Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 276
Search took 0.35 seconds.
Search: Posts Made By: Philscbx
Forum: Engine / Drive Train 07-30-2014, 09:05 PM
Replies: 46
Views: 1,380
Posted By Philscbx
Yea - someone needed a ECM real bad - just too...

Yea - someone needed a ECM real bad - just too bad it wasn't his boat that needed it.

May have to - alway code devices before bringing it in - with last 4 of SSN.
Forum: Engine / Drive Train 07-30-2014, 08:49 PM
Replies: 46
Views: 1,380
Posted By Philscbx
Don't let anything happen to the old cap - if...

Don't let anything happen to the old cap - if possible.
Photo CSI grade if possible.

Usually High Voltage tracking can be seen underside.

60,000 volts - just like lightning will make micro trails...
Forum: Engine / Drive Train 07-30-2014, 04:20 PM
Replies: 10
Views: 395
Posted By Philscbx
Thanks Much - Forwarded PDF form. to collect...

Thanks Much -

Forwarded PDF form.
to collect data.

Cheers
Forum: Engine / Drive Train 07-30-2014, 03:18 PM
Replies: 10
Views: 395
Posted By Philscbx
That's Great News Mike - I just talked to...

That's Great News Mike -

I just talked to partner to try to intercept the shipment and have it NextDay Air back before they touch it.

Thanks Again,
Phil
Forum: Engine / Drive Train 07-30-2014, 02:18 PM
Replies: 10
Views: 395
Posted By Philscbx
Wow, thats pretty cool. It would be massive...

Wow, thats pretty cool.
It would be massive quantities of brew that's for sure.

I'll hit him up with email to see just where it is for the heck of it.

Thanks for that hit of hope Tim.
Cheers
Forum: General / Other 07-30-2014, 01:53 PM
Replies: 5,259
Views: 468,242
Posted By Philscbx
The sand is more than likely iron oxide crystals...

The sand is more than likely iron oxide crystals formed by high moisture trapped over long period.
Long term cold storage is good at this.
Especially below zero.

Test sample pile with magnet screw...
Forum: Engine / Drive Train 07-30-2014, 01:40 PM
Replies: 10
Views: 395
Posted By Philscbx
Thanks Mike - Just received an update - they are...

Thanks Mike -

Just received an update - they are sending unit to California to be re-flashed - $400 I guess.
That's the only details I have right now.

I'll have to test the issue about the battery,...
Forum: Engine / Drive Train 07-30-2014, 08:09 AM
Replies: 9
Views: 634
Posted By Philscbx
Just throwing out an Idea flash - What about the...

Just throwing out an Idea flash -

What about the aluminum fresh air intake tubes they sell - and they are polished even.
Seems like every auto supplier has these tubes hanging the entire wall.
Not...
Forum: Engine / Drive Train 07-30-2014, 08:04 AM
Replies: 18
Views: 682
Posted By Philscbx
From what others suggested - a listening stick is...

From what others suggested - a listening stick is best.

But to narrow it down a little -
the noise seems to be short phase pulse - then quits - then comes on again.

My first guess is alternator...
Forum: Engine / Drive Train 07-30-2014, 07:48 AM
Replies: 10
Views: 395
Posted By Philscbx
ECM Needed 04' 209

I was just notified my 04's ecm is toast -

Did a little search - Ebay = $1000.00 - For real? - for a $100 box.
Can't be that special.

Maybe 3-4 short tours - Being Minnesota. Stored in heated....
Forum: Engine / Drive Train 07-30-2014, 07:11 AM
Replies: 1
Views: 213
Posted By Philscbx
You Too huh - I was just notified my 04's ecm is...

You Too huh -

I was just notified my 04's ecm is toast -

Did a little search - Ebay = $1000.00 for a $100 box. Somethings up with that. Can't be that special.

Is this for real? Must be where the...
Forum: Upholstery 07-02-2013, 07:59 PM
Replies: 4
Views: 622
Posted By Philscbx
wow, Thanks - I was afraid of that. The kids...

wow, Thanks - I was afraid of that.

The kids took it upnorth - so I haven't had time to try the impossible through the speaker hole that far up.

A quick peak under the dash - didn't look doable -...
Forum: General / Other 06-29-2013, 10:51 PM
Replies: 5,259
Views: 468,242
Posted By Philscbx
There are quite a few places - One I used -...

There are quite a few places -
One I used - http://www.superbrightleds.com/cat/boat-rv/
Forum: Upholstery 06-29-2013, 10:14 AM
Replies: 4
Views: 622
Posted By Philscbx
Maybe have to head over to boat shop perhaps - or...

Maybe have to head over to boat shop perhaps - or figure out who to contact at Mastercraft.
Sent message to http://www.mastercraft.com/
Forum: Upholstery 06-29-2013, 07:33 AM
Replies: 10
Views: 1,354
Posted By Philscbx
My 2004 209 was already in this crack condition...

My 2004 209 was already in this crack condition when purchased couple years ago.

JUst installed all new, the worst 1/2 of it all replaced with same stuff - pattern - stitching.
It all looked just...
Forum: Upholstery 06-28-2013, 06:03 PM
Replies: 4
Views: 622
Posted By Philscbx
04 209 Bow Handrail

Howdy -
Sitting in the driveway totally stumped how to remove bow seat back cushion along
the sides - to replace missing bolt/stud holding handrail on topside gunnel.

Tried to lift cushion-back...
Forum: Appearance 06-20-2013, 10:02 PM
Replies: 533
Views: 93,174
Posted By Philscbx
I'm going to drive down there right now to see if...

I'm going to drive down there right now to see if our local Menards has it -
Actually - A floor sander is the first thing I thought of using -
I grew up with those 300lb machines.

Making a...
Forum: Appearance 06-20-2013, 09:54 PM
Replies: 533
Views: 93,174
Posted By Philscbx
I'm doing my sanding makeover again - Last year,...

I'm doing my sanding makeover again -
Last year, partner dropped off the Star Brite 3 step -

Belt sanded it clean - coated the final teak oil on - install platform.
It looked like a joke from the...
Forum: General / Other 06-20-2013, 08:48 PM
Replies: 5,259
Views: 468,242
Posted By Philscbx
I'm doing my sanding makeover again - last year,...

I'm doing my sanding makeover again - last year, partner dropped off the Star Brite 3 step -

Belt sanded it clean - coated the final teak oil on - install platform.
It looked like a joke from the...
Forum: Towers 02-22-2013, 04:20 AM
Replies: 38
Views: 5,579
Posted By Philscbx
Quite The System,, there are lower profile billet...

Quite The System,, there are lower profile billet clamp profiles.

I'll gather links I'm sure I have just in case.
Forum: Audio/Stereo 07-31-2012, 12:31 AM
Replies: 2
Views: 718
Posted By Philscbx
Not quite sure w/o looking - but there's a couple...

Not quite sure w/o looking - but there's a couple ways dealing with epoxy in difficult small areas.
Source - Hobby store has shredded glass in small amounts to mix in with the resin prior to...
Forum: General Discussion 07-30-2012, 09:57 PM
Replies: 19
Views: 1,407
Posted By Philscbx
I posted that one a few weeks ago - I can't image...

I posted that one a few weeks ago - I can't image the water intrusion to every connection.
Probably wanted final bilge flush.
Forum: General / Other 07-28-2012, 06:50 AM
Replies: 34
Views: 3,850
Posted By Philscbx
Is the raw water pump in front of engine - or...

Is the raw water pump in front of engine - or behind it - or is the strainer after the cooler?
I've made up my mind to filter the cooler.
Forum: Off Topic Discussion 07-27-2012, 12:40 AM
Replies: 7
Views: 1,440
Posted By Philscbx
http://www.youtube.com/watch?v=O7-s_mdEPb0 For...

http://www.youtube.com/watch?v=O7-s_mdEPb0
For some reason-this video link is unlisted I just discovered-hopefully it will work here.
Forum: Off Topic Discussion 07-27-2012, 12:22 AM
Replies: 7
Views: 1,440
Posted By Philscbx
I know, I felt this as well as a kid when my hand...

I know, I felt this as well as a kid when my hand was in the water, and I wasn't sure what to think, but I suspect it was the dock light, and never dove in.
Showing results 1 to 25 of 276

 

All times are GMT -4. The time now is 05:20 AM.