Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 160
Search took 0.01 seconds.
Search: Posts Made By: mcmx2
Forum: General Discussion 07-10-2016, 01:11 PM
Replies: 17
Views: 584
Posted By mcmx2
I do not know much about the x-30 but I have an...

I do not know much about the x-30 but I have an 05 197TT with the LQ9 engine. The engine itself has been flawless and has just over 1200 hours on it. It does like to go through spark plugs. Once...
Forum: Underwater Running Gear 07-05-2016, 03:25 PM
Replies: 38
Views: 1,493
Posted By mcmx2
H2O, I just sent you a PM.

H2O, I just sent you a PM.
Forum: Trailers 07-05-2016, 03:06 PM
Replies: 8
Views: 1,955
Posted By mcmx2
I have a trailer being made and will be parting...

I have a trailer being made and will be parting out my old one at the end of the month. If you can wait until then I will sell you mine.
Forum: General Discussion 06-24-2016, 12:16 PM
Replies: 8
Views: 404
Posted By mcmx2
http://www.ballofspray.com/forum#/discussion/5822/...

http://www.ballofspray.com/forum#/discussion/5822/ski-photos-that-just-make-you-happy

Over on the Ball of Spray forum there is a gentleman who is disabled. He has been that way since shortly after...
Forum: General Discussion 06-22-2016, 11:33 AM
Replies: 3
Views: 176
Posted By mcmx2
http://greatlakesskipper.com/cruiser-yachts-stainl...

http://greatlakesskipper.com/cruiser-yachts-stainless-steel-boat-bimini-top-quick-release-hinge-bracket-mount-pair

This is what is on mine and came from the factory that way. The gray piece that...
Forum: General Discussion 06-21-2016, 04:11 PM
Replies: 13
Views: 846
Posted By mcmx2
It is possible that you did not really run out of...

It is possible that you did not really run out of gas. If your pump is an original in an 06 it is likely that the pump failed and you just thought you ran out of fuel if it was low. Check the fuel...
Forum: General Discussion 06-11-2016, 09:44 AM
Replies: 3
Views: 230
Posted By mcmx2
Need some help locating a trailer

I had a trailer fail last night under my 2005 197TT. The rails are actually failing above the axle and starting to fold in. I know it looks like a lot of rust but it seems to be surface rust even...
Forum: General / Other 06-09-2016, 02:04 PM
Replies: 1
Views: 136
Posted By mcmx2
Mine is back under the floor next to where the...

Mine is back under the floor next to where the prop shaft goes through the hull.
Forum: Towers 06-08-2016, 09:20 PM
Replies: 7
Views: 418
Posted By mcmx2
This will do the trick.

This will do the trick.
Forum: Wanted to Buy 06-02-2016, 03:51 PM
Replies: 1
Views: 224
Posted By mcmx2
This is off of my 05 TT. I upgraded it in 08 and...

This is off of my 05 TT. I upgraded it in 08 and it was working fine when it was removed. Let me know if you are interested.
Forum: For Sale: Boats 06-02-2016, 11:01 AM
Replies: 14,185
Views: 2,262,992
Posted By mcmx2
Yes, in 08 the TT boats had both zero off and PP.

Yes, in 08 the TT boats had both zero off and PP.
Forum: Wanted to Buy 05-17-2016, 02:39 PM
Replies: 1
Views: 152
Posted By mcmx2
I have a single line display, It came out of my...

I have a single line display, It came out of my 2005 but should work just fine for you. I took it out in 2008 when I upgraded my PP system. It is not exactly what you are looking for as the color is...
Forum: General Discussion 05-02-2016, 10:24 PM
Replies: 5
Views: 405
Posted By mcmx2
I have an 05 197. If you are talking about the...

I have an 05 197. If you are talking about the zipper that runs across the back side of the bimini mine has an extension that connects at the back of the main bimini to keep sun off the back of the...
Forum: Electrical 04-18-2016, 03:47 PM
Replies: 6
Views: 325
Posted By mcmx2
We are talking about the same part I am probably...

We are talking about the same part I am probably using the wrong terminology.
Forum: Electrical 04-18-2016, 03:29 PM
Replies: 6
Views: 325
Posted By mcmx2
http://www.mouser.com/ProductDetail/BEI-Sensors/98...

http://www.mouser.com/ProductDetail/BEI-Sensors/9861R5KL20/?qs=y%252bTtbMcwHOmUDGism%2f8OiiH4uLrY1dziY9cxcY3gPG8kxcDojESlYA%3d%3d

Here is what you need I believe. The throttle position sensor goes...
Forum: Towers 03-02-2016, 09:26 PM
Replies: 136
Views: 23,582
Posted By mcmx2
Put me down for a set.

Put me down for a set.
Forum: Electrical 07-03-2015, 06:25 AM
Replies: 4
Views: 499
Posted By mcmx2
2005 was the first year of the drive by wire...

2005 was the first year of the drive by wire system. The perfect pass on mine does not use a throttle cable but uses the computer to control the engine speed. If you have the base engine you still...
Forum: For Sale: Parts & Accessories 06-29-2015, 09:18 PM
Replies: 6
Views: 366
Posted By mcmx2
I sent you a PM.

I sent you a PM.
Forum: For Sale: Parts & Accessories 06-29-2015, 09:03 PM
Replies: 6
Views: 366
Posted By mcmx2
I have a coupling that is off of an 05 ProStar. ...

I have a coupling that is off of an 05 ProStar. I believe it is the same one you are looking for, Let me know if you are interested. I bought it for the exact reason you are stating, needed a shaft...
Forum: Engine / Drive Train 06-16-2015, 06:41 PM
Replies: 6
Views: 562
Posted By mcmx2
Gates K060760 is the part number on my LQ9. Any...

Gates K060760 is the part number on my LQ9. Any auto parts store should be able to cross it over if they do not carry Gates belts.
Forum: Engine / Drive Train 06-15-2015, 09:32 AM
Replies: 6
Views: 562
Posted By mcmx2
I can get you the gates belt number tonight when...

I can get you the gates belt number tonight when I get to the house. Let me know if you still need it. You can pick one up at any auto parts store.
Forum: Engine / Drive Train 05-20-2015, 01:29 PM
Replies: 731
Important: Fuel Pump 101
Views: 160,876
Posted By mcmx2
I have the 6.0 LQ9 on a 2005 197. The airtec...

I have the 6.0 LQ9 on a 2005 197. The airtec 2044 has been on my boat for over 800 hours now. I replaced the original around 300 hours and am now just under 1100. I bought a spare right after the...
Forum: General Discussion 04-18-2015, 03:07 PM
Replies: 5
Views: 1,403
Posted By mcmx2
This is the 14" cover, it is the one you are...

This is the 14" cover, it is the one you are looking for I believe however to see and image of it you have to google the image. The image link does take you to this page. ...
Forum: Wanted to Buy 03-12-2015, 05:00 PM
Replies: 10
Views: 1,003
Posted By mcmx2
It will fit as long as you have the 1-1/8" prop...

It will fit as long as you have the 1-1/8" prop shaft.
Forum: Wanted to Buy 03-12-2015, 01:52 PM
Replies: 10
Views: 1,003
Posted By mcmx2
I have a 13.7 x 17.5 OJ I would part with.

I have a 13.7 x 17.5 OJ I would part with.
Showing results 1 to 25 of 160

 

All times are GMT -4. The time now is 09:01 AM.