View Full Version : 2010 XStar $64,999

01-02-2014, 05:49 PM
2010 MasterCraft XStar - Price Lowered to $57,999
THIS BOAT IS AT Midwest MasterCraft. Please Call 763-533-9666 for more information.

This boat is a wakeboarding LEGEND! The official tow boat of the wakeboard camp, this XStar has pulled pro riders, local tournaments and students at the best boarding school on the planet. Fully cumstomized with SURF TABS and the PWT Ballast Kit this boat surfs, boards and does everything in between. This 2010 XStar has 290 hours on the engine and 1192 on the boat. The engine was upgraded to an ILMOR 6.0 Liter due to failure in the old engine, tons of new parts make this the best value on the water.

Upgrades on this boat include
6.0 Liter ILMOR Engine - 290 Hours (engine replaced at 906 hours) Currently 1192 on boat
Cockpit and Bow Cover - Black
Tower Mirror Bracket with Mirror
Tower Camera
Swivel Board Racks
Stereo System
Tower Speakers With Lights - 4
Zero Off GPS Speed Control
Sirius Stellite Radio Kit
Transom Stereo Remote
XStar Pylon
Fiberglass Swim Platform
Heated Observers Seat
Walk Through Seat
Bow Filler Cushion
Bow Ladder
Depth Finder
Dual Batteries
Surf Tabs - Custom Install
PWT Ballast Kit
Tandem Axle Trailer

Boat Specs:
Length: 22'3"
Beam: 100"
Weight: 4650 lbs
Fuel Capacity: 83 gallons
Capacity: 12 people

01-02-2014, 07:31 PM
The tower rack its a nice feature there.

01-02-2014, 10:07 PM
Sweet boat. Interesting that Shaun Murray would autograph a MasterCraft.

01-03-2014, 03:27 PM
The owner of this boat had it at one of the Pro Tour Stops and as it was the Boarding School XStar quite a few pro riders stopped by to say hi to the new owner. A couple of non-MC riders signed it, hard to say no to a wakeboard enthusiast!

01-03-2014, 03:52 PM
God I love flake

01-03-2014, 04:15 PM
Shaun used to be associated with the boarding school.

interesting the engine was replaced - was the original a big block?

also, a indmar to ilmor conversion wiring harness exists then?

01-03-2014, 04:36 PM
Long story on the engine swap but yes it is possible. Basically someone (not us) diagnosed this as a blown engine, we ordered a new block from ILMOR but upon inspection found it was a broken drive play which had caused the started to get stuck engaged. The boat owners expectations were a new engine and so we replaced the block, etc. rather than just repairing the drive plate/starter issue.

The new block didn't come with a wire harness but we were able to use the existing harness/ecm in the boat, aside from a couple of sensors it was pretty close to plug and play. Software calibrations were updated, new drive plate, new starter, new plug wires, etc.

01-03-2014, 04:46 PM
Hey look at that - "Gen 1" surf tabs retro on a 2010 Xstar. Maybe whoever did this should go work for MasterCraft Engineering- I crack myself up.:D:D:D

10-02-2014, 11:27 AM
bump because price has been lowered. For some reason I can't figure out how to edit the post header.

10-02-2014, 11:41 AM
Just saw this, beautiful boat. To bad y'all won't swap for an 05 with less than half the hours ;)

10-02-2014, 01:49 PM
bump because price has been lowered. For some reason I can't figure out how to edit the post header.

Yikes, original post was nearly nine months ago. Summer is gone already.

10-02-2014, 03:09 PM
bump because price has been lowered. For some reason I can't figure out how to edit the post header.


Can you please go back and run the parts department too? We miss you!:cool:

10-03-2014, 01:12 PM
06MCX15, let me know when you need anything. I'll take care of it!