TeamTalk

TeamTalk (http://www.mastercraft.com/teamtalk/index.php)
-   General Discussion (http://www.mastercraft.com/teamtalk/forumdisplay.php?f=6)
-   -   Sunstream float lift release problem (http://www.mastercraft.com/teamtalk/showthread.php?t=52248)

nanneyman 01-03-2013 11:36 PM

Sunstream float lift release problem
 
One side of my lift releases a few seconds before the other side causing the boat to come down at an angle. I've had the pressure checked coming out of the manifold and it is fine. When there is not a boat on the lift it works fine it just happens when there is weight on it.
This problem started when i had to replace a stripped fitting and had the threads retapped. The new fitting is a little bigger, but has the same size opening in it. I also had to remove the manifold from the motor and reattach it.
Any suggestions on how to fix are appreciated!

jeffbare 01-05-2013 12:24 PM

Did you bleed the lines when you put it back together?

jeffbare 01-05-2013 12:27 PM

Did you bleed the lines when you put it back together?

nanneyman 01-05-2013 10:13 PM

No, I thought any air in the lines wood bleed out through the reservoir? How do I bleed them.
.


All times are GMT -4. The time now is 07:27 AM.