Go Back   TeamTalk > View Profile

thatsmrmastercraft thatsmrmastercraft is offline

MC Master Poster

Visitor Messages

Showing Visitor Messages 41 to 49 of 49
  1. americanskierJim
    07-27-2011 07:11 PM
    Just passin by Peter to say HI. Hope you are having a great Summer. I have been having a wonderful summer with the boys skiing and tubing. I have been up a couple times on the ski. Keep inouch. Jim
  2. oxberger
    06-10-2011 06:02 PM
    I'm trying to start a thread and can't seem to figure it out. I don't have a new thread button anywhere and it shows I have the permision to start one. Any clue on how I can do it?
  3. Skir68
    05-11-2011 10:05 AM
    Good Morning! I see you are a M/C owner and are on Team Talk alot
    My wife and I just purchased a prostar 190 and Live in Buffalo
    We would like to get to know other M/C owners in the area
    Where does everyone ski?
  4. americanskierJim
    02-16-2011 11:55 PM
    Hi Peter, Just thought I would pass by and say HI. Hope your having a great start to the new year.
  5. LaRue
    01-30-2011 12:06 AM
    Thought u might know the answer to a question. What boats have the same hull design as a 2000 maristar, if any, other than the X10? Thanks in advance.
  6. Slinkyredfoot
    01-18-2011 06:28 PM
    How ya doing? My name is Steve, live in Carmel Indiana and very long time MasterCraft owner Enjoy your input here and typically read your responses and threads, you seem to be in tune. Did not want to thread jack the fuel injection thread so I thought I would email you for some input.
    I am pretty well versed and mechanically inclined much like you, but the problem I referred to with my engine stalling after use is mind boggling to me. I have done everything, new coil, plug wires, converted to pointless ignition, new fuel filter with water separator, you name it I have done it. The stalling problem started two summers ago and I am at wits end. Like I said, have a good friend who I trust totally, he still says it is ethanol fuel I buy at the gas station which kinda makes sense. Almost like vapor lock or something. Just trying to get thoughts. I think my old oringinal carb may need some attention, but it starts so good and runs so fine I hate to screw around with things. Any other thoughts your may have to address my stalling problem? Thanks and good to meet you.
  7. bmack1479
    10-21-2010 08:17 PM
    did you get a chance to post pics of s&s with outboard thanks butch
  8. broncotw
    10-30-2009 09:21 PM
    I own a 1985 MasterCraft Prostar Stars and Stripes with a 351 Windsor....

    The last four (4) times I have taken the boat out it runs GREAT and STRONG for approximately two (2) hours and then all of a sudden it begins to bog down as if it's starving for fuel. It becomes very hard to start if it starts at all. The last time I took it out it would start and then every time I put the boat in gear it would stall....

    After the first time this happened I changed the in-line fuel filter and it contained approximately two (2) inches of black particles almost resembling coffee grounds. I sunsequently changed the entire fuel filter assembly. I soon thereafter took the boat out again and the SAME problem happened again.

    Next, since changing the entire fuel filter assembly, I have also changed the following: entire fuel line, fuel pump, carberator, spark plungs, spark plug wires, PVC value, distributor cap and rotor, and ignition system (replacing the old point system with an electronic PCM kit). In my mind, I thought I have addressed all of the potential items that possible could be causing this problem.

    To my surprise, I took the boat out this past weekend, and the same EXACT thing happened again! Boat ran GREAT and STRONG for 2 hours and then began missing and then stalling and it was hard to start. Again, as in before, if the boat started once it was put into geat it stalled.....

    I hae NO idea what else to look at here......

    My only thought is maybe there is some sludge in the fuel tank that is gathering at the pick up point inside of the fuel tank thus preventing the fuel from being sent to through the system -- and this seems to happen at approximately 2 hours into running the boat which equates to 1/2 of the fuel being expended from the tank..... I have no idea if there is a screen or mesh covering over the fuel pickup inside of the fuel tank....

    I am at a total loss here....

    I would love to hear some ideas and thoughts from some of the members here as to what this could possible be....


    (210) 393-1228
  9. mad-dog1
    02-04-2009 06:39 PM
    Hey Mr mc I'm gonna be following your thread on the metal flake stripe, My 86 had the wave decals on it and I've remove them since I really want to put the stripe on it, I guess the original stripe was done with in the gel coat but I can't see myself redoing all of it since the original gel coat is in good shape, so I'll be looking at you progress as you do the decal stripe...thank's

About Me

  • About thatsmrmastercraft
    St. Paul
    St. Paul, MN
    Team MasterCraft Member
    Boat Owned
    1977 Stars & Stripes
    Trailer Accessories
  • Signature

    FOR 302, 351 & 454 STARTING AT $449 DELIVERED
    Email - [email protected]


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 12:49 AM
  • Join Date: 09-20-2008
  • Referrals: 0


Showing Friends 1 to 10 of 57

All times are GMT -4. The time now is 09:59 AM.