Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 131
Search took 0.01 seconds.
Search: Posts Made By: Legolamb
Forum: Engine / Drive Train 09-13-2018, 07:59 AM
Replies: 6
Views: 253
Posted By Legolamb
Grab the fiberglass kit at Walmart, clean and...

Grab the fiberglass kit at Walmart, clean and scuff up areas where they are leaking and add a couple layers, spray paint black when dry. Very easy repair, the biggest part of the job is getting the...
Forum: Trailers 06-18-2018, 07:29 AM
Replies: 2
Views: 412
Posted By Legolamb
Nice write-up and pics Chris, thanks.

Nice write-up and pics Chris, thanks.
Forum: Engine / Drive Train 06-18-2018, 07:25 AM
Replies: 5
Views: 195
Posted By Legolamb
Mine is the same way, star-bird side is much...

Mine is the same way, star-bird side is much hotter.
Forum: Trailers 06-13-2018, 08:33 AM
Replies: 19
Views: 897
Posted By Legolamb
Bearings & races are typically available at Napa...

Bearings & races are typically available at Napa and many other retail locations as noted above, but the correct double lip seals, which should be used on boat trailers, may not be available at Napa...
Forum: Engine / Drive Train 05-22-2018, 07:31 AM
Replies: 10
Views: 963
Posted By Legolamb
Have you considered draining your LT-1(or any...

Have you considered draining your LT-1(or any engine) and storing it dry? It takes about 10 minutes to pull plugs and hoses to drain all the water, and it's ready for storage. I've been doing this...
Forum: Trailers 09-14-2017, 07:23 AM
Replies: 15
Views: 4,000
Posted By Legolamb
I have a set of Classic wheel covers from Amazon...

I have a set of Classic wheel covers from Amazon I bought last year, and am very happy with them. They fit well, are easy to get on and off, and they stay on in all weather conditions.
Forum: For Sale: Parts & Accessories 07-08-2017, 09:44 PM
Replies: 1
Views: 593
Posted By Legolamb
Sold, thanks Jimmy.

Sold, thanks Jimmy.
Forum: For Sale: Parts & Accessories 07-07-2017, 05:45 PM
Replies: 1
Views: 593
Posted By Legolamb
JL Audio Bluetooth Receiver MBT-RX

Brand new, discovered I don't have the correct Aux RCA inputs on my head unit. Package was opened but receiver was never used. $35 shipped in lower 48.
Thanks,
Dave
Forum: Audio/Stereo 06-28-2017, 08:13 AM
Replies: 17
Views: 2,347
Posted By Legolamb
JL adapter power

For you guys using the JL Audio adapter, are you wiring in a switch to turn the unit off? Based on only a power and ground wire, I would think the adapter is always on and may drain your battery if...
Forum: Trailers 05-11-2017, 07:37 AM
Replies: 8
Views: 1,598
Posted By Legolamb
There is normally a gap between your drum and the...

There is normally a gap between your drum and the backing plate, and the seal wouldn't have affected that distance, as long as your seal was installed flush with the hub. As long as there is no...
Forum: Trailers 05-09-2017, 01:29 PM
Replies: 3
Views: 523
Posted By Legolamb
Send a message to thatsmrmastercraft, I think he...

Send a message to thatsmrmastercraft, I think he had access to these for a very reasonable price.
Forum: Engine / Drive Train 05-09-2017, 08:04 AM
Replies: 9
Views: 1,247
Posted By Legolamb
Water pump Impeller from China

Has anyone tried a $10 Ebay impeller, and if so any good/bad experiences. I'm usually not one to skimp on a $30 part, and I also like to support local businesses, or at least businesses within the...
Forum: Trailers 05-08-2017, 07:46 AM
Replies: 8
Views: 1,598
Posted By Legolamb
I think the seal you need is UFP 07027U, which is...

I think the seal you need is UFP 07027U, which is a 1.688" x 2.328" The 2.56" OD seal is going to be too big.
http://www.easternmarine.com/ufp-1-68-id-grease-seal-32372
or Waymires.net, but you...
Forum: Engine / Drive Train 04-27-2017, 07:55 AM
Replies: 14
Views: 1,934
Posted By Legolamb
For your bearing buddy you can use a center punch...

For your bearing buddy you can use a center punch on the inside edge of the buddy, make a couple of punches 90 degrees apart, so there is a small tit on the exterior edge that slides into your hub. ...
Forum: Wanted to Buy 04-25-2017, 08:26 AM
Replies: 8
Views: 1,525
Posted By Legolamb
Check your local Ace Hardware in the hardware...

Check your local Ace Hardware in the hardware bins. Bring one of yours with to verify bolt size, and the knobs press onto the correct size hex head stainless bolt.
Forum: Engine / Drive Train 04-19-2017, 08:20 AM
Replies: 14
Views: 1,934
Posted By Legolamb
I have the same year boat and trailer, and...

I have the same year boat and trailer, and essentially the same story with hub heat. I chased the heat problem for two seasons, replacing bearings several times, and eventually all other brake...
Forum: General Discussion 03-16-2017, 07:16 AM
Replies: 16
Views: 1,667
Posted By Legolamb
Use a screwdriver to try and work under and...

Use a screwdriver to try and work under and around the hose to break the bond.
Forum: Engine / Drive Train 10-31-2016, 08:41 AM
Replies: 30
Views: 5,465
Posted By Legolamb
Would you be so kind as to take some pictures and...

Would you be so kind as to take some pictures and document your repair?
Forum: General Discussion 09-29-2016, 07:39 AM
Replies: 47
Views: 8,095
Posted By Legolamb
I had Maxxis on my fishing boat trailer, they...

I had Maxxis on my fishing boat trailer, they didn't sit in the sun and the trailer sat on blocks during the winter. I checked the tire pressure prior to trailering anywhere, and I had one of the...
Forum: Off Topic Discussion 09-16-2016, 07:47 AM
Replies: 68
Views: 8,262
Posted By Legolamb
Very cool Bret, thanks for sharing.

Very cool Bret, thanks for sharing.
Forum: Off Topic Discussion 09-15-2016, 07:46 AM
Replies: 62
Views: 14,569
Posted By Legolamb
Canadian Musky

Canadian Musky
Forum: Engine / Drive Train 09-15-2016, 07:33 AM
Replies: 35
Views: 3,418
Posted By Legolamb
I used this one for the first time this year, and...

I used this one for the first time this year, and it works great. Not a single drop...
Forum: Trailers 08-19-2016, 08:02 AM
Replies: 8
Views: 910
Posted By Legolamb
Call Waymire Distributing in Indianapolis, IN to...

Call Waymire Distributing in Indianapolis, IN to see if they ship to you. They definitely have all the bearings and double lip marine seals you need for UFP products....
Forum: General Discussion 08-19-2016, 07:33 AM
Replies: 16
Views: 1,616
Posted By Legolamb
I have a small box fan on a timer, runs 2 hours a...

I have a small box fan on a timer, runs 2 hours a day and keeps everything dry and mold free.
Forum: Trailers 08-16-2016, 08:24 AM
Replies: 9
Views: 2,251
Posted By Legolamb
Thanks Guys, I feel better about my hub temps...

Thanks Guys, I feel better about my hub temps although I wish they ran as cool as my trailer without brakes. So about 50 degrees warmer than ambient temps seems to be normal. D2jp, I do know that...
Showing results 1 to 25 of 131

 

All times are GMT -4. The time now is 11:05 PM.


2018