Hope you don't mind me asking, but I ran across a thread you were involved with a few years back regarding your fuel gage, etc. I've got an '03 210VRS so I'm sure our boats are very similar. Anyway, on to my question.... I've got a bad fuel gage and have a replacement in hand. I don't suppose you remember what all was involved in getting to it to swap it out do you? Like I said, I know it's been a long time. I looked under it and there appears to just be one large hole where all the wires go through, so I couldn't figure out (but assumed) the entire dash panel must pull out in order to access the gage and remove it / replace it? I was hoping you could remember and give me some pointers.... I posted a new thread on here several days ago, but have had no replies so I thought I'd give you a try for help.. Thanks!