Go Back   TeamTalk > Search Forums

Showing results 1 to 20 of 20
Search took 0.00 seconds.
Search: Posts Made By: LotusV8
Forum: Engine / Drive Train 11-23-2014, 04:24 PM
Replies: 4
Views: 249
Posted By LotusV8
All, I took JimN's advice.....was able to get a...

All,

I took JimN's advice.....was able to get a loaner fuel presser testing kit form AutoZone (Thanks AZ), Test key on Engine off was 42lbs, idling 40lbs.

Replaced the metal fuel filter after pump,...
Forum: Engine / Drive Train 11-09-2014, 09:01 PM
Replies: 4
Views: 249
Posted By LotusV8
1997 Maristar LT-1 Loss of Power

Hi All,

I took the boat out for a little test run to to check a few things......ran it for about 5 - 10 minutes and then noticed a severe loss of power. I was unable to get above 3000rpm.

The temp...
Forum: Engine / Drive Train 11-06-2014, 11:01 PM
Replies: 3
Views: 190
Posted By LotusV8
1997 Maristar Shift Control - Help

Jayhawk,

Thank you for the catalog, I was able to find a very simular shift lever and identify the part i'm looking for.
I will contact Teleflex tomorrow.

Thanks for your help.

119908
Forum: Engine / Drive Train 11-06-2014, 09:02 PM
Replies: 3
Views: 190
Posted By LotusV8
1997 Maristar Shift Control - Help

Good Evening,

I have a new to me 1997 MC Maristar 225vrs, first V-Drive for me.

The problem is my shift / throttle handle is missing the nut, bolt, screw etc that holds it in place on the shaft and...
Forum: General / Other 11-05-2014, 10:20 AM
Replies: 1
Views: 174
Posted By LotusV8
MC Mechanic Recommendations - N. Atlanta Area

Good Morning,

I'm looking for a recommendation on a mechanic with MC knowledge in the north Atlanta area that I can take my 1997 Maristar 225V Lt-1 for maintenance and repairs as needed.
This...
Forum: Restorations and Refurbishments 06-08-2013, 03:20 PM
Replies: 19
Views: 3,684
Posted By LotusV8
GWeaver, I wish I you had posted this 2 weeks...

GWeaver,

I wish I you had posted this 2 weeks earlier......I have been working on the same fix but your documentation is awesome!
My wife recommended I cut the Styrofoam seat with an electric...
Forum: Restorations and Refurbishments 03-03-2013, 01:13 PM
Replies: 6
Views: 2,067
Posted By LotusV8
Ski pole is out and center board removed. Thanks...

Ski pole is out and center board removed.

Thanks for all the help!

LotusV8
Forum: Restorations and Refurbishments 03-03-2013, 01:08 PM
Replies: 0
Views: 620
Posted By LotusV8
1989 PS 190 Used Seat Patterns

Hi all,

I'm working on my interior and the driver seat and rear bench seat have been reupholstered years ago by previous owner.
The original skins are long gone and the replacement covers are not to...
Forum: Restorations and Refurbishments 02-09-2013, 09:02 PM
Replies: 6
Views: 2,067
Posted By LotusV8
1989 Prostar Ski Pylon/Pole Removal

I'm replacing my carpet and need help on removing the ski pole in order to remove center wood plank.

I have loosened the U clamps but do not know what to do next.

I see many of you guys remove them...
Forum: Engine / Drive Train 07-29-2012, 07:32 PM
Replies: 0
Views: 270
Posted By LotusV8
Pro Star 1989 Exhaust issue maybe?

All,

I was cleaning the back of the boat today and realized my exhaust flapper seemed loose, upon removal I found it to be melted on the right side. I realize it is exhaust and it gets hot but this...
Forum: For Sale: Watersports Equipment 07-16-2012, 05:37 PM
Replies: 2
Views: 858
Posted By LotusV8
Can you send me a picture of the board,...

Can you send me a picture of the board, Thanks

Vettefest1@yahoo.com
Forum: Engine / Drive Train 07-01-2012, 05:22 PM
Replies: 4
Views: 521
Posted By LotusV8
Thank you both for the information, looks like my...

Thank you both for the information, looks like my next project!
Forum: Engine / Drive Train 07-01-2012, 03:49 PM
Replies: 4
Views: 521
Posted By LotusV8
Please help me identify this picture

All,

I know this has fuel running through it, I expect it is some type of filter. I have done a search but not able to identify this or what maintenence it requires.

It is on my 1989 Prostar 190 -...
Forum: Trailers 06-30-2012, 08:36 PM
Replies: 2
Views: 873
Posted By LotusV8
I removed my bearings last week and took them to...

I removed my bearings last week and took them to Napa, they were able to match them in about 10 minutes.
Cost about $20.00 per wheel.
Forum: Engine / Drive Train 06-30-2012, 08:30 PM
Replies: 14
Views: 1,592
Posted By LotusV8
Guys, Thanks very much for the information, I...

Guys,

Thanks very much for the information, I will replace the thermostat.
Forum: Engine / Drive Train 06-30-2012, 08:16 AM
Replies: 14
Views: 1,592
Posted By LotusV8
1989 Prostar running 180 degrees - too warm?

All,

My 1989 Prostar 190 with Indmar 351 is consistantly running 175 - 180 degrees, this just seems a little high to me.

What is normal operating temp for this model?

Thanks in advance for any...
Forum: Appearance 06-23-2012, 05:05 PM
Replies: 140
Views: 17,190
Posted By LotusV8
We need to see the finished product........ Im...

We need to see the finished product........ Im betting it looks brand new!
Forum: Engine / Drive Train 06-22-2012, 06:37 PM
Replies: 6
Views: 414
Posted By LotusV8
All, Thanks very much for the good information,...

All,

Thanks very much for the good information, I plan on checking into a new prop and repairing the existing one.

Much appreciated!
Forum: Engine / Drive Train 06-22-2012, 09:26 AM
Replies: 6
Views: 414
Posted By LotusV8
Most Interesting Man... The transmission tag is...

Most Interesting Man...

The transmission tag is stamped velevt drive 1:1.
Forum: Engine / Drive Train 06-22-2012, 08:09 AM
Replies: 6
Views: 414
Posted By LotusV8
Newbie needs Prop help - 89 Prostar

Good morning,

I'm new around here and new to MC, can someone tell me the correct prop size, pitch, bore and direction (any necessary specs) for a 1989 Prostar 190, or where I can go look for...
Showing results 1 to 20 of 20

 

All times are GMT -4. The time now is 07:28 AM.