Go Back   TeamTalk > View Profile

venetrex venetrex is offline

TT Enthusiast

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. Wkndtoy
    09-15-2017 12:02 PM
    Wkndtoy
    Hey it’s not worth posting this in the thread… due to several of the other members on the board. I have converted my Gen 1 system over to a gen 2 style. With great success.

    Check out these posts.
    http://www.boatingworld.com/diy/how-...-on-your-boat/

    http://www.wakegarage.com/projects-a...alibu-247-r95/


    If you don’t have gen 1 tabs “the Wake Logic controller” would be great to use to control the lenco rams.

    http://www.wakegarage.com/projects-a...-2007-lsv-r93/


    The size of the tab is important for the size and shape of the wave you want. For our x-55 it is huge and we run a lot of weight too 5000lbs of ballast (under floor and bags).

    The really important part of the tab install is the operating angle, you need 10-12 degrees of down angle on the tab. My tab size is 17x20 for our X-55 which is on par with the Gen 2 and the Go surf tab size and also very similar in size to the centurion surf tab system. it's really not that hard soon as to get past the part about drilling holes!!!
  2. DeepBlue
    07-26-2015 02:03 PM
    DeepBlue
    Hello! Thanks for the comments on recalibrating the ballast tank gauges. I managed to adjust the gauges on the rear tanks. I think I found a small hatch cover on the port side of the boat which I assume has the gauge for the KGB tank under it. Any tricks to get the hatch cover off - it seem stuck. 2007 X2. Thanks!
  3. venetrex
    04-02-2011 06:38 AM
    venetrex
    The mount is the problem
  4. fireman38539
    04-01-2011 08:02 PM
    fireman38539
    do you have the table yet?
  5. Jim@BAWS
    08-23-2010 01:28 PM
    Jim@BAWS
    I have NEVER heard of a COCKPIT table for an X7/197. I have never seen it as an option either Jim@BAWS
  6. venetrex
    01-14-2010 02:52 PM
    venetrex
    Can I get them from you somehow?
  7. airbornjim
    01-14-2010 10:11 AM
    airbornjim
    Yes, I have pre vdig instructions. That was part of my problem. I needed the vdig set

About Me

  • About venetrex
    City
    Sandy Hook
    State
    Connecticut
    Location
    Northeast
    Gender
    Male
    Boat Owned
    X2

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: 10-07-2017 10:00 AM
  • Join Date: 11-02-2009
  • Referrals: 0

Friends

Showing Friends 1 to 1 of 1

All times are GMT -4. The time now is 12:32 PM.