Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 32
Search took 0.01 seconds.
Search: Posts Made By: WA Nautique
Forum: General Discussion 07-22-2016, 04:02 PM
Replies: 6
Views: 255
Posted By WA Nautique
Hi Mike, I haven't seen as many detailed...

Hi Mike, I haven't seen as many detailed stringer threads here as I have on Correctcraftfan.com. I know it's a family of Nautique guys, but lots of love for an old S&S too. there is a thread on...
Forum: Engine / Drive Train 07-05-2016, 03:36 PM
Replies: 2
Views: 114
Posted By WA Nautique
starter nose might be different, sometimes the...

starter nose might be different, sometimes the Bendix is longer than the original. that would be the first place I'd check. Second option is that the starter housing is not seated all the way and...
Forum: General / Other 06-27-2016, 01:05 PM
Replies: 12
Views: 629
Posted By WA Nautique
might be a good opportunity to pick up a shock...

might be a good opportunity to pick up a shock tube, you never know when someone will get stuck on the end of your rope. Bummer on the mirror, but glad you don't have an ER bill or need a new...
Forum: Electrical 06-16-2016, 02:37 PM
Replies: 3
Views: 118
Posted By WA Nautique
not a diagram, but it would be pretty easy... ...

not a diagram, but it would be pretty easy...

12v wire from battery to a fuse/ckt breaker, to switch, to device. from device negative terminal to ground. each wire will need to be sized for...
Forum: Engine / Drive Train 06-14-2016, 06:23 PM
Replies: 2
Views: 222
Posted By WA Nautique
http://www.correctcraftfan.com/forum/forum_posts.a...

http://www.correctcraftfan.com/forum/forum_posts.asp?TID=34338&title=protec-ignition-swap
Forum: Engine / Drive Train 06-14-2016, 06:19 PM
Replies: 15
Views: 476
Posted By WA Nautique
if your going to the trouble of shipping a carb,...

if your going to the trouble of shipping a carb, you might check out the quick fuel 600's they have had a very good reception on another site that I follow. It's a direct replacement for the...
Forum: Electrical 06-10-2016, 06:14 PM
Replies: 15
Views: 530
Posted By WA Nautique
Many older Nautiques use a ballast resistor on...

Many older Nautiques use a ballast resistor on the coil, but have a full voltage wire that is connected to the starting circuit of the key(bypassing the resistor). It sounds to me like your coil is...
Forum: Electrical 06-08-2016, 01:15 PM
Replies: 13
Views: 505
Posted By WA Nautique
glad you got it figured out!

glad you got it figured out!
Forum: Appearance 06-08-2016, 01:13 PM
Replies: 32
Views: 2,241
Posted By WA Nautique
that might be poly-glow... try a floor wax...

that might be poly-glow... try a floor wax stripper and see if that takes it off. Some people think that floor wax is a good solution to an oxidized finish, as it is a lot less work than actually...
Forum: Electrical 06-07-2016, 09:21 PM
Replies: 13
Views: 505
Posted By WA Nautique
So I think there are several things you should...

So I think there are several things you should check. Since you started taking things apart, and it worked before, its a good possibility that this is something caused by your work.

- battery...
Forum: Electrical 06-03-2016, 12:37 PM
Replies: 5
Views: 169
Posted By WA Nautique
I agree, you can test by accessing the back of...

I agree, you can test by accessing the back of the ignition switch and jumpering from the 12v constant terminal to the run terminal. if the engine fires and stays running, or the dash lights stay...
Forum: General Discussion 02-11-2016, 01:04 PM
Replies: 247
Views: 11,164
Posted By WA Nautique
Ski nautique 2001's were built fairly similar...

Ski nautique 2001's were built fairly similar from 82 to 89, the 89's had a 1.23 transmission and a normal rotating engine, where the earlier models were 1:1 transmission and counter rotating...
Forum: Appearance 09-29-2015, 02:01 PM
Replies: 13
Views: 1,151
Posted By WA Nautique
I like to apply the decal using a mark (painters...

I like to apply the decal using a mark (painters tape mentioned above works good), spray your solution on the hull, remove the back of the sticker paper, then place. move everything where you...
Forum: For Sale: Boats 09-14-2015, 06:00 PM
Replies: 10
Views: 1,437
Posted By WA Nautique
Moose - the 176 is a rare breed. they may board...

Moose - the 176 is a rare breed. they may board well, but were originally intended for slalom skiing and for the lower end of the cost market (2ft shorter than their 196 cousin) they do hold a...
Forum: Off Topic Discussion 08-04-2015, 04:32 PM
Replies: 8
Views: 716
Posted By WA Nautique
certain props will do that on a nautique... he...

certain props will do that on a nautique... he may have joined up on correct craft fan . com recently. there was a thread about noisy props. the other issue could be transmission whine. the...
Forum: Restorations and Refurbishments 06-05-2015, 01:03 PM
Replies: 170
Views: 36,132
Posted By WA Nautique
While I am no expert, it seems to me that this...

While I am no expert, it seems to me that this might be a flawed plan based on the way the different finishes cure... With paint, the catalyst used creates heat, causing the reducer/thinner to...
Forum: Off Topic Discussion 02-27-2015, 11:29 AM
Replies: 88
Views: 11,709
Posted By WA Nautique
trap primers automatically fill the p-trap in the...

trap primers automatically fill the p-trap in the drain with water so the traps don't dry out. If the traps dry out, you will get sewer gas penetration into the space. You can use an automatic...
Forum: Off Topic Discussion 02-26-2015, 11:44 AM
Replies: 88
Views: 11,709
Posted By WA Nautique
2 suggestions, a trap primer on your floor...

2 suggestions, a trap primer on your floor drains is easy when the plumber is there, and will keep you from having to manually prime the traps when they dry out from lack of use. Also, since you...
Forum: Off Topic Discussion 02-19-2015, 07:06 PM
Replies: 55
Views: 4,400
Posted By WA Nautique
in Washington, 3% for the listing agent and 3%...

in Washington, 3% for the listing agent and 3% for the selling agent. Plan on 4% on top for the govt. Agents earn their commissions, There is a ton of leg work that goes into every sale for a...
Forum: Off Topic Discussion 01-14-2014, 05:53 PM
Replies: 21
Views: 2,555
Posted By WA Nautique
Foam would make adding an electrical circuit or...

Foam would make adding an electrical circuit or thermostat or cable down the wall nearly impossible. Not that you couldn't do it, but it would require a sheetrock repair every time. Might be...
Forum: Off Topic Discussion 12-10-2013, 05:16 PM
Replies: 83
Views: 7,093
Posted By WA Nautique
OK, so maybe I am showing some ignorance here,...

OK, so maybe I am showing some ignorance here, but why would a Line voltage stat not work with a contactor? A contactor is just a relay to carry large current, correct? The # 8 wires to the...
Forum: Off Topic Discussion 12-10-2013, 02:43 PM
Replies: 83
Views: 7,093
Posted By WA Nautique
on the heater, run 24v from the heater...

on the heater, run 24v from the heater transformer to the R terminal on the thermostat, Connect the Common to the C terminal on the thermostat, Connect W1 on the thermostat to the w1 on the unit if...
Forum: Storage / Winterization 11-19-2013, 07:42 PM
Replies: 29
Views: 3,863
Posted By WA Nautique
been a while since I looked at this thread, sorry...

been a while since I looked at this thread, sorry for the late response.... I had my manifold off at the time, but I would suggest that a snake drill or a 90 drill adapter would get you in that...
Forum: Off Topic Discussion 11-19-2013, 04:16 PM
Replies: 41
Views: 3,661
Posted By WA Nautique
be glad it's not a VA loan.... Just do what you...

be glad it's not a VA loan.... Just do what you need to to get the house sold. The last VA contract that my wife did, the inspector required a natural cedar fence to be "painted". I am not sure...
Forum: Storage / Winterization 11-05-2013, 03:17 PM
Replies: 29
Views: 3,863
Posted By WA Nautique
I drilled out the corners of the 1/2 square...

I drilled out the corners of the 1/2 square recess with a small drill bit, then punched the center out of the steel plugs I had a couple of years ago. once the recess is a square hole, you'll be...
Showing results 1 to 25 of 32

 

All times are GMT -4. The time now is 02:17 PM.