Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: Table Rocker
Forum: Engine / Drive Train 11-12-2018, 12:06 PM
Replies: 6
Views: 256
Posted By Table Rocker
There should be a number on the back of the...

There should be a number on the back of the flange that is the K&N number.

Here is the list of K&N marine arrestors:
https://www.knfilters.com/marine/boats.htm
Forum: General Discussion 09-25-2018, 11:00 AM
Replies: 1
Views: 163
Posted By Table Rocker
The chromed version of that wheel is available on...

The chromed version of that wheel is available on eBay: https://www.ebay.com/itm/Mastercraft-15-Aluminum-Trailer-Wheel-6H-OEM-Chrome/332383962110?hash=item4d63a0c3fe:g:zPkAAOSw8Sta9NYQ

The version...
Forum: Engine / Drive Train 09-05-2018, 10:57 AM
Replies: 10
Views: 441
Posted By Table Rocker
It does, on the back of the fuel rail.

It does, on the back of the fuel rail.
Forum: Engine / Drive Train 09-05-2018, 12:55 AM
Replies: 10
Views: 441
Posted By Table Rocker
There is a Schraeder valve on the back of the...

There is a Schraeder valve on the back of the fuel rail where the gauge attaches. If you can test at a variety of RPMs on the water, your results will tell you the most. 4,000 RPM on the water...
Forum: General Discussion 09-04-2018, 10:14 AM
Replies: 72
Views: 3,702
Posted By Table Rocker
The answer to your original question depends...

The answer to your original question depends entirely on the relationship that exists between the owner and the "friend." With this post, it is pretty clear you feel your friend is using you. You...
Forum: Engine / Drive Train 09-03-2018, 10:33 PM
Replies: 10
Views: 441
Posted By Table Rocker
Check your fuel pressure before throwing a new...

Check your fuel pressure before throwing a new fuel pump at it. You can buy the tool or borrow one from an auto parts store. Then you will know you need a new fuel pump.
Forum: General Discussion 09-01-2018, 03:52 PM
Replies: 19
Views: 1,551
Posted By Table Rocker
Eric @ OJ will be able to shed some light on the...

Eric @ OJ will be able to shed some light on the cavitation burn as well. I had cavitation burn and he was a big help.
Forum: General Discussion 08-31-2018, 11:34 AM
Replies: 11
Views: 502
Posted By Table Rocker
Try letting it sit for a few seconds with the key...

Try letting it sit for a few seconds with the key on before attempting a start.
Forum: Engine / Drive Train 08-30-2018, 10:08 AM
Replies: 16
Views: 532
Posted By Table Rocker
It sounds like you could have a vacuum leak.

It sounds like you could have a vacuum leak.
Forum: Engine / Drive Train 08-29-2018, 11:08 PM
Replies: 16
Views: 532
Posted By Table Rocker
It's not the vent then.

It's not the vent then.
Forum: Engine / Drive Train 08-29-2018, 08:22 PM
Replies: 16
Views: 532
Posted By Table Rocker
Have you checked your fuel tank vent? If it is...

Have you checked your fuel tank vent? If it is blocked, the tank will pull a vacuum and starve for fuel. As it sits, air will creep in and it will run fine for a while, starting the process over.
Forum: General Discussion 08-29-2018, 05:10 PM
Replies: 12
Views: 705
Posted By Table Rocker
I am not sure what route you are taking to get...

I am not sure what route you are taking to get there, but I like I-40 & I-49 over I-44 & 412, especially when pulling a trailer. No stops, no tolls and better scenery. Compare the routes and see if...
Forum: Off Topic Discussion 08-29-2018, 11:44 AM
Replies: 35
Views: 2,408
Posted By Table Rocker
I doubt there is any way it could have ridden on...

I doubt there is any way it could have ridden on that stern drive. I think it swam up and decided to take a break there.
Forum: General Discussion 08-29-2018, 11:29 AM
Replies: 19
Views: 1,551
Posted By Table Rocker
I suspect boats loaded for surfing are likely to...

I suspect boats loaded for surfing are likely to see cavitation burn with almost any prop.
Forum: General Discussion 08-28-2018, 02:13 PM
Replies: 19
Views: 1,551
Posted By Table Rocker
That is cavitation burn. Is it on both sides?

That is cavitation burn. Is it on both sides?
Forum: Engine / Drive Train 08-24-2018, 12:59 PM
Replies: 24
Views: 974
Posted By Table Rocker
Transmission neutral sensor? Do you get 12v on...

Transmission neutral sensor? Do you get 12v on the yellow wire with red stripe at your starter when you turn the key to start?

Nevermind, after re-reading I see where it tries to crank.
Forum: General Discussion 08-23-2018, 11:25 PM
Replies: 57
Views: 1,975
Posted By Table Rocker
The bypass isn't a necessity, I was just...

The bypass isn't a necessity, I was just explaining what was in the diagram.
Forum: General Discussion 08-23-2018, 11:13 PM
Replies: 57
Views: 1,975
Posted By Table Rocker
This diagram shows the ballast resistor starting...

This diagram shows the ballast resistor starting bypass wire. The I terminal on the solenoid is hot when cranking only and sends full voltage to the coil.
Forum: General Discussion 08-23-2018, 10:10 PM
Replies: 57
Views: 1,975
Posted By Table Rocker
You can run a jumper from the I terminal of the...

You can run a jumper from the I terminal of the solenoid to the coil post on the ballast resistor. This sends full voltage to the coil during starting.
Forum: Engine / Drive Train 08-22-2018, 11:23 AM
Replies: 50
Views: 2,007
Posted By Table Rocker
You are correct, in my mind I had you standing in...

You are correct, in my mind I had you standing in front of your engine. Sorry to add my confusion.
Forum: Engine / Drive Train 08-21-2018, 07:55 PM
Replies: 50
Views: 2,007
Posted By Table Rocker
If a temp sensor isn't in water/coolant, it will...

If a temp sensor isn't in water/coolant, it will not give accurate readings. That is likely what happened here regarding the reasonable temps displayed on the gauge during the event.

Since I think...
Forum: Engine / Drive Train 08-19-2018, 08:48 PM
Replies: 3
Views: 179
Posted By Table Rocker
I would suspect you have an alignment problem. ...

I would suspect you have an alignment problem. Have you checked the engine alignment?
Forum: General Discussion 08-06-2018, 07:49 PM
Replies: 26
Views: 849
Posted By Table Rocker
That is correct. I just did a Google image...

That is correct. I just did a Google image search for a 350 distributor and borrowed that pic from Jegs. It is an automotive distributor with vacuum advance.

I am just trying to connect "I...
Forum: General Discussion 08-06-2018, 07:38 PM
Replies: 26
Views: 849
Posted By Table Rocker
Yes, I agree.

Yes, I agree.
Forum: Electrical 08-06-2018, 06:25 PM
Replies: 13
Views: 400
Posted By Table Rocker
AutoZone didn't have the "right connections?" ...

AutoZone didn't have the "right connections?" Didn't have the right employees is more honest. The right connections for that alternator are two alligator clips.

If one of your terminals is...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 11:15 AM.


2018