Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: blackhawk
Forum: Ballast 07-28-2016, 04:31 PM
Replies: 6
Views: 154
Posted By blackhawk
Correct No idea why this is looped. I guess...

Correct



No idea why this is looped. I guess that it can still work to drain because of a siphoning effect. But, it should work just fine if it went to the rear bag port directly.



If you did...
Forum: Audio/Stereo 07-28-2016, 01:21 PM
Replies: 9
Views: 271
Posted By blackhawk
David - The relay fixed my problem. In the end,...

David - The relay fixed my problem. In the end, I connected the RLC in with the other 2 remote wires per my diagram. I did try it with the RLC connected separately to a positive terminal and it...
Forum: Audio/Stereo 07-25-2016, 01:33 PM
Replies: 9
Views: 271
Posted By blackhawk
David - I follow, but wanted to clarify your...

David - I follow, but wanted to clarify your statements on the line controller (RLC). I do have a separate/dedicated wire for the constant power that goes to the line controller. I am pulling this...
Forum: Storage / Winterization 07-24-2016, 10:44 PM
Replies: 16
Views: 671
Posted By blackhawk
You should be able to take out one of the 8' wide...

You should be able to take out one of the 8' wide doors and change it to a 9' wide door. You will definitely need to replace the header to carry the load properly. Is there a second floor above the...
Forum: Wakesurfing 07-24-2016, 10:34 PM
Replies: 6
Views: 233
Posted By blackhawk
I have an X15, so it is a little different. I...

I have an X15, so it is a little different. I run about 1000 lbs total in the port locker with KGB full and IBS piggyback full. Nothing in starboard locker. What makes a huge difference is having...
Forum: Audio/Stereo 07-24-2016, 10:21 PM
Replies: 9
Views: 271
Posted By blackhawk
David - I unplugged my RCA inputs and the popping...

David - I unplugged my RCA inputs and the popping noise went away. I assume this means that my amp is OK and an upstream event is my problem, correct?

I have 2 amps total. I have the original...
Forum: Audio/Stereo 07-23-2016, 10:30 PM
Replies: 9
Views: 271
Posted By blackhawk
JL M400/4 amp pops when turned on

I installed a dedicated JL M400/4 for my two tower speakers last year. This summer the tower speakers have been making a popping sound whenever I turn the key on and the amp cuts on. I always leave...
Forum: Electrical 07-23-2016, 10:29 PM
Replies: 0
Views: 52
Posted By blackhawk
JL M400/4 amp pops when turned on

Please delete. Added to wrong section
Forum: Other 07-23-2016, 10:20 PM
Replies: 27
Views: 825
Posted By blackhawk
Other way to check is to run and slide on a...

Other way to check is to run and slide on a smooth floor with socks on. The foot that you put forward is how you should ride. Otherwise known as the "Risky Business" test method.
Forum: Engine / Drive Train 07-20-2016, 11:30 PM
Replies: 731
Important: Fuel Pump 101
Views: 160,936
Posted By blackhawk
1. It will drop very slowly after the pump...

1. It will drop very slowly after the pump starts. It should only drop about 1 psi per minute at most. That is just a rough approximation though.

2. Yes, it should be pretty steady. Mine runs...
Forum: Ballast 07-20-2016, 11:23 PM
Replies: 5
Views: 166
Posted By blackhawk
The top of each sending unit has potentiometers...

The top of each sending unit has potentiometers that you can adjust with a screwdriver. There is one for your empty reading and one for the full reading. You can try adjusting these, but as...
Forum: General Discussion 07-20-2016, 11:00 PM
Replies: 6
Views: 292
Posted By blackhawk
Would really like to get others CR/CS and KDW...

Would really like to get others CR/CS and KDW settings for an X15 with MCX. If you have settings that are working great with the new style screen and module please share.
Forum: Engine / Drive Train 07-19-2016, 10:26 PM
Replies: 6
Views: 240
Posted By blackhawk
Get a spark tester and see if you have a spark. ...

Get a spark tester and see if you have a spark. Engine needs 3 main things to run, spark, fuel, and compression.
Forum: General Discussion 07-19-2016, 10:17 PM
Replies: 5
Views: 247
Posted By blackhawk
That thread size does show up on metric thread...

That thread size does show up on metric thread charts, but I have never seen a bolt that size. You are probably going to need to check with some trailer shops. You might also call etrailer.com and...
Forum: General Discussion 07-18-2016, 10:55 PM
Replies: 6
Views: 292
Posted By blackhawk
Yes, I played with the CS settings last year...

Yes, I played with the CS settings last year based on what PP told me to try. Changing the settings helped with surfing but I could never get it as good as my old unit. I am going to play with it...
Forum: General Discussion 07-18-2016, 10:52 PM
Replies: 2
Views: 210
Posted By blackhawk
I had a roller throw a few gallons of water over...

I had a roller throw a few gallons of water over my bow a few weeks ago. The next day I still had about a quart of water standing right in the center of the bow under the cupholders. I raised the...
Forum: Off Topic Discussion 07-18-2016, 10:04 AM
Replies: 12
Views: 297
Posted By blackhawk
I have had pretty good dealings with Crutchfield...

I have had pretty good dealings with Crutchfield throughout the years. Here is a link to their antennas. http://www.crutchfield.com/g_15920/TV-Antennas.html

They are really great about returns.
Forum: General Discussion 07-18-2016, 09:51 AM
Replies: 6
Views: 292
Posted By blackhawk
jseam - Pretty sure that my KDW is higher than...

jseam - Pretty sure that my KDW is higher than 40. I'll give it a shot though. Worst case is that I'll have to change KDW between wakeboarding and surfing.

PP told me that they didn't change any...
Forum: General Discussion 07-17-2016, 10:49 PM
Replies: 6
Views: 292
Posted By blackhawk
New Perfect Pass problems

So last year I had the dreaded blank screen on my Perfect Pass. (2006 X15 MCX) I bought a new one directly from PP. As most know, when your original screen goes you have to also replace the...
Forum: For Sale: Boats 07-14-2016, 10:34 PM
Replies: 2
Views: 497
Posted By blackhawk
Link doesn't work

Link doesn't work
Forum: General Discussion 07-14-2016, 10:30 PM
Replies: 2
Views: 156
Posted By blackhawk
My 2006 X15 does not have a dedicated pump just...

My 2006 X15 does not have a dedicated pump just for the heater. I really doubt that yours does either. I had trouble with mine not blowing a lot of air. I found that my access door behind the bow...
Forum: Engine / Drive Train 07-13-2016, 10:06 PM
Replies: 731
Important: Fuel Pump 101
Views: 160,936
Posted By blackhawk
J. Graham - I had to order my Oetiker clamps from...

J. Graham - I had to order my Oetiker clamps from McMaster Carr. http://www.mcmaster.com/#ear-hose-clamps/=139sb3c I ordered both the 11.3 and 13.3 sizes with the single pinch, "tight seal" style. ...
Forum: Engine / Drive Train 07-10-2016, 10:12 PM
Replies: 731
Important: Fuel Pump 101
Views: 160,936
Posted By blackhawk
You really need the Oetiker brand pinch clamps...

You really need the Oetiker brand pinch clamps and a pinch tool to close them. Standard worm clamps usually won't seal completely leading to hard starts.
Forum: General Discussion 07-10-2016, 10:05 PM
Replies: 288
Views: 19,014
Posted By blackhawk
Don't pay attention to the trailer color in my...

Don't pay attention to the trailer color in my pictures. That was just a temporary trailer for the factory. I saw all kinds of mis-matched trailers in final assembly. They match them up later on.
Forum: General Discussion 07-09-2016, 10:26 PM
Replies: 288
Views: 19,014
Posted By blackhawk
Here are pictures of a couple of XT23s that I...

Here are pictures of a couple of XT23s that I took during my factory tour on 7/6. My guide said that we were the first group to see the new colors and options for 2017 on the factory floor. Check...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 08:35 PM.