TeamTalk

TeamTalk (http://www.mastercraft.com/teamtalk/index.php)
-   General Discussion (http://www.mastercraft.com/teamtalk/forumdisplay.php?f=6)
-   -   Zero Flex Flyer Speaker Help? (http://www.mastercraft.com/teamtalk/showthread.php?t=35544)

upnthebid 05-24-2010 01:09 PM

Zero Flex Flyer Speaker Help?
 
I have a zero flex flyer tower and need to update the speakers. Any Suggestions on great sounding speakers that will fit in the original Flyer cans?

upnthebid 05-24-2010 01:12 PM

1 Attachment(s)
Here is a picture of the Factory Speaker/Can

nmcjr 05-24-2010 01:45 PM

Bullet makes some 6.5's that I am pretty sure will fit in those cans. I thought about going that route, but ended up just getting the full speaker and can setup so I could upgrade to the 7.7" speakers, which wasn't a whole lot more expensive. You will need a lot of power to go to any of the HLCD setups, but its worth it.

JPK 05-24-2010 02:09 PM

1 Attachment(s)
I have the exact same cans on my zero flex tower. I replaced mine with 6 3/4" Polk 6051UM. I had to drill and tap out the cans. If you look at the Clarion speakers just outside of the mounting screws there are additional holes. These are where the holes for the Polks line up but the factory cans don't have holes there.

I used a #29 bit with an 8/32 tap (you can use the stock screws) but I replaced mine with stainless allen heads to match the rest of the boat.

Also I had to get creative to mount the tweeters but it was fairly simple. I cut off the back of the mounting (cup) bezels (supplied with the Polk tweeters) and then glued the tweeters to the mounting bezels, then I glued the bezels with tweeters in place. They look and sound great. I found the speakers online for $165/set. I also had the cans powder coated to match.

No pictures but I can get some next time I'm out.

upnthebid 05-24-2010 05:38 PM

how do the polks sound? I use them for my surround sound in the house.

upnthebid 05-24-2010 06:43 PM

Don't these require an independent crossover? If so, where did you locate the crossover and did you do any additional wiring?

TayMC197 05-24-2010 06:58 PM

3 Attachment(s)
I have 6x9's on my mini zero flex... They came off a malibu but work great..

upnthebid 05-24-2010 08:00 PM

bump for nice set up. any major modifications on the install?

TayMC197 05-25-2010 08:05 AM

Not really, I had to make a 1/4 inch spacer to fit between the speakers and tower so that the can faces didn't hit. Wasn't to hard at all. other than that, I through bolted and ran the wires.. not to complicated.


All times are GMT -4. The time now is 02:38 PM.