Go Back   TeamTalk > Search Forums

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: uski
Forum: Electrical 07-19-2013, 02:54 PM
Replies: 11
Views: 786
Posted By uski
I seem to have a short someplace else that is...

I seem to have a short someplace else that is causing overall problems. I went through the entire ignition following all of the purple wires. I was actually losing most of the volts between the...
Forum: Electrical 07-18-2013, 06:09 PM
Replies: 11
Views: 786
Posted By uski
Nope, jumping the battery wire and ignition wire...

Nope, jumping the battery wire and ignition wire at the ignition switch do not turn the engine light or gauges on.

Interestingly enough, when I was done playing around with the ignition switch, the...
Forum: Electrical 07-18-2013, 05:01 PM
Replies: 11
Views: 786
Posted By uski
Yes, I cleaned the ground bar, the wires, and the...

Yes, I cleaned the ground bar, the wires, and the positive connections under the dash. When I test the positive point under the dash with the ground bar I get 12.5 volts. I have also cleaned every...
Forum: Electrical 07-18-2013, 03:02 PM
Replies: 11
Views: 786
Posted By uski
The back of the ignition switch has two wires...

The back of the ignition switch has two wires connected to a couple of the out pins. Sad to say, I already put in a new MDC box and that did not fix the issue. When the electrical issues started...
Forum: Electrical 07-18-2013, 02:29 PM
Replies: 11
Views: 786
Posted By uski
Yes, I checked the lanyard. thanks!

Yes, I checked the lanyard. thanks!
Forum: Electrical 07-18-2013, 01:51 PM
Replies: 11
Views: 786
Posted By uski
Also... I already replaced the ignition switch...

Also... I already replaced the ignition switch and the ignition breaker under the dash. The inline fuse at the switch is fine.
Forum: Electrical 07-18-2013, 01:39 PM
Replies: 11
Views: 786
Posted By uski
2001 XStar no gauge power, no engine light, boat wont start

Hi Everyone,

I have a 2001 XStar with the standard engine. When I turn the key to the start position, I only get ~1.3 volts coming out on the out pin of the ignition switch, although I get 12.5 as...
Showing results 1 to 7 of 7

 

All times are GMT -4. The time now is 11:39 PM.