Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 152
Search took 0.01 seconds.
Search: Posts Made By: Wingnut
Forum: Restorations and Refurbishments 11-22-2014, 07:43 PM
Replies: 38
Views: 4,280
Posted By Wingnut
This is the replacement shaft log I ordered thru...

This is the replacement shaft log I ordered thru MC - $17.50
Forum: Restorations and Refurbishments 11-22-2014, 07:41 PM
Replies: 38
Views: 4,280
Posted By Wingnut
H2O- Was this boat a salt water boat?? the...

H2O- Was this boat a salt water boat?? the corrosion on the pylon and other areas you have shown look suspiciously like salt water. I had a similar issue with the 205 I finished- Had to hunt all...
Forum: Restorations and Refurbishments 10-19-2014, 09:37 AM
Replies: 188
Views: 40,444
Posted By Wingnut
they are the silvers pieces you can see slightly....

they are the silvers pieces you can see slightly. Ill look to take another pic shortly.
Forum: Restorations and Refurbishments 10-19-2014, 09:35 AM
Replies: 188
Views: 40,444
Posted By Wingnut
To Snipe- ref removing the speedo pod

Snipe- these are the two pictures that get close to the center dash pod mounts. There are 4 Snap clips one located above and below both speedos. If you grab the speedos by the bezel ring (hopefully...
Forum: Wanted to Buy 10-16-2014, 07:51 AM
Replies: 4
Views: 438
Posted By Wingnut
Frank what do you want for it and estimated...

Frank what do you want for it and estimated shipping to FL? Could you send a picture? Thx Wingnut
Forum: Wanted to Buy 10-15-2014, 12:09 PM
Replies: 4
Views: 438
Posted By Wingnut
Pm sent

Pm sent
Forum: Restorations and Refurbishments 10-15-2014, 11:56 AM
Replies: 188
Views: 40,444
Posted By Wingnut
Before installation.

Before installation.
Forum: Restorations and Refurbishments 10-15-2014, 11:53 AM
Replies: 188
Views: 40,444
Posted By Wingnut
Its already closed loop cooling. A must for...

Its already closed loop cooling. A must for saltwater ops. Thanks
Forum: Restorations and Refurbishments 10-11-2014, 04:42 PM
Replies: 188
Views: 40,444
Posted By Wingnut
Looking for an international barefoot boom...

Looking for an international barefoot boom mounting clamp. Anyone got one out there? Got all the rest of the parts. Thanks
Forum: General Discussion 10-11-2014, 04:34 PM
Replies: 7
Views: 330
Posted By Wingnut
Fiberlay but look up location, not sure if...

Fiberlay but look up location, not sure if anything is close to you,
Forum: Wanted to Buy 10-11-2014, 04:25 PM
Replies: 4
Views: 438
Posted By Wingnut
WTB- Barefoot International Boom Clamp

Anyone out there got one without the boom?? I know someone does cause it went with my 88 prostar bout 6 months ago- Anyone else got one?? Thanks Wingnut
Forum: Appearance 08-28-2014, 09:40 AM
Replies: 151
Views: 32,763
Posted By Wingnut
I did McMasters Carr and it turned out great- ...

I did McMasters Carr and it turned out great- Really works- Easy to install just a pain to get all the old stuff off.
Forum: Restorations and Refurbishments 08-28-2014, 09:36 AM
Replies: 42
Views: 5,042
Posted By Wingnut
Oil and mineral spirits for me after paying for...

Oil and mineral spirits for me after paying for the Star Bright the first go round. 75/25 or 80/20- Works great!!!
Forum: Restorations and Refurbishments 08-28-2014, 09:34 AM
Replies: 7
Views: 400
Posted By Wingnut
Well may not help, but if you are on the west...

Well may not help, but if you are on the west coast of florida there is a discount marine surplus store in Sarasota FL that buys excess parts from many manufactures and they have a bunch of them,...
Forum: Restorations and Refurbishments 08-27-2014, 11:26 AM
Replies: 188
Views: 40,444
Posted By Wingnut
pictures of summer

pictures of summer
Forum: Restorations and Refurbishments 08-27-2014, 11:17 AM
Replies: 188
Views: 40,444
Posted By Wingnut
Summer Fun

Ok haven't posted for a while because I'm having too much fun. Replaced manifold riser gaskets , retighted steering brackets, replaced Impeller, found out that weeds are a pain in the A** ....
Forum: Engine / Drive Train 08-08-2014, 12:18 PM
Replies: 20
Views: 934
Posted By Wingnut
Thanks Mike- I too have read the problems was...

Thanks Mike- I too have read the problems was just wondering- It's not too much of a prob to backflush -- just a pain. You're always the "Go to guy" on this forum. Thanks again,
Dave
Forum: Engine / Drive Train 08-08-2014, 12:10 PM
Replies: 20
Views: 934
Posted By Wingnut
Anyone put a strainer on water intake??

Ok I keep sucking in weeds and crap that gets past the Perko flushpro and into the Tranny cooler. I notice a slight rise in operating temp and then have to backflush the cooler. It clears and runs...
Forum: Restorations and Refurbishments 07-09-2014, 10:10 PM
Replies: 122
Views: 15,461
Posted By Wingnut
Nice work and it looks really nice. I have a 98...

Nice work and it looks really nice. I have a 98 with a 96 motor that went thru a major resurrection. so If I can be of any help give a shout. Wingnut// Dave
Forum: Restorations and Refurbishments 06-23-2014, 03:54 PM
Replies: 25
Views: 1,962
Posted By Wingnut
Wow that is really an impressive job. Looks...

Wow that is really an impressive job. Looks fantastic!!!!
Forum: Restorations and Refurbishments 06-17-2014, 06:16 PM
Replies: 188
Views: 40,444
Posted By Wingnut
finished the trailer prop guard for non M/C...

finished the trailer prop guard for non M/C trailer and happy the way it turned out- First prototype more under the trailer forum -" bolt on trailer prop guard"
Forum: Restorations and Refurbishments 06-17-2014, 06:11 PM
Replies: 188
Views: 40,444
Posted By Wingnut
Ran it today for the first time at speed-...

Ran it today for the first time at speed- Niiiicce- really quieted it down- Book says 60% reduction- I think every bit of that.
Forum: Restorations and Refurbishments 06-17-2014, 06:10 PM
Replies: 188
Views: 40,444
Posted By Wingnut
From McMaster-Carr- 1" Heavy duty Foil Sided with...

From McMaster-Carr- 1" Heavy duty Foil Sided with peel adhesive backing- Comes in 54" wide roll- Bought 8 Feet and it was enough- Wasnt cheap- $140 with $25 shipping - arrived next day. Adhesive...
Forum: Trailers 06-17-2014, 11:38 AM
Replies: 12
Views: 625
Posted By Wingnut
SKI-me did a roller addition on his trailer in...

SKI-me did a roller addition on his trailer in this forum thats pretty cool and there are others that have integrated steel bearing rollers into the cage.
Forum: Trailers 06-17-2014, 11:31 AM
Replies: 12
Views: 625
Posted By Wingnut
Here are the pixs. Keep in mind when you look at...

Here are the pixs. Keep in mind when you look at ground clearance, this is taken from the rear on a driveway that slopes up from the wheels- actual ground clearance is about 7.5 inches. Might...
Showing results 1 to 25 of 152

 

All times are GMT -4. The time now is 09:08 PM.