Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: Table Rocker
Forum: Engine / Drive Train 09-05-2018, 09:57 AM
Replies: 10
Views: 306
Posted By Table Rocker
It does, on the back of the fuel rail.

It does, on the back of the fuel rail.
Forum: Engine / Drive Train 09-04-2018, 11:55 PM
Replies: 10
Views: 306
Posted By Table Rocker
There is a Schraeder valve on the back of the...

There is a Schraeder valve on the back of the fuel rail where the gauge attaches. If you can test at a variety of RPMs on the water, your results will tell you the most. 4,000 RPM on the water...
Forum: General Discussion 09-04-2018, 09:14 AM
Replies: 72
Views: 3,281
Posted By Table Rocker
The answer to your original question depends...

The answer to your original question depends entirely on the relationship that exists between the owner and the "friend." With this post, it is pretty clear you feel your friend is using you. You...
Forum: Engine / Drive Train 09-03-2018, 09:33 PM
Replies: 10
Views: 306
Posted By Table Rocker
Check your fuel pressure before throwing a new...

Check your fuel pressure before throwing a new fuel pump at it. You can buy the tool or borrow one from an auto parts store. Then you will know you need a new fuel pump.
Forum: General Discussion 09-01-2018, 02:52 PM
Replies: 19
Views: 1,402
Posted By Table Rocker
Eric @ OJ will be able to shed some light on the...

Eric @ OJ will be able to shed some light on the cavitation burn as well. I had cavitation burn and he was a big help.
Forum: General Discussion 08-31-2018, 10:34 AM
Replies: 11
Views: 410
Posted By Table Rocker
Try letting it sit for a few seconds with the key...

Try letting it sit for a few seconds with the key on before attempting a start.
Forum: Engine / Drive Train 08-30-2018, 09:08 AM
Replies: 16
Views: 394
Posted By Table Rocker
It sounds like you could have a vacuum leak.

It sounds like you could have a vacuum leak.
Forum: Engine / Drive Train 08-29-2018, 10:08 PM
Replies: 16
Views: 394
Posted By Table Rocker
It's not the vent then.

It's not the vent then.
Forum: Engine / Drive Train 08-29-2018, 07:22 PM
Replies: 16
Views: 394
Posted By Table Rocker
Have you checked your fuel tank vent? If it is...

Have you checked your fuel tank vent? If it is blocked, the tank will pull a vacuum and starve for fuel. As it sits, air will creep in and it will run fine for a while, starting the process over.
Forum: General Discussion 08-29-2018, 04:10 PM
Replies: 12
Views: 585
Posted By Table Rocker
I am not sure what route you are taking to get...

I am not sure what route you are taking to get there, but I like I-40 & I-49 over I-44 & 412, especially when pulling a trailer. No stops, no tolls and better scenery. Compare the routes and see if...
Forum: Off Topic Discussion 08-29-2018, 10:44 AM
Replies: 35
Views: 2,091
Posted By Table Rocker
I doubt there is any way it could have ridden on...

I doubt there is any way it could have ridden on that stern drive. I think it swam up and decided to take a break there.
Forum: General Discussion 08-29-2018, 10:29 AM
Replies: 19
Views: 1,402
Posted By Table Rocker
I suspect boats loaded for surfing are likely to...

I suspect boats loaded for surfing are likely to see cavitation burn with almost any prop.
Forum: General Discussion 08-28-2018, 01:13 PM
Replies: 19
Views: 1,402
Posted By Table Rocker
That is cavitation burn. Is it on both sides?

That is cavitation burn. Is it on both sides?
Forum: Engine / Drive Train 08-24-2018, 11:59 AM
Replies: 24
Views: 832
Posted By Table Rocker
Transmission neutral sensor? Do you get 12v on...

Transmission neutral sensor? Do you get 12v on the yellow wire with red stripe at your starter when you turn the key to start?

Nevermind, after re-reading I see where it tries to crank.
Forum: General Discussion 08-23-2018, 10:25 PM
Replies: 57
Views: 1,664
Posted By Table Rocker
The bypass isn't a necessity, I was just...

The bypass isn't a necessity, I was just explaining what was in the diagram.
Forum: General Discussion 08-23-2018, 10:13 PM
Replies: 57
Views: 1,664
Posted By Table Rocker
This diagram shows the ballast resistor starting...

This diagram shows the ballast resistor starting bypass wire. The I terminal on the solenoid is hot when cranking only and sends full voltage to the coil.
Forum: General Discussion 08-23-2018, 09:10 PM
Replies: 57
Views: 1,664
Posted By Table Rocker
You can run a jumper from the I terminal of the...

You can run a jumper from the I terminal of the solenoid to the coil post on the ballast resistor. This sends full voltage to the coil during starting.
Forum: Engine / Drive Train 08-22-2018, 10:23 AM
Replies: 50
Views: 1,774
Posted By Table Rocker
You are correct, in my mind I had you standing in...

You are correct, in my mind I had you standing in front of your engine. Sorry to add my confusion.
Forum: Engine / Drive Train 08-21-2018, 06:55 PM
Replies: 50
Views: 1,774
Posted By Table Rocker
If a temp sensor isn't in water/coolant, it will...

If a temp sensor isn't in water/coolant, it will not give accurate readings. That is likely what happened here regarding the reasonable temps displayed on the gauge during the event.

Since I think...
Forum: Engine / Drive Train 08-19-2018, 07:48 PM
Replies: 3
Views: 130
Posted By Table Rocker
I would suspect you have an alignment problem. ...

I would suspect you have an alignment problem. Have you checked the engine alignment?
Forum: General Discussion 08-06-2018, 06:49 PM
Replies: 26
Views: 779
Posted By Table Rocker
That is correct. I just did a Google image...

That is correct. I just did a Google image search for a 350 distributor and borrowed that pic from Jegs. It is an automotive distributor with vacuum advance.

I am just trying to connect "I...
Forum: General Discussion 08-06-2018, 06:38 PM
Replies: 26
Views: 779
Posted By Table Rocker
Yes, I agree.

Yes, I agree.
Forum: Electrical 08-06-2018, 05:25 PM
Replies: 13
Views: 310
Posted By Table Rocker
AutoZone didn't have the "right connections?" ...

AutoZone didn't have the "right connections?" Didn't have the right employees is more honest. The right connections for that alternator are two alligator clips.

If one of your terminals is...
Forum: General Discussion 08-06-2018, 05:19 PM
Replies: 26
Views: 779
Posted By Table Rocker
That is a good point, the bottom end of that...

That is a good point, the bottom end of that setup does not turn freely. I guess that is why the clamp and bolt are fairly substantial.
Forum: Electrical 08-06-2018, 02:20 PM
Replies: 13
Views: 310
Posted By Table Rocker
The purple wire is the "exciter" wire. It gets...

The purple wire is the "exciter" wire. It gets voltage from the key switch "on" circuit and tells the alternator when to do its thing. Where did you have the alternator rebuilt? They will be able...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 12:18 AM.


2018