Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: MLA
Forum: General Discussion Today, 09:20 AM
Replies: 16
Views: 433
Posted By MLA
You always fain some mid-bass output and...

You always fain some mid-bass output and extension when you go from a smaller to larger speaker.
Forum: General Discussion Today, 08:17 AM
Replies: 16
Views: 433
Posted By MLA
Well of course one could create this very...

Well of course one could create this very condition, or avoid it just as easily. In all seriousness, how low do we want to try and cross over a small tower pod?
Forum: General Discussion Yesterday, 06:02 PM
Replies: 13
Views: 284
Posted By MLA
I have a different opinion regarding the use of...

I have a different opinion regarding the use of an HLCD for near field listening, when it comes to the Rev-10. Hardly anyone is hard core into boarding these days. I see surfers and party-cove people...
Forum: Audio/Stereo Yesterday, 04:35 PM
Replies: 108
Views: 17,931
Posted By MLA
I think speaker sox will make then to your...

I think speaker sox will make then to your dimensions.
Forum: General Discussion Yesterday, 01:48 PM
Replies: 16
Views: 433
Posted By MLA
You could cross the 7.7 and 8.8 at the same...

You could cross the 7.7 and 8.8 at the same point, without over driving the 7.7 or leaving much of the 8.8 on the table so to speak. Gain setting would depend on the amp's output potential. Although...
Forum: Audio/Stereo 06-23-2018, 04:05 PM
Replies: 2
Views: 86
Posted By MLA
Sounds like there two major wiring issues. One...

Sounds like there two major wiring issues. One creating a possible ground loop and the other being the amp does not come on unless the engine is running. Is this boat new to you or has the audio...
Forum: Audio/Stereo 06-23-2018, 11:37 AM
Replies: 13
Views: 702
Posted By MLA
A polk amp would not work or work, same as any...

A polk amp would not work or work, same as any other amp will or wont. Speaker level is just another means of bringing the signal in to the amp. The difference is what the Klipsch DSP amp does with...
Forum: Audio/Stereo 06-22-2018, 08:39 PM
Replies: 8
Views: 264
Posted By MLA
The rev-8 is not a bad sounding speaker by any...

The rev-8 is not a bad sounding speaker by any means, but no amount of 8" HLCDs are going to deliver the mis-bass depth of larger 10" speaker.
Forum: Audio/Stereo 06-22-2018, 07:19 AM
Replies: 3
Views: 136
Posted By MLA
Do you have bow speakers? Are the in-boats on an...

Do you have bow speakers? Are the in-boats on an external amp?
Forum: General Discussion 06-21-2018, 06:24 PM
Replies: 16
Views: 433
Posted By MLA
Sure it will add to the overall volume/output,...

Sure it will add to the overall volume/output, adding a 2nd set of same or larger speakers.
Forum: Audio/Stereo 06-21-2018, 03:11 PM
Replies: 6
Views: 179
Posted By MLA
Nothing at all wrong with the FA, other then its...

Nothing at all wrong with the FA, other then its designed for a different setup then the HP. Since neither woofer options indicated FA/IB, I just presumed neither was.

So, not constructing an...
Forum: Audio/Stereo 06-21-2018, 12:46 PM
Replies: 6
Views: 179
Posted By MLA
Although each setup will have its own design...

Although each setup will have its own design sound signature, they both are fairly comparable. Both are 8" tower speaker, both are 10" woofers (although I dont know which JL woofer and presume the...
Forum: Audio/Stereo 06-20-2018, 09:42 AM
Replies: 268
Important: Ask Klipsch
Views: 24,854
Posted By MLA
As to the transom remote. Its designed for the...

As to the transom remote. Its designed for the Murphy ICE system, but seems a great deal of the Klipsch function is relegated to the down stream Klipsch module. Mainly the zone control. Other boats...
Forum: Audio/Stereo 06-19-2018, 08:18 PM
Replies: 3
Views: 127
Posted By MLA
There any a number of 5 and 6 chnl amps out there...

There any a number of 5 and 6 chnl amps out there that will do very nice for you. The only real tricky part, is matching the best woofer ohm configuration to get the most out of the woofer.

Wet...
Forum: Electrical 06-16-2018, 08:31 PM
Replies: 6
Views: 124
Posted By MLA
No worries about a plastic battery box/tray...

No worries about a plastic battery box/tray sitting on carpet. breaker, yeah, it could stand to be off the floor.
Forum: Audio/Stereo 06-16-2018, 07:32 PM
Replies: 1
Views: 78
Posted By MLA
Honestly, a pair of Kicker 8 coaxial and a single...

Honestly, a pair of Kicker 8 coaxial and a single pro 485 are not going to be that far off cross-over wise. Hi-pass and 80-100 hz and call it a day.

Your issue is likely trying to run three 4 ohm...
Forum: Electrical 06-16-2018, 07:25 PM
Replies: 6
Views: 124
Posted By MLA
Hard to say. if that breaker feeds the helm BUS,...

Hard to say. if that breaker feeds the helm BUS, any of the gauges could act up, not just one.
Forum: Electrical 06-16-2018, 10:19 AM
Replies: 6
Views: 124
Posted By MLA
Absolutely, and both ring terminals. Might end up...

Absolutely, and both ring terminals. Might end up having to replace the cables. As you cut back to find good clean copper, you could end up with too short of cables.
Forum: Electrical 06-16-2018, 07:29 AM
Replies: 8
Views: 149
Posted By MLA
@ida6339 This is a feature that puts a light in...

@ida6339

This is a feature that puts a light in the quality column IMO. Most that have this, state it. Some turn off to cool down, others reduce their output when too warm.
Forum: Electrical 06-15-2018, 08:48 PM
Replies: 8
Views: 149
Posted By MLA
Some lights do it a self preservation to prevent...

Some lights do it a self preservation to prevent over heating.
Forum: Electrical 06-15-2018, 07:21 PM
Replies: 8
Views: 149
Posted By MLA
Were you up on plane and likely no water on the...

Were you up on plane and likely no water on the lights?
Forum: Electrical 06-15-2018, 05:48 PM
Replies: 14
Views: 290
Posted By MLA
Yes, there are fused blocks, but the fuses are...

Yes, there are fused blocks, but the fuses are not built-in, but rather installed and need to be appropriate for the amp and branch cable gauge. Yes, you can eliminate the individual amp B+ inline...
Forum: Electrical 06-15-2018, 11:47 AM
Replies: 14
Views: 290
Posted By MLA
That is not intended for amplifiers. Its best for...

That is not intended for amplifiers. Its best for ballast pumps and other similar loads. The best practice for the 3 amps, is to run a trunk line to a distribution block, then branch lines to the...
Forum: Ballast 06-14-2018, 07:02 PM
Replies: 5
Views: 219
Posted By MLA
Those look like some rebranded old school sacs...

Those look like some rebranded old school sacs with water bed fittings. If so, id pass on them. If they have a threaded fitting, then go for it.
Forum: Electrical 06-11-2018, 08:23 AM
Replies: 1
Views: 76
Posted By MLA
If the radio is already on the IGN key switch,...

If the radio is already on the IGN key switch, your wire to the radio is already under the helm.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 09:21 AM.


2018