Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 65
Search took 0.03 seconds.
Search: Posts Made By: jmhjgh
Forum: General Discussion 09-11-2014, 01:52 PM
Replies: 24
Views: 759
Posted By jmhjgh
I agree with Mastercraft13. I learned on...

I agree with Mastercraft13. I learned on long-line sitting on a kneeboard. The boat driver needs to go to around 20, and then slow down until you stop bouncing. Move forward on the board and have...
Forum: Storage / Winterization 07-30-2014, 11:01 AM
Replies: 9
Views: 779
Posted By jmhjgh
Are you using teflon tape? Cleaning with a wire...

Are you using teflon tape? Cleaning with a wire brush and teflon tape should be more than sufficient for sealing.
Forum: Engine / Drive Train 07-18-2014, 11:25 AM
Replies: 16
Views: 669
Posted By jmhjgh
This would be a long shot, but put a meter on...

This would be a long shot, but put a meter on your battery when running and measure both AC and DC. My alternator was failing and putting out AC that was causing a similar stall.
Forum: General Discussion 06-04-2014, 11:08 AM
Replies: 42
Views: 2,311
Posted By jmhjgh
Also check your local Craigslist. If someone...

Also check your local Craigslist. If someone found it, it might be for sale.
Forum: General Discussion 05-21-2014, 02:42 PM
Replies: 41
Views: 2,079
Posted By jmhjgh
I looked at Skisafe. The premiums change...

I looked at Skisafe. The premiums change drastically depending on what liability limits you want. For the same liability limits as my current policy with American Family, Skisafe was more expensive...
Forum: Upholstery 05-20-2014, 09:48 AM
Replies: 23
Views: 2,004
Posted By jmhjgh
I have used that same Loctite adhesive. The...

I have used that same Loctite adhesive. The issue is going to be holding the seam together while it dries. If you just want a temporary repair, think about adding a piece of vinyl under the seam...
Forum: Restorations and Refurbishments 11-26-2013, 10:42 AM
Replies: 179
Views: 35,280
Posted By jmhjgh
I think your boat and new interior are turning...

I think your boat and new interior are turning out fantastic. In looking at your picture for the front bow, is it possible that the left and right seat cushions are on the wrong sides? I don't...
Forum: General Discussion 09-19-2013, 01:26 PM
Replies: 14
Views: 1,061
Posted By jmhjgh
A cantilever will definitely work. However, we...

A cantilever will definitely work. However, we sold ours for a vertical lift. If I was buying used, I would search for a vertical. Depending on the lake levels (if they change a lot) a cantilever...
Forum: Off Topic Discussion 09-06-2013, 02:35 PM
Replies: 27
Views: 1,528
Posted By jmhjgh
They make very good cars, but there will be some...

They make very good cars, but there will be some maintenance. I have owned several and currently have two. You will need a Vag-Com cable from Ross-Tech for diagnostic work (it will pay for itself...
Forum: Engine / Drive Train 06-04-2013, 11:47 AM
Replies: 92
Views: 3,499
Posted By jmhjgh
You stated you checked the output of your...

You stated you checked the output of your alternator, but one more easy check is to see if your alternator is putting out any AC voltage. That will cause some weird problems with sensors.
Forum: Storage / Winterization 05-30-2013, 02:59 PM
Replies: 9
Views: 1,242
Posted By jmhjgh
The only problem with the tower is that it makes...

The only problem with the tower is that it makes putting it back on the lift after a quick run more difficult. Our boat might go on/off the lift several times a day on a weekend.
Forum: Storage / Winterization 05-30-2013, 11:53 AM
Replies: 9
Views: 1,242
Posted By jmhjgh
We do not have a tower. But if I did, I would...

We do not have a tower. But if I did, I would fold it down and tuck the boat up in the canopy. We put ours in the water this past weekend. No issues, and the wheel kit works pretty good for moving...
Forum: Upholstery 05-28-2013, 11:31 AM
Replies: 7
Views: 806
Posted By jmhjgh
I have had good luck with Mold Armour in a green...

I have had good luck with Mold Armour in a green bottle from Menards. Follow it up with 303 protectant.
Forum: Storage / Winterization 05-22-2013, 11:47 AM
Replies: 9
Views: 1,242
Posted By jmhjgh
We have a 4000# vertical with 24' canopy. Some...

We have a 4000# vertical with 24' canopy. Some of the rollers tend to creak and groan a bit. IMO more of the frame is bolted vs welded when comparing to Hewitt or Shorestation. I really like their...
Forum: Engine / Drive Train 04-29-2013, 03:12 PM
Replies: 28
Views: 2,432
Posted By jmhjgh
Make sure the gas valve is turned all the way on...

Make sure the gas valve is turned all the way on (located on top of the gas tank behind the rear seat).
Forum: For Sale: Boats 04-16-2013, 10:27 PM
Replies: 112
Views: 15,897
Posted By jmhjgh
I have an offer in to you. Good luck with the...

I have an offer in to you. Good luck with the sale.
Forum: For Sale: Boats 12-06-2012, 12:24 PM
Replies: 11,166
Views: 1,352,278
Posted By jmhjgh
Denver 205: we do you get the foam tape?

In the 2nd picture, the owner has a color matched foam pad/tape protecting the top edge of the hull. With kids, ours seems to get scratched and always needs a buff. Anyone know where to buy...
Forum: Off Topic Discussion 09-11-2012, 04:28 PM
Replies: 11
Views: 945
Posted By jmhjgh
I agree with being safe, but I don't require life...

I agree with being safe, but I don't require life jackets on the dock or while swimming. I agree that people that are not competent swimmers should not be in the boat or in areas that are unsafe...
Forum: Engine / Drive Train 08-16-2012, 03:42 PM
Replies: 24
Views: 1,982
Posted By jmhjgh
NAPa no longer has those pumps as I tried to...

NAPa no longer has those pumps as I tried to purchase one a few weeks ago. Their inventory claims they have one, but they do not.
Forum: Engine / Drive Train 08-09-2012, 10:44 PM
Replies: 30
Views: 4,073
Posted By jmhjgh
I brought mine to a shop that rebuilds starters...

I brought mine to a shop that rebuilds starters and alternators. The capacitor had broken free of the clamp and took out the rotor and wires. The rebuild was going to be the same price as one off...
Forum: Engine / Drive Train 08-09-2012, 01:54 PM
Replies: 0
Views: 318
Posted By jmhjgh
PIC needed of PS205 350 Indmar Timing marker

I was having trouble earlier with surging and engine drop outs. My problem ended up being a bad alternator. I purchased a re-manufactured unit after dropping mine off for a rebuild. The mounting...
Forum: Engine / Drive Train 08-06-2012, 10:18 AM
Replies: 30
Views: 4,073
Posted By jmhjgh
OK. The boat is 3 hours north and we went up...

OK. The boat is 3 hours north and we went up this past weekend. I had a fuel pressure tester and a new fuel pump just in case. For reference, AutoZone will sell you a very nice fuel pressure...
Forum: Engine / Drive Train 07-25-2012, 11:37 AM
Replies: 30
Views: 4,073
Posted By jmhjgh
I will look at the filter a bit closer this...

I will look at the filter a bit closer this evening. Too start with, it is a painted filter, but the connections looked like plated metal.
Do you happen to know the thread size on the filter so I...
Forum: Engine / Drive Train 07-25-2012, 11:09 AM
Replies: 30
Views: 4,073
Posted By jmhjgh
The Napa fuel filters look like the case is made...

The Napa fuel filters look like the case is made of aluminum. I was planning to solder on a schrader valve to a new fuel filter so that I can use a regular fuel pressure gauge to check my fuel pump....
Forum: Engine / Drive Train 07-20-2012, 11:07 PM
Replies: 30
Views: 4,073
Posted By jmhjgh
Well I have everything in the basement except a...

Well I have everything in the basement except a new filter and maybe the brass shrader valve. I am excited about trying the alternator, but I am not sure when we can get back up north.
What...
Showing results 1 to 25 of 65

 

All times are GMT -4. The time now is 12:30 AM.