Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 62
Search took 0.01 seconds.
Search: Posts Made By: PureInboards
Forum: Engine / Drive Train 08-12-2014, 04:57 PM
Replies: 17
Views: 588
Posted By PureInboards
Take a fuel can out with you and empty glas...

Take a fuel can out with you and empty glas container. When it does it again remove the fuel filter, empty into glass and full with fresh gas rom fuel can and see if it runs properly. If it does I...
Forum: Engine / Drive Train 07-11-2014, 06:34 PM
Replies: 6
Views: 276
Posted By PureInboards
I was going to say check the timing (cam angle)...

I was going to say check the timing (cam angle) as this is a common problem when incorrectly set, you actually experience cross-firing i.e. as the advance increases the rotor is pointing halfway...
Forum: Engine / Drive Train 06-08-2014, 05:28 PM
Replies: 11
Views: 575
Posted By PureInboards
Yes reasonably common the baffle assembly inside...

Yes reasonably common the baffle assembly inside has come loose and is what rattles, in an extreme case they can block the exhaust enough to cause the water from the engine to back up and go down the...
Forum: Engine / Drive Train 05-29-2014, 04:26 AM
Replies: 5
Views: 217
Posted By PureInboards
Sounds to me you will get away with it just line...

Sounds to me you will get away with it just line up the paint marks and see if it starts and go from there.
Forum: Engine / Drive Train 05-28-2014, 11:06 PM
Replies: 4
Views: 210
Posted By PureInboards
You will have a dripless packing inside the boat...

You will have a dripless packing inside the boat that has a tiny hose going to it that feeds it water to keep it cool, this is where the water exits the packing gland
Forum: Engine / Drive Train 05-28-2014, 11:03 PM
Replies: 5
Views: 217
Posted By PureInboards
If you are pretty sure you haven't changed the...

If you are pretty sure you haven't changed the oil pump slot and the distributor has gone down in the same place align it using the paint marks on it and go try it. Just make sure you run it in the...
Forum: Engine / Drive Train 05-27-2014, 04:30 PM
Replies: 26
Views: 1,609
Posted By PureInboards
Are you sure its a 1285 and not a 1235 as the...

Are you sure its a 1285 and not a 1235 as the bore diameters are different, I take it it has splines in the hub but otherwise if it is a 1285 looks like you may have received a defect and need to...
Forum: Engine / Drive Train 05-26-2014, 04:09 PM
Replies: 26
Views: 1,609
Posted By PureInboards
What prop brand specs was on the boat originally...

What prop brand specs was on the boat originally as it sounds like the bore size is wrong
Forum: Engine / Drive Train 05-22-2014, 04:50 PM
Replies: 10
Views: 544
Posted By PureInboards
Just fab a deflector and mount it to the bolts...

Just fab a deflector and mount it to the bolts that hold the 2 pylon in place (see previous photo) as the water comes through the join between the hatch and the rear seat particularly around the...
Forum: Engine / Drive Train 05-21-2014, 04:59 PM
Replies: 7
Views: 366
Posted By PureInboards
Sorry to hear that you would be better to take it...

Sorry to hear that you would be better to take it out as the baffles can sometimes block the exit and the water coming from the engine will backup and hydraulic the engine in an extreme case. ...
Forum: Engine / Drive Train 05-19-2014, 01:38 AM
Replies: 7
Views: 366
Posted By PureInboards
Yes baffle broken inside talk to dealer and maybe...

Yes baffle broken inside talk to dealer and maybe able to get it replaced under warranty
Forum: Engine / Drive Train 05-16-2014, 04:00 PM
Replies: 10
Views: 544
Posted By PureInboards
later versions don't have them, should have the...

later versions don't have them, should have the manufacturing plate (serial, manufacturing date...) visible on the ECU or backing plate
Forum: Engine / Drive Train 05-14-2014, 04:28 PM
Replies: 3
Views: 308
Posted By PureInboards
Yours is fly-by-wire throttle so if you don't...

Yours is fly-by-wire throttle so if you don't have the diagnostic tool to run it in compression check mode you will need to unplug the fuel pump (under rear seat bin) and unplug the coil so you don't...
Forum: Engine / Drive Train 05-12-2014, 01:31 AM
Replies: 15
Views: 760
Posted By PureInboards
Are you talking about the pinion on the starter...

Are you talking about the pinion on the starter or the ring gear on the engine fly wheel?
Forum: Engine / Drive Train 05-11-2014, 09:27 PM
Replies: 15
Views: 760
Posted By PureInboards
Can you turn the ring gear with a flat blade...

Can you turn the ring gear with a flat blade screw driver when the starter is off
Forum: Engine / Drive Train 05-06-2014, 05:01 PM
Replies: 2
Views: 179
Posted By PureInboards
Feel around the output shaft that connects to the...

Feel around the output shaft that connects to the propshaft and see if there is oil around it where it comes out of the transmission. Usually (not always) when these leak it is because the shaft has...
Forum: Engine / Drive Train 04-28-2014, 01:40 AM
Replies: 10
Views: 510
Posted By PureInboards
I would also ask what engine as if it has alloy...

I would also ask what engine as if it has alloy in it I would defiantly add a cooling system if you plan on keeping it longterm as you need an inhibiter to prevent the electrolysis, thats one reason...
Forum: Engine / Drive Train 04-23-2014, 04:15 PM
Replies: 24
Views: 774
Posted By PureInboards
Check the balancer (thing that the pump and...

Check the balancer (thing that the pump and pulley is bolted to) as that will cause pump wobble if it is shot.
Forum: Engine / Drive Train 03-26-2014, 03:43 PM
Replies: 8
Views: 393
Posted By PureInboards
Does it have a heater?

Does it have a heater?
Forum: Engine / Drive Train 03-13-2014, 07:28 PM
Replies: 7
Views: 523
Posted By PureInboards
Sorry been a bit busy here but would suggest you...

Sorry been a bit busy here but would suggest you try looking through this manual and see how you go first http://perfectpass.com/sites/all/themes/perfectpass%20-%20Copy/images/20082009mastercraft.pdf...
Forum: Engine / Drive Train 03-11-2014, 03:20 PM
Replies: 7
Views: 523
Posted By PureInboards
Pretty sure that the 08 version was a cut down...

Pretty sure that the 08 version was a cut down variant of the PerfectPass code and MC got into a bit of trouble as the 09 one sucks in comparison. When you say it doesn't work what is happening or...
Forum: Engine / Drive Train 03-10-2014, 07:10 PM
Replies: 7
Views: 523
Posted By PureInboards
Rubbish if you need a part contact me and I will...

Rubbish if you need a part contact me and I will get it sorted for you as I am an Indmar dealer and MasterCraft service agent in NZ, if you have any problems PM me with serial for the cooling system...
Forum: Engine / Drive Train 03-10-2014, 03:05 PM
Replies: 7
Views: 523
Posted By PureInboards
The 08 closed cooling system is a bit special I...

The 08 closed cooling system is a bit special I would suggest you contact Indmar customer service and have the engine serial number available
Forum: Engine / Drive Train 01-14-2014, 05:28 PM
Replies: 1
Views: 310
Posted By PureInboards
LY6 engine the pulley and harmonic balancer are...

LY6 engine the pulley and harmonic balancer are one so you need Indmar p/n 551685 which retails for $275 USD (congrats that is the most expensive one they sell)
Forum: Engine / Drive Train 12-23-2013, 02:57 PM
Replies: 65
Views: 3,082
Posted By PureInboards
Typically for ECU's adv_deg = adv_offset +...

Typically for ECU's adv_deg = adv_offset + ign_table(rpm, kpa) + cold_adv_deg so have you checked what the ECU things the RPM, MAP and engine temp values are with a diacom diagnostic system?
Showing results 1 to 25 of 62

 

All times are GMT -4. The time now is 08:30 PM.