ...
Forum: Appearance 09-11-2008, 06:10 PM
Replies: 14
Views: 1,234
Posted By boatweight
thanks for the info, sounds like welding is the...

thanks for the info, sounds like welding is the way to go. Lee
Forum: Appearance 09-10-2008, 05:27 PM
Replies: 14
Views: 1,234
Posted By boatweight
Cracked swim step bracket

I noticed that one of my swim step brackets has a two inch vertical crack running from the inside top of the bracket. Seems to be holding fine but I would like to replace before somthing bad...
Forum: Upholstery 08-11-2008, 01:52 PM
Replies: 3
Views: 980
Posted By boatweight
1996 prostar backseat question

The last owner had the back seat on my 96 prostar re-covered but it looks like they left the hardware off so the seat tends to slide out. There is hardware mounted on each side of the rails that the...
Forum: Appearance 08-07-2008, 01:54 PM
Replies: 8
Views: 1,190
Posted By boatweight
I had a little scare this weekend. I tried...

I had a little scare this weekend. I tried lacquer thinner on small section of the painted on hull numbers and it did a great job taking the paint off (the hull is white and the numbers are red) but...
Forum: Team Talk 08-01-2008, 10:22 AM
Replies: 15
Views: 1,879
Posted By boatweight
I agree as well

I agree as well
Forum: General Discussion 07-29-2008, 11:22 AM
Replies: 44
Views: 3,592
Posted By boatweight
Smile Not factor installed fuel filter

After reading all of the great advice I pulled my gas tank out over the weekend and made a few discoveries. First, I noticed a fuel filter installed that was defiantly not factor and lead me to...
Forum: Electrical 07-29-2008, 10:48 AM
Replies: 8
Views: 1,342
Posted By boatweight
Pulled the tank and sending unit out this weekend...

Pulled the tank and sending unit out this weekend and did a little adjustment, seems to have fixed my guage reading problems. Thanks for the help.
Forum: Appearance 07-18-2008, 11:54 AM
Replies: 8
Views: 1,190
Posted By boatweight
Painted on hull numbers???

How about if the previous owner painted the registration ID numbers to the hull? I need to change numbers but can't seem to get the paint off the hull, any suggestions?
Forum: Electrical 07-17-2008, 04:25 PM
Replies: 8
Views: 1,342
Posted By boatweight
thanks GuitsBoy for the help. I am planning on...

thanks GuitsBoy for the help. I am planning on making the adjustment this weekend. Lee
Forum: Electrical 07-16-2008, 02:22 PM
Replies: 8
Views: 1,342
Posted By boatweight
I was looking at the tank last night wondering if...

I was looking at the tank last night wondering if I wanted to tackle the project, decided to wait until the weekend, looks like I will have to take off the fuel filler tube and vent line to remove...
Forum: Electrical 07-15-2008, 06:42 PM
Replies: 8
Views: 1,342
Posted By boatweight
thanks Jim, found the post. Now I need to pull...

thanks Jim, found the post. Now I need to pull the fuel tank and see what happens next. Thanks again for the help. Lee
Forum: Electrical 07-15-2008, 12:38 PM
Replies: 8
Views: 1,342
Posted By boatweight
Question Gas guage not showing correct level

I am trying to trouble shoot an issue with my gas guage or the level of the pump in my tank; ran out of gas this weekend but my tank is still 1/3 full and my guage reads 1/2 full. I recieved some...
Forum: General Discussion 07-15-2008, 10:16 AM
Replies: 44
Views: 3,592
Posted By boatweight
thanks Steve for the help, I will do a little...

thanks Steve for the help, I will do a little research and see what I can find. Lee
Forum: General Discussion 07-14-2008, 06:22 PM
Replies: 44
Views: 3,592
Posted By boatweight
I too found a dual purpose for my ski rope this...

I too found a dual purpose for my ski rope this weekend--pretty colored toe line. I bought a used 1996 prostar 190 LT1 last year and I vaguely remember the last owner saying something about "when...
Showing results 1 to 23 of 23

 

All times are GMT -4. The time now is 05:39 PM.