Forum: General Discussion
05-05-2013, 06:30 PM
|
|
Replies: 2
Views: 163
2001 X30 Table
I am looking for a table for my 01 X30. I researched but really did not have much luck and was looking for suggestions of what may work. Ebay sells RV and marine tables ect but I have no Idea what...
|
|
Forum: General Discussion
03-11-2013, 01:56 AM
|
|
Replies: 11
Views: 516
Prop Strut Alignment
Today I was putting in a new steering cable in my 01 X30 and when aligning the steering wheel I noticed the rudder was about 1" to the left of the center of the prop shaft when looking from the rear....
|
|
Forum: General Discussion
03-03-2013, 08:46 PM
|
|
Replies: 1
Views: 185
2001 X30 Platform, Hydroturf?
My X30 platform needs to be redone. The black rubber is starting to crack and peel and the black is coming off on everything, shorts, feet, towels, ect. So I know it is shot. I looked at Sea Dek, but...
|
|
Forum: For Sale: Parts & Accessories
03-02-2013, 10:32 PM
|
|
Replies: 1
Views: 349
Green Impeller
I have a gree Jabsco Ballast Puppy impeller that I ordered and ended up not needing. So I just want to sell it to someone who could use it. Make me an offer.
|
|
Forum: For Sale: Parts & Accessories
03-02-2013, 10:29 PM
|
|
Replies: 0
Views: 190
New Indmar WP
I have a brand new Indmar Water Pump. The plate says 685001-1 and I beleive it is for the Non LTR motor. I ordered a WP for my LTR and they sent me this. I never sent it back so it has been sitting...
|
|
Forum: General / Other
11-22-2012, 04:27 PM
|
|
Replies: 1
Views: 320
Ultraflex steering cable
I am needing a new steering cable for my 2001 x30 and ran across a company that is called Ultraflex. They sell one compatible to the Teleflex extreme in a 21 foot length which is what I need. Has...
|
|
Forum: Ballast
07-11-2012, 12:17 PM
|
|
Replies: 8
Views: 720
|
|
Forum: Ballast
07-10-2012, 10:15 PM
|
|
Replies: 8
Views: 720
|
|
Forum: Ballast
07-10-2012, 09:40 PM
|
|
Replies: 8
Views: 720
|
|
Forum: Ballast
07-09-2012, 04:49 PM
|
|
Replies: 8
Views: 720
As far as I know it is stock and I did notice...
As far as I know it is stock and I did notice all(several) yellow cartridge style bilge pumps right where you said they were. I honestly thought that is all they were, bilge pumps not meant for the...
|
|
Forum: Engine / Drive Train
06-30-2012, 08:50 PM
|
|
Replies: 4
Views: 212
The LTR one only has 3 holes. It is an indmar...
The LTR one only has 3 holes. It is an indmar pump and the part numbers match up. I got the pump from Charlotte ski boats so it is the right pump, just not sure why things don't line up. We tried...
|
|
Forum: Engine / Drive Train
06-30-2012, 08:04 PM
|
|
Replies: 4
Views: 212
2001 LTR water pump, UGHHH!!!
So I finally get my water pump delivered and have my mechanic pull the old one and he has a hell of a time getting the new one on. After about 15 min he lines up the holes in the flange of the new...
|
|
Forum: Trailers
06-30-2012, 02:05 AM
|
|
Replies: 2
Views: 364
2001 Trailer wheel bearing size, PT#
I want to replace the wheel bearings on my boat trailer but need to know the bearing size or part numbers before I start. I researched it but couldn't find what I needed. It is a tandem axle trailer...
|
|
Forum: Engine / Drive Train
06-28-2012, 07:52 PM
|
|
Replies: 1
Views: 218
Quick Tranny Fluid Question
I have a 2001 x30 with the 1:5 tranny and am getting ready to do the service on it. I was going to use Dex/Merc to do the change but then read that using 14w-40 oil was actually better. Any thoughts...
|
|
Forum: Ballast
06-26-2012, 09:19 PM
|
|
Replies: 8
Views: 720
2001 X30 Center Ballast pump location
I have a 2001 x30 and need to replace the impeller in the center ballast pump since it likes to fill up by itself. I am just curious if someone can tell me where it is located. I searched other posts...
|
|
Forum: General Discussion
06-16-2012, 02:26 PM
|
|
Replies: 2
Views: 336
Registration Numbers
I have a black and white 2001 X30 and have to get new registration numbers. I am going to get them from 3dlettering and need to decide between the chrome mastercraft style which I have on the rear of...
|
|
Forum: Engine / Drive Train
06-13-2012, 12:53 AM
|
|
Replies: 0
Views: 166
Recommended Fluids
Just wanted to do a quick post asking what oil and tranny fluid/vdrive fluid you would recommend for a 2001 X30 with the LTR motor. I have a guy who is going to come do my service at the house but I...
|
|
Forum: Trailers
06-07-2012, 11:03 PM
|
|
Replies: 26
Views: 2,145
|
|
Forum: Trailers
06-07-2012, 07:48 PM
|
|
Replies: 26
Views: 2,145
Pretty timely discussion. I just looked in my...
Pretty timely discussion. I just looked in my master cylinder after my actuator was sliding really slowly and sure enough, rusty color. Soooooo. New actuator or replace the fluid, bleed the brakes...
|
|
Forum: General Discussion
01-24-2012, 07:20 PM
|
|
Replies: 21
Views: 2,096
|
|
Forum: General Discussion
12-14-2011, 12:29 AM
|
|
Replies: 46
Views: 3,921
We paid 21k for our '01 x30 last April and it...
We paid 21k for our '01 x30 last April and it only had 220 hours. Did have some quirks, but I think we got a really good deal, especially considering the hours. If u really like it, I think 21 to 22k...
|
|
Forum: General Discussion
12-08-2011, 11:32 PM
|
|
Replies: 21
Views: 2,096
They are Jester's made by Ballistic. I need a...
They are Jester's made by Ballistic. I need a 17x9 for my suburban so they fit the tires I already have. I found them on ebay for $569 shipped to AZ. I called them today and they are back ordered...
|
|
Forum: General Discussion
12-08-2011, 10:03 PM
|
|
Replies: 21
Views: 2,096
|
|
Forum: General Discussion
12-07-2011, 11:16 PM
|
|
Replies: 21
Views: 2,096
|
|
Forum: General Discussion
12-07-2011, 12:40 PM
|
|
Replies: 21
Views: 2,096
New Wheels for the tow rig?
I am wanting to get some new wheels for my 2000 3/4 ton suburban and have these in mind.
73434
The only thing is I dont see many Charcoal suburbans with black wheels. Just wondering if any of you...
|
