Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 437
Search took 0.02 seconds.
Search: Posts Made By: KahunaCraft
Forum: Tow Vehicles 07-13-2014, 09:47 PM
Replies: 53
Views: 3,659
Posted By KahunaCraft
New Dodge 3.0L V6 Eco-Diesel

Test drove one last week, very impressed. Smooth power and quiet. I drove it a mix of hwy and city and saw 25 mpg. More hwy and a little less 'testing' of the acceleration and it would have been...
Forum: General Discussion 07-06-2014, 10:02 AM
Replies: 20
Views: 799
Posted By KahunaCraft
My advice... No try no weight in the bow,...

My advice... No try no weight in the bow, everything to the back corner or on the bench of the surf side. Center plate should be at less than 30%.
Forum: Wakesurfing 06-30-2014, 05:00 PM
Replies: 17
Views: 1,539
Posted By KahunaCraft
Thanks, nice wave.

Thanks, nice wave.
Forum: Wakesurfing 06-30-2014, 01:05 PM
Replies: 17
Views: 1,539
Posted By KahunaCraft
Wonder if you could share a pic of the surf wave...

Wonder if you could share a pic of the surf wave with that setup?
Forum: Ballast 06-29-2014, 05:49 PM
Replies: 11
Views: 545
Posted By KahunaCraft
My advice, don't piggy off the center tank unless...

My advice, don't piggy off the center tank unless you know how to vent it properly. If you mess up the venting, you'll collapse the hard tank and it will crack. That is a big problem that you'll want...
Forum: Electrical 06-29-2014, 08:57 AM
Replies: 28
Views: 906
Posted By KahunaCraft
Increased Medallion Failures with .54

I believe you could pull the screen completely.

You'd have to find the dash part that covers the hole. I'd put timers on the pumps and zero off in and drop the screen before I'd pay 3200 to replace...
Forum: General Discussion 06-29-2014, 08:54 AM
Replies: 20
Views: 937
Posted By KahunaCraft
When they upgraded mine, they changed the speedo...

When they upgraded mine, they changed the speedo and they added the puck.
Forum: Ballast 06-29-2014, 07:25 AM
Replies: 11
Views: 545
Posted By KahunaCraft
I believe that the 1" only supports one jabsco at...

I believe that the 1" only supports one jabsco at a time. You will burn impellers running two, go extra thru hull and save a lot of time.

You can get a double seacock thru hull and add two pumps to...
Forum: Engine / Drive Train 06-22-2014, 09:26 PM
Replies: 8
Views: 261
Posted By KahunaCraft
Might be up up down down. Sorry, it's a really...

Might be up up down down. Sorry, it's a really simple combination.

Pretty sure it was up down up down. I don't have my 2012 anymore, but had all the problems you speak of. Dealer ended up resetting...
Forum: Engine / Drive Train 06-22-2014, 07:55 PM
Replies: 8
Views: 261
Posted By KahunaCraft
Make sure it is three or four up/down's ... Also...

Make sure it is three or four up/down's ... Also note that some codes will NOT reset unless the ECM is connected by a dealer.
Forum: Engine / Drive Train 06-21-2014, 11:12 PM
Replies: 8
Views: 261
Posted By KahunaCraft
Up down up down up down ....

Up down up down up down ....
Forum: General Discussion 06-21-2014, 11:10 PM
Replies: 20
Views: 937
Posted By KahunaCraft
12 x-25

Btw the zero off puck for gps will not provide navi/chart plotting functionality for the boat. It is just for cruise.
Forum: General Discussion 06-15-2014, 07:25 PM
Replies: 535
Views: 23,541
Posted By KahunaCraft
Good point...I never did the math...

Good point...I never did the math...
Forum: General Discussion 06-14-2014, 03:01 AM
Replies: 18
Views: 750
Posted By KahunaCraft
I used an acme 1285 and it worked like a charm.

I used an acme 1285 and it worked like a charm.
Forum: General Discussion 06-13-2014, 10:45 PM
Replies: 535
Views: 23,541
Posted By KahunaCraft
The X30 will fit 1100# sacs in the rear lockers.

The X30 will fit 1100# sacs in the rear lockers.
Forum: General Discussion 06-08-2014, 08:43 AM
Replies: 5
Views: 300
Posted By KahunaCraft
I'd take the platform off and inspect the hole...

I'd take the platform off and inspect the hole that the pins go through, they may be worn out a bit, that could create the 'play' you're speaking of.

I ended up adding three bolts on each bracket...
Forum: General Discussion 06-07-2014, 05:25 AM
Replies: 10
Views: 478
Posted By KahunaCraft
I had mine on what you describe as the narrow...

I had mine on what you describe as the narrow setting because that provided better clearance for the lifting cross-bar which is under the bunks.

One thing that went wrong was the bunk itself was on...
Forum: General Discussion 06-01-2014, 04:40 PM
Replies: 10
Views: 560
Posted By KahunaCraft
I'd also add that Mastercraft was first class...

I'd also add that Mastercraft was first class with warranty on my 2012.
Forum: General Discussion 06-01-2014, 04:37 PM
Replies: 10
Views: 560
Posted By KahunaCraft
2013 Mastercraft Warranty?

http://www.mastercraft.com/assets/manual/3.pdf


Skip to page 169...


2.3
Other Component Parts (Excluding Engine and Transmission). MasterCraft provides the following warranties for other component...
Forum: For Sale: Parts & Accessories 04-27-2014, 06:37 PM
Replies: 4
Views: 542
Posted By KahunaCraft
Sold!

Sold!
Forum: For Sale: Parts & Accessories 04-27-2014, 04:56 AM
Replies: 4
Views: 542
Posted By KahunaCraft
Rear Facing Mastercraft LED lights

They are off a 2012 ZFT-4
http://img.tapatalk.com/d/14/04/27/8u4amyvy.jpg
Forum: For Sale: Boats 04-26-2014, 06:29 PM
Replies: 23
Views: 1,473
Posted By KahunaCraft
MC and my dealer were very good to me over the...

MC and my dealer were very good to me over the last 18 months. We'll see what the future holds.
Forum: For Sale: Boats 04-26-2014, 05:21 PM
Replies: 23
Views: 1,473
Posted By KahunaCraft
Thanks all. It worked out well. I kept my rear...

Thanks all. It worked out well. I kept my rear facing lights and am selling them if anyone is interested... Other post covers it
Forum: For Sale: Parts & Accessories 04-26-2014, 02:57 PM
Replies: 4
Views: 542
Posted By KahunaCraft
Rear Facing Mastercraft LED lights

These fit the newer towers and are from MC by design.

Price is 800 USD plus shipping. They are a 1750.00 option.


109969
Forum: For Sale: Boats 04-26-2014, 02:51 PM
Replies: 23
Views: 1,473
Posted By KahunaCraft
Sold.

Sold.
Showing results 1 to 25 of 437

 

All times are GMT -4. The time now is 05:27 PM.