Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 177
Search took 0.01 seconds.
Search: Posts Made By: chrislandy
Forum: Engine / Drive Train 05-17-2015, 07:21 AM
Replies: 10
Views: 322
Posted By chrislandy
my money is on the firing order being slightly...

my money is on the firing order being slightly wrong, mine had a slight vibration and rich smell, plus no top end under load (it depends which plugs are the wrong way around)

checked it, found two...
Forum: General Discussion 05-13-2015, 08:52 AM
Replies: 33
Views: 1,112
Posted By chrislandy
Funnily enough I was talking to someone the other...

Funnily enough I was talking to someone the other day about building a tracking dronecam
Forum: General Discussion 05-13-2015, 05:49 AM
Replies: 11
Views: 666
Posted By chrislandy
drinks cooler? Driver controlled hydraulic rear...

drinks cooler?
Driver controlled hydraulic rear seat/engine cover lift? - just because you can?
Forum: What is this boat worth? 05-13-2015, 05:44 AM
Replies: 10
Views: 694
Posted By chrislandy
Even a good condition S&S in the UK you may be...

Even a good condition S&S in the UK you may be able to get 5k at the most, a lot of them seem to be in the 3.5k-4k range.

Parts are expensive over here as you either have to buy from MCUK or...
Forum: General Discussion 05-08-2015, 10:08 AM
Replies: 38
Views: 1,711
Posted By chrislandy
When the fibreglass is exposed to water, on a...

When the fibreglass is exposed to water, on a "normal" surface, there is a layer of resin which prevents the fibres from coming into contact with the water. When a cut edge and hence the fibres are...
Forum: Off Topic Discussion 05-07-2015, 04:42 AM
Replies: 36
Views: 2,156
Posted By chrislandy
My 205 was originally owned by the British...

My 205 was originally owned by the British Disabled Water Ski Association, then we bought it from MCUK fully refurbed
Forum: General Discussion 04-27-2015, 03:38 AM
Replies: 56
Views: 2,276
Posted By chrislandy
The more pressure on the back foot the more the...

The more pressure on the back foot the more the ski will try to go vertical and you'll be pushing against half the lake.

I used to ski with a guy that was 80+ so it's all technique, he got very...
Forum: General Discussion 04-27-2015, 03:34 AM
Replies: 18
Views: 1,224
Posted By chrislandy
It's Lac de Guerledan in Brittany, France. There...

It's Lac de Guerledan in Brittany, France. There is a whole sunken village under there somewhere. It is on the Nantes-Breast canal and was flooded in about 1930. The building in the picture is likely...
Forum: General Discussion 04-24-2015, 10:32 AM
Replies: 18
Views: 1,224
Posted By chrislandy
Need to find a new lake this year :(

Going over in a month or so to take a ganders myself but this is what the lake I normally ski on looks like this year :(

They have drained it to check out the dam and service the hydroelectric bits...
Forum: General Discussion 04-24-2015, 10:21 AM
Replies: 19
Views: 783
Posted By chrislandy
I like it, crisper without loosing the feel of...

I like it, crisper without loosing the feel of the forum... nice.
Forum: Wakeboarding & Wakeskating 04-24-2015, 02:24 AM
Replies: 2
Views: 304
Posted By chrislandy
142x44 This one is a mix of carbon & glass Bi...

142x44 This one is a mix of carbon & glass Bi axial & UD, wrapped rails and stringers

Weight is less than 6lb
Forum: Wakeboarding & Wakeskating 04-23-2015, 12:04 PM
Replies: 2
Views: 304
Posted By chrislandy
latest board made

Well the latest board is finished, made for the British Masters Mens Team member Rich...
Forum: Electrical 04-23-2015, 11:58 AM
Replies: 11
Views: 483
Posted By chrislandy
or 3hrs of swearing and knuckle bashing if the...

or 3hrs of swearing and knuckle bashing if the bolts are seized /VOE
Forum: Electrical 04-23-2015, 10:49 AM
Replies: 11
Views: 483
Posted By chrislandy
try jumping the solenoid, short out between the...

try jumping the solenoid, short out between the two poles on the solenoid with a screwdriver and see if the motor spins, if it does then it could just be a duff solenoid - happened to mine so did...
Forum: Engine / Drive Train 04-21-2015, 11:24 AM
Replies: 17
Views: 694
Posted By chrislandy
a cheap easy check is to rebuild (take apart and...

a cheap easy check is to rebuild (take apart and clean up) the idle control valve.

Does your check engine light come on at all? not just with an error, i.e. when you turn the ignition on and not...
Forum: Electrical 04-21-2015, 04:22 AM
Replies: 11
Views: 483
Posted By chrislandy
easy way to check the cables is to use a set of...

easy way to check the cables is to use a set of jump leads, attach the positive lead directly to the starter solenoid
Forum: Engine / Drive Train 04-20-2015, 05:07 AM
Replies: 17
Views: 694
Posted By chrislandy
Yup, check the screen - it's all the way inside...

Yup, check the screen - it's all the way inside the pump on the inlet side. Actually remove the fitting and it's tucked up inside
Forum: Engine / Drive Train 04-20-2015, 05:04 AM
Replies: 8
Views: 483
Posted By chrislandy
The injectors won't fire if the ECU isn't seeing...

The injectors won't fire if the ECU isn't seeing a trigger from the dizzy saying the engine is turning over, have you turned the engine over and checked for a spark?

Check the earths, the one at the...
Forum: General Discussion 04-15-2015, 09:18 AM
Replies: 25
Views: 1,198
Posted By chrislandy
36 and 10.25m and you should be ok!

36 and 10.25m and you should be ok!
Forum: General Discussion 04-14-2015, 12:29 PM
Replies: 15
Views: 1,270
Posted By chrislandy
pretty sweet!

pretty sweet!
Forum: General Discussion 04-14-2015, 06:32 AM
Replies: 13
Views: 529
Posted By chrislandy
Drain the block then bung one of these each side...

Drain the block then bung one of these each side of the block on a frost stat
https://quickbit.co.uk/image/cache/data/HEATERS/main-500x500.jpg

You can drag the thing out anytime, use it, drain it...
Forum: General Discussion 04-10-2015, 04:01 AM
Replies: 1
Views: 458
Posted By chrislandy
NXT @ 50k - found one!

OK, it's 50k not $50k MC UK has one, I am absolutely shocked as I we don't typically see these models over here (or most of the MC line TBH)

So if you're in the UK and want an NXT (or want to see...
Forum: Team Talk 04-07-2015, 03:50 AM
Replies: 25
Views: 1,023
Posted By chrislandy
Thank you

Thank you MC, you have just lifted my mood for the day when I clicked on TT and this came up!

Thank you, thank you, thank you :)
Forum: General Discussion 03-23-2015, 10:42 AM
Replies: 17
Views: 759
Posted By chrislandy
my 2p, Mine had visible blistering but dried it...

my 2p,
Mine had visible blistering but dried it off (the storage area was constantly damp) and stored it somewhere else. The blisters have reduced so much I don't know where they were now! OK the...
Forum: Tow Vehicles 03-05-2015, 03:45 AM
Replies: 125
Views: 9,626
Posted By chrislandy
This is my toy I built/rebuilt about 20yrs ago...

This is my toy I built/rebuilt about 20yrs ago and still have :D I shoe-horned a 3.9 V8 EFI and a 4sp auto into...
Showing results 1 to 25 of 177

 

All times are GMT -4. The time now is 04:50 PM.