Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 218
Search took 0.01 seconds.
Search: Posts Made By: markismm
Forum: Engine / Drive Train 05-17-2013, 11:35 AM
Replies: 5
Views: 119
Posted By markismm
You can make them open up manually through the...

You can make them open up manually through the use of compressed air. See this link which is helpful in diagnosing your problem in the...
Forum: General / Other 05-16-2013, 04:12 PM
Replies: 3,254
Views: 234,497
Posted By markismm
Have been having a small "hesitation" in...

Have been having a small "hesitation" in secondaries opening opening up on my Holley 4160 when slowly easing into the throttle. So I installed a quick fuel adjustable vaccum advance secondary...
Forum: General / Other 05-02-2013, 04:37 PM
Replies: 1
Views: 156
Posted By markismm
Steering cable removal

Sorry for this long post, but I had a PM to post some pics. Not sure how to post pics in a PM and the space is limited so I decided to put it here.

The following is the removal of the steering...
Forum: General Discussion 04-30-2013, 01:15 PM
Replies: 21
Views: 2,534
Posted By markismm
Thanks George. Hope to see you out on the water...

Thanks George. Hope to see you out on the water this year. Talk to you soon.
Forum: General Discussion 04-30-2013, 01:10 PM
Replies: 8
Views: 372
Posted By markismm
I purchased the replacement cable from the...

I purchased the replacement cable from the boatdesigns folks located in the link on the original post. The replacement cable is fantastic and comes with an extra zirc fitting for continued...
Forum: General Discussion 04-29-2013, 05:12 PM
Replies: 21
Views: 2,534
Posted By markismm
Yep...pond is at full pool and am looking forward...

Yep...pond is at full pool and am looking forward to getting out on the courses. That will be happening in two weeks. Any word on this years slalom clinic/tournament. I love the event and will be...
Forum: Off Topic Discussion 10-01-2012, 03:06 PM
Replies: 13,263
Views: 3,134,154
Posted By markismm
Looks like you guys were having a good time...

Looks like you guys were having a good time although Chimney Rock is starting to slow down for the seasons end. Always the most disappointing time of the year in my mind.
Forum: Engine / Drive Train 10-01-2012, 03:02 PM
Replies: 3
Views: 277
Posted By markismm
That seems to be the case. In looking at your...

That seems to be the case. In looking at your pic I only see the four wires that are supposed to be hooked up to your coil hooked to it. None of those wires appear to be tan.
Forum: Engine / Drive Train 09-06-2012, 01:00 PM
Replies: 41
Views: 2,149
Posted By markismm
I dont think you should be afraid of swapping to...

I dont think you should be afraid of swapping to a marine billet Pertronix Distrib. Just put on in my boat at the beginning of this season to replace my old converted Prestolite and it is working...
Forum: Engine / Drive Train 09-05-2012, 01:10 PM
Replies: 41
Views: 2,149
Posted By markismm
You could always have someone else ride with you...

You could always have someone else ride with you with the doghouse off and check to see if your secondaries are opening all the way. You can also manually open them while driving. If the...
Forum: Engine / Drive Train 08-28-2012, 01:47 PM
Replies: 25
Views: 1,634
Posted By markismm
Okay. Fully understand what you are referring to...

Okay. Fully understand what you are referring to now with that description. Its been a while since I looked at mine. How long has it been since you replaced the cap and rotor. If it has been more...
Forum: Engine / Drive Train 08-27-2012, 01:05 PM
Replies: 25
Views: 1,634
Posted By markismm
Glad you figured out the issue. Not too sure...

Glad you figured out the issue. Not too sure which "little black button" you are referring to? Is it part of the cap or rotor? The parts that was worn out in my old distrib which had been...
Forum: Engine / Drive Train 08-24-2012, 11:56 PM
Replies: 25
Views: 1,634
Posted By markismm
sxerob. i responded to you pm. sorry it took me...

sxerob. i responded to you pm. sorry it took me so long. i do not know how to test an ecm to see if it is good. i replaced that last when i had some ignition problems with my boat on the old...
Forum: Engine / Drive Train 08-13-2012, 01:04 PM
Replies: 4
Views: 303
Posted By markismm
I have the same intake that I bought at a swap...

I have the same intake that I bought at a swap meet. It had a custom egr block-off plate and it has never once leaked any carbon whatsoever. The block-off plate it very thick and had a good amount...
Forum: Engine / Drive Train 07-24-2012, 12:54 PM
Replies: 13
Views: 845
Posted By markismm
When I installed mine, it was a much tighter fit...

When I installed mine, it was a much tighter fit than the original due to 20 years worth of wear and tear on the original gear. In short, however, took a bit to get the Pertronix to finally seat. ...
Forum: Trailers 07-20-2012, 11:39 PM
Replies: 1
Views: 415
Posted By markismm
Let me try this once more.

Let me try this once more.
Forum: Trailers 07-19-2012, 04:02 PM
Replies: 1
Views: 415
Posted By markismm
Wanting to buy O.E.M. black trailer wheel

I had an unsuspected blow-out a weekend back on my 84 S&S trailer. Unfortunately the wheel was damaged and the trim ring destroyed. I am looking to see if anyone has a black factory wheel like the...
Forum: Off Topic Discussion 07-05-2012, 01:11 PM
Replies: 56
Views: 2,723
Posted By markismm
Here is some GoPro video from me on my homemade...

Here is some GoPro video from me on my homemade subwing and some shots of the Mastercraft cruisin. Please excuse the fact that there is a brief shot of us skiing behind a Nautique in the vid as...
Forum: Wakeboarding & Wakeskating 06-18-2012, 09:03 AM
Replies: 6
Views: 743
Posted By markismm
We will be there both days. Looking forward to...

We will be there both days. Looking forward to the clinic especially.
Forum: Restorations and Refurbishments 06-07-2012, 01:19 PM
Replies: 78
Views: 6,765
Posted By markismm
LOVE IT!!!. Mind sharing the name of the...

LOVE IT!!!. Mind sharing the name of the manufacturer of the upholstery and the color code/number with us?
Forum: General / Other 05-23-2012, 01:43 PM
Replies: 6
Views: 588
Posted By markismm
The cavity I am referring to on mine is very...

The cavity I am referring to on mine is very narrow and was not filled in with foam. I know that most of the open areas around the stringers were filled in with foam, but the area directly below the...
Forum: Off Topic Discussion 05-23-2012, 01:27 PM
Replies: 881
Views: 64,510
Posted By markismm
I use Royal Oak, Cowboy Brand Lump Charcoal or...

I use Royal Oak, Cowboy Brand Lump Charcoal or Publix Brand lump. I personally like Royal Oak because its made in Georgia and is the most consistent in its size and lack of broken little pieces.
Forum: Engine / Drive Train 05-23-2012, 01:24 PM
Replies: 14
Views: 534
Posted By markismm
Sounds like you have two probs. Sounds like you...

Sounds like you have two probs. Sounds like you have a cooling problem and potentially a fuel delivery problem. Check impeller. Then work on fuel delivery. This usually entails a carburetor...
Forum: Electrical 05-23-2012, 09:05 AM
Replies: 33
Views: 1,225
Posted By markismm
Agreed. If you are getting that kind of voltage...

Agreed. If you are getting that kind of voltage with engine running, sounds like no reason to replace alternator.
Forum: General / Other 05-23-2012, 09:01 AM
Replies: 6
Views: 588
Posted By markismm
I considered not worrying about it too, but my...

I considered not worrying about it too, but my curiosity got the best of me. The water I was hearing was all in between the two inner stringers and under the sub floor of my bilge. Therefore, I cut...
Showing results 1 to 25 of 218

 

All times are GMT -4. The time now is 06:08 PM.