TeamTalk

TeamTalk (http://www.mastercraft.com/teamtalk/index.php)
-   Engine / Drive Train (http://www.mastercraft.com/teamtalk/forumdisplay.php?f=24)
-   -   How to cut the wire reinforced Water Hose? (http://www.mastercraft.com/teamtalk/showthread.php?t=2380)

VTJC 04-12-2005 12:26 PM

How to cut the wire reinforced Water Hose?
 
I am preparing to install this new Y-Fitting to improve my heat at low engine speeds.

I am curious how people recommend to cut the wire reinforced Water Hose. Hacksaw?

Ice is out on the lake, I hope to get out this weekend!

Thanks in advance for your advice.

Jamie

AirJunky 04-12-2005 12:55 PM

Quote:

Originally Posted by VTJC
I am curious how people recommend to cut the wire reinforced Water Hose. Hacksaw?

I did this about 4 or 5 years ago & think you'll be very happy with how it works.... heat at idle speeds. As I recall, I cut the hose with a knife & the reinforce wiring inside with dikes. I did have to pull the hose out of the bilge to work on it though.

Diesel 04-12-2005 03:47 PM

Chop saw works great. Just be sure to clean out the inside of the hose.

east tx skier 04-12-2005 04:06 PM

Pocket knife or pruning shears works great.


All times are GMT -4. The time now is 10:13 AM.


2018