TeamTalk

TeamTalk (http://www.mastercraft.com/teamtalk/index.php)
-   Engine / Drive Train (http://www.mastercraft.com/teamtalk/forumdisplay.php?f=24)
-   -   Throttle and trans cable setting (http://www.mastercraft.com/teamtalk/showthread.php?t=56183)

MI_Corey 07-22-2013 04:50 PM

Throttle and trans cable setting
 
How do I set the throttle and trans cable? I understand how to move them in/out (tighter/looser) but is there a way to set how tight they are without being out on the water? I often have to jiggle to throttle a lot to get the boat to find neutral to start and when pulling if I'm at a set speed and want to back off, the throttle will move back about 1/4" before engaging the cable to slow down.

etduc 07-22-2013 05:35 PM

You can adjust the throttle cable, at the carb. It's trial and error. You do need, just a bit of play. You can get close on the trailer. Slight adjustment, maybe necessary on the water. Takes about 1 minute. If you have the original cable, maybe time for replacement.

MI_Corey 07-22-2013 06:00 PM

Quote:

Originally Posted by etduc (Post 959460)
You can adjust the throttle cable, at the carb. It's trial and error. You do need, just a bit of play. You can get close on the trailer. Slight adjustment, maybe necessary on the water. Takes about 1 minute. If you have the original cable, maybe time for replacement.

Same with shift cable?

JayBrown 07-23-2013 08:55 PM

Dont want to be a thread theif but Im having almost the same problem. Adjust one way and it shifts smooth into forward but then 2500RPM until rev kicks in. Adjust it to middel and same for forward and rev and adjust back no forward?


All times are GMT -4. The time now is 06:59 AM.