Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 480
Search took 0.06 seconds.
Search: Posts Made By: soacj
Forum: Storage / Winterization Yesterday, 10:35 AM
Replies: 8
Views: 330
Posted By soacj
I've had a similar issue and did not hesitate for...

I've had a similar issue and did not hesitate for one second to use the old gasket with nary a drip...
Forum: General Discussion 09-30-2014, 12:26 PM
Replies: 15
Views: 793
Posted By soacj
I don't even bother with trying to pour the...

I don't even bother with trying to pour the ventless cans. We keep a few of these...
Forum: Tow Vehicles 09-22-2014, 12:47 PM
Replies: 30
Views: 990
Posted By soacj
Bet the OP's going for a particular...

Bet the OP's going for a particular aesthetic!:D

http://image.truckinweb.com/f/8102825%2Bw750%2Bst0/0202_01zoom%2B1999_chevrolet_astro_van%2Bfront_side_view.jpg
Forum: General Discussion 09-09-2014, 12:45 PM
Replies: 1,000
Views: 270,996
Posted By soacj
Talk about the trailer being too deep;)

Talk about the trailer being too deep;)
Forum: Tow Vehicles 09-09-2014, 11:59 AM
Replies: 11
Views: 547
Posted By soacj
Watching this thread--my '07 (5.9/6 speed) is at...

Watching this thread--my '07 (5.9/6 speed) is at 130K on the original dual mass clutch. Knock on wood, I've never had a problem with it. I frequently tow the CJ with it (about 8k w/ trailer) and...
Forum: General Discussion 09-08-2014, 12:24 PM
Replies: 1,000
Views: 270,996
Posted By soacj
You, sir, are in the right thread! Please take...

You, sir, are in the right thread! Please take video.:D
Forum: Engine / Drive Train 09-02-2014, 03:37 PM
Replies: 14
Views: 489
Posted By soacj
Same basic chart referenced by Engine Nut,...

Same basic chart referenced by Engine Nut, TeamTalk's Indmar insider/expert:

http://www.mastercraft.com/teamtalk/showpost.php?p=696421&postcount=17
Forum: Engine / Drive Train 09-02-2014, 03:27 PM
Replies: 14
Views: 489
Posted By soacj
Constant source of confusion. See this...

Constant source of confusion.

See this chart:

http://www.mastercraft.com/teamtalk/attachment.php?attachmentid=111994&stc=1&d=1401370732
Forum: Engine / Drive Train 09-02-2014, 01:31 PM
Replies: 14
Views: 489
Posted By soacj
Search on MDC, MMDC, or Medallion Digital Control...

Search on MDC, MMDC, or Medallion Digital Control box...the digital gauge driver which is usually the source of dash woes.

Another thing, regarding the vacuum hose coming off your regulator, I bet...
Forum: Engine / Drive Train 09-02-2014, 11:39 AM
Replies: 14
Views: 489
Posted By soacj
Later boats were 60psi. 40psi is correct up...

Later boats were 60psi. 40psi is correct up until '04 ('05?) due to an injector change.

Bet your pump's fine. 2 psi could simply be gauge inaccuracy.
Forum: Engine / Drive Train 09-02-2014, 07:59 AM
Replies: 14
Views: 489
Posted By soacj
How much less pressure was it showing than 40psi?...

How much less pressure was it showing than 40psi? 40psi is the correct pressure for that model year.

The pressure gauge might not be dead-on accurate so if it was only a psi or two off I'd look...
Forum: Off Topic Discussion 08-31-2014, 08:45 PM
Replies: 1,652
Views: 183,154
Posted By soacj
Sorry for your loss--beautiful dog. Thanks for...

Sorry for your loss--beautiful dog. Thanks for providing her with a home in her final years!
Forum: Engine / Drive Train 08-31-2014, 08:41 PM
Replies: 14
Views: 489
Posted By soacj
Fuel pump primes as noted and the perfect pass...

Fuel pump primes as noted and the perfect pass (if equipped) does a self check.
Forum: General Discussion 08-29-2014, 06:17 PM
Replies: 28
Views: 1,256
Posted By soacj
I hear that! Hell, I'm in VA and still wouldn't...

I hear that! Hell, I'm in VA and still wouldn't have a 2wd truck.

I'm a diesel/HD fan but those kind of numbers get your attention.
Forum: General Discussion 08-29-2014, 05:40 PM
Replies: 28
Views: 1,256
Posted By soacj
A consistent 20mpg is impressive for a 6.2. 2wd,...

A consistent 20mpg is impressive for a 6.2. 2wd, or 4wd?
Forum: Tow Vehicles 08-29-2014, 10:49 AM
Replies: 9
Views: 523
Posted By soacj
All three meaning Ford, GM, and Chrysler? Did I...

All three meaning Ford, GM, and Chrysler? Did I not read Chrysler verified that a legitimate curb weight was used in their calc?
Forum: General Discussion 08-26-2014, 03:47 PM
Replies: 18
Views: 996
Posted By soacj
EFI is obviously of benefit, but I think for a...

EFI is obviously of benefit, but I think for a second boat of that vintage I'd advocate a carb'd setup for the simplicity. A carb rebuild or ignition replacement is about the most complex issue you...
Forum: General Discussion 08-25-2014, 07:16 AM
Replies: 12
Views: 863
Posted By soacj
Ahhh, a little extra "skin" in the game! Not...

Ahhh, a little extra "skin" in the game! Not that I wouldn't feel the same...
Forum: For Sale: Boats 08-20-2014, 12:12 PM
Replies: 3
Views: 691
Posted By soacj
Wow, I'm not usually a tinted windshield guy, but...

Wow, I'm not usually a tinted windshield guy, but that boat looks sweet.
Forum: Trailers 08-18-2014, 07:04 PM
Replies: 12
Views: 709
Posted By soacj
MC's trailer manufacturing is in another facility...

MC's trailer manufacturing is in another facility in the same industrial park as the main plant, but is not part of the standard tour (at least that's what I was told during a tour a couple months...
Forum: Upholstery 08-18-2014, 02:09 PM
Replies: 6
Views: 388
Posted By soacj
Something like this...

Something like this maybe:

http://www.americanrvcompany.com/RV-Designer-H601-White-Screw-Covers-14-Per-Pack-Camper-Trailer-RV
Forum: General Discussion 08-14-2014, 09:45 PM
Replies: 24
Views: 1,319
Posted By soacj
Ahhhh, sorry for the confusion.

Ahhhh, sorry for the confusion.
Forum: General Discussion 08-14-2014, 08:40 PM
Replies: 24
Views: 1,319
Posted By soacj
Stole this picture from a boat trader ad for a...

Stole this picture from a boat trader ad for a '01 230 VRS...the round access port directly in front of the back...
Forum: Trailers 08-14-2014, 04:46 PM
Replies: 12
Views: 709
Posted By soacj
That's a new one. How is the bent axle...

That's a new one. How is the bent axle manifesting itself? Visually bent, or are you getting weird tire wear? What caused the blowouts?
Forum: General Discussion 08-14-2014, 04:40 PM
Replies: 24
Views: 1,319
Posted By soacj
Based on his description of a 2" diameter plate...

Based on his description of a 2" diameter plate with a single 1/16" hole in the center and it's location on the keel, sounds like he's looking at the drain plug. The 1/16" hole is just the divot in...
Showing results 1 to 25 of 480

 

All times are GMT -4. The time now is 08:36 AM.